scholarly journals Transmission Electron Microscopy (TEM) Observations of Female Oocytes FromNilaparvata lugens(Hemiptera: Delphacidae): Antibiotic Jinggangmycin (JGM)-Induced Stimulation of Reproduction and Associated Changes in Hormone Levels

2016 ◽  
Vol 109 (4) ◽  
pp. 1677-1682 ◽  
Author(s):  
Bing Xu ◽  
Lin-Lin You ◽  
You Wu ◽  
Jun Ding ◽  
Lin-Quan Ge ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Hormone Levels ◽  
Transmission Electron ◽  
Stimulation Of

scholarly journals Immuno-toxicological Evaluation of the Adjuvant Formulations for Experimental Anti-meningococcal Vaccines without Aluminium Hydroxide

2019 ◽  
Vol 70 (4) ◽  
pp. 1251-1257
Author(s):  
Beatriz Tamargo Santos ◽  
Simona Bungau ◽  
Catherine Fleitas Perez ◽  
Yanet Marquez Napoles ◽  
Juan F. Infante Bourzac ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Relative Weight ◽  
Intranasal Route ◽  
Toxicological Evaluation ◽  
Toxicological Effects ◽  
Transmission Electron ◽  
Pathologic Anatomy ◽  
Standard Range ◽  
Stimulation Of

The proteoliposomes and cochleates are used as adjuvants for vaccines since they are potent immune stimulators. However, the hyper stimulation of the immune system provoked by adjuvants can cause immune-toxicological side effects. The present study was carried out to evaluate the toxic and immuno-toxicological effects of new adjuvants for anti-meningococci vaccines based on neo-proteoliposomes (nPL) and neo-cochleates (nCh), in Balb/c mice that were administered doses of 15 �g each, over periods of 14 days through intramuscular route and three inoculations with the same doses through intranasal route, every 7 days. The Scanning and Transmission Electron Microscopy showed that the nPL and nCh had nanometric dimensions and their normal peculiar forms. The experimental formulations did not provoke general toxic effects in the tested animals, which tended to the progressive normal growing of this species, that did not statistically differ from the control ones. The studies of pathologic anatomy in inoculation organs and sites did not reveal modifications that can indicate toxicity and there was no sign of hepatic damage. The structural observations found in the spleen and lymphatic nodes showed the physiological development of the immune response, which was normal in all cases showing the restitution of the stimulation signs. The relative weight values of the spleen were within the standard range. These results showed that the nPL and nCh elaborated as adjuvants for vaccines did not show any evident induction of general toxic or particular immune-toxicologicl effects.

Techniques for Transmission Electron Microscopy of Fiber-Matrix Interfaces in Aluminum Alloy-Boron Composites by Ion Erosio

1971 ◽  
Vol 29 ◽  
pp. 204-205
Author(s):  
G. G. Shaw
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Aluminum Alloy ◽  
Electron Beam ◽  
Pure Aluminum ◽  
Ion Milling ◽  
Transmission Electron ◽  
Fiber Matrix ◽  
Ion Erosion ◽  
Row Of Fibers

The morphology and composition of the fiber-matrix interface can best be studied by transmission electron microscopy and electron diffraction. For some composites satisfactory samples can be prepared by electropolishing. For others such as aluminum alloy-boron composites ion erosion is necessary.When one wishes to examine a specimen with the electron beam perpendicular to the fiber, preparation is as follows: A 1/8 in. disk is cut from the sample with a cylindrical tool by spark machining. Thin slices, 5 mils thick, containing one row of fibers, are then, spark-machined from the disk. After spark machining, the slice is carefully polished with diamond paste until the row of fibers is exposed on each side, as shown in Figure 1.In the case where examination is desired with the electron beam parallel to the fiber, preparation is as follows: Experimental composites are usually 50 mils or less in thickness so an auxiliary holder is necessary during ion milling and for easy transfer to the electron microscope. This holder is pure aluminum sheet, 3 mils thick.

Direct Observation of Heat Exchanger Deposits by Cross Sectioning

1967 ◽  
Vol 25 ◽  
pp. 364-365
Author(s):  
R. W. Anderson ◽  
D. L. Senecal
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Heat Exchanger ◽  
Direct Observation ◽  
Cross Sections ◽  
Preparation Method ◽  
Specimen Preparation ◽  
Flowing Water ◽  
Transmission Electron ◽  
Deposit Layer

A problem was presented to observe the packing densities of deposits of sub-micron corrosion product particles. The deposits were 5-100 mils thick and had formed on the inside surfaces of 3/8 inch diameter Zircaloy-2 heat exchanger tubes. The particles were iron oxides deposited from flowing water and consequently were only weakly bonded. Particular care was required during handling to preserve the original formations of the deposits. The specimen preparation method described below allowed direct observation of cross sections of the deposit layers by transmission electron microscopy.The specimens were short sections of the tubes (about 3 inches long) that were carefully cut from the systems. The insides of the tube sections were first coated with a thin layer of a fluid epoxy resin by dipping. This coating served to impregnate the deposit layer as well as to protect the layer if subsequent handling were required.

Phase Transformations in Ti-7w/oMo-3w/oMe Alloy

1974 ◽  
Vol 32 ◽  
pp. 514-515
Author(s):  
S. Fujishiro
Keyword(s):  
Electron Microscopy ◽  
Mechanical Properties ◽  
Transmission Electron Microscopy ◽  
Tensile Strength ◽  
Mechanical Processing ◽  
Ray Method ◽  
X Ray ◽  
Transmission Electron ◽  
Water Quench ◽  
Alpha Beta

The mechanical properties of three titanium alloys (Ti-7Mo-3Al, Ti-7Mo- 3Cu and Ti-7Mo-3Ta) were evaluated as function of: 1) Solutionizing in the beta field and aging, 2) Thermal Mechanical Processing in the beta field and aging, 3) Solutionizing in the alpha + beta field and aging. The samples were isothermally aged in the temperature range 300° to 700*C for 4 to 24 hours, followed by a water quench. Transmission electron microscopy and X-ray method were used to identify the phase formed. All three alloys solutionized at 1050°C (beta field) transformed to martensitic alpha (alpha prime) upon being water quenched. Despite this heavily strained alpha prime, which is characterized by microtwins the tensile strength of the as-quenched alloys is relatively low and the elongation is as high as 30%.

Two- or three-way observations of the identical cell elements within the same sections by LM, TEM and/or SEM

1978 ◽  
Vol 36 (2) ◽  
pp. 82-83 ◽  
Author(s):  
Nakazo Watari ◽  
Yasuaki Hotta ◽  
Yoshio Mabuchi
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Fine Structure ◽  
Light Microscopy ◽  
Thin Sections ◽  
Transmission Electron ◽  
Identical Cell ◽  
Electron Microscopes ◽  
Scanning Electron

It is very useful if we can observe the identical cell elements within the same sections by light microscopy (LM), transmission electron microscopy (TEM) and/or scanning electron microscopy (SEM) sequentially, because, the cell fine structure can not be indicated by LM, while the color is; on the other hand, the cell fine structure can be very easily observed by EM, although its color properties may not. However, there is one problem in that LM requires thick sections of over 1 μm, while EM needs very thin sections of under 100 nm. Recently, we have developed a new method to observe the same cell elements within the same plastic sections using both light and transmission (conventional or high-voltage) electron microscopes.In this paper, we have developed two new observation methods for the identical cell elements within the same sections, both plastic-embedded and paraffin-embedded, using light microscopy, transmission electron microscopy and/or scanning electron microscopy (Fig. 1).

Comparative Microstructures of Ion Milled and Electrochemically Thinned Composite Materials

1974 ◽  
Vol 32 ◽  
pp. 546-547
Author(s):  
R.R. Russell
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Composite Materials ◽  
Great Difficulty ◽  
Ion Milling ◽  
Transmission Electron ◽  
Ion Damage ◽  
Intermetallic Composite

Transmission electron microscopy of metallic/intermetallic composite materials is most challenging since the microscopist typically has great difficulty preparing specimens with uniform electron thin areas in adjacent phases. The application of ion milling for thinning foils from such materials has been quite effective. Although composite specimens prepared by ion milling have yielded much microstructural information, this technique has some inherent drawbacks such as the possible generation of ion damage near sample surfaces.

Maytansine-Induced Mitotic Arrest in Human Lymphoblasts

1977 ◽  
Vol 35 ◽  
pp. 460-461
Author(s):  
Tai-Te Chao ◽  
John Sullivan ◽  
Awtar Krishan
Keyword(s):  
Electron Microscopy ◽  
Cell Cycle ◽  
Transmission Electron Microscopy ◽  
Tubulin Polymerization ◽  
Vinca Alkaloids ◽  
Antimitotic Activity ◽  
Transmission Electron ◽  
Flow Microfluorometry ◽  
Brain Tubulin

Maytansine, a novel ansa macrolide (1), has potent anti-tumor and antimitotic activity (2, 3). It blocks cell cycle traverse in mitosis with resultant accumulation of metaphase cells (4). Inhibition of brain tubulin polymerization in vitro by maytansine has also been reported (3). The C-mitotic effect of this drug is similar to that of the well known Vinca- alkaloids, vinblastine and vincristine. This study was carried out to examine the effects of maytansine on the cell cycle traverse and the fine struc- I ture of human lymphoblasts.Log-phase cultures of CCRF-CEM human lymphoblasts were exposed to maytansine concentrations from 10-6 M to 10-10 M for 18 hrs. Aliquots of cells were removed for cell cycle analysis by flow microfluorometry (FMF) (5) and also processed for transmission electron microscopy (TEM). FMF analysis of cells treated with 10-8 M maytansine showed a reduction in the number of G1 cells and a corresponding build-up of cells with G2/M DNA content.

Tumor Diagnosis

1982 ◽  
Vol 40 ◽  
pp. 262-265
Author(s):  
Bruce Mackay
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Differential Diagnosis ◽  
Light Microscopy ◽  
Clinical Examination ◽  
Ultrastructural Study ◽  
Diagnostic Procedures ◽  
Specific Diagnosis ◽  
Transmission Electron ◽  
Microscopic Diagnosis

The broadest application of transmission electron microscopy (EM) in diagnostic medicine is the identification of tumors that cannot be classified by routine light microscopy. EM is useful in the evaluation of approximately 10% of human neoplasms, but the extent of its contribution varies considerably. It may provide a specific diagnosis that can not be reached by other means, but in contrast, the information obtained from ultrastructural study of some 10% of tumors does not significantly add to that available from light microscopy. Most cases fall somewhere between these two extremes: EM may correct a light microscopic diagnosis, or serve to narrow a differential diagnosis by excluding some of the possibilities considered by light microscopy. It is particularly important to correlate the EM findings with data from light microscopy, clinical examination, and other diagnostic procedures.

High-Voltage Scanning Electron Microscopy

1970 ◽  
Vol 28 ◽  
pp. 6-7
Author(s):  
J. M. Cowley
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Scanning Transmission Electron Microscopy ◽  
Wave Optics ◽  
Contrast Effects ◽  
Transmission Electron ◽  
Mode Of Operation ◽  
Scanning Transmission ◽  
Types Of Information ◽  
Voltage Scanning

The comparison of scanning transmission electron microscopy (STEM) with conventional transmission electron microscopy (CTEM) can best be made by means of the Reciprocity Theorem of wave optics. In Fig. 1 the intensity measured at a point A’ in the CTEM image due to emission from a point B’ in the electron source is equated to the intensity at a point of the detector, B, due to emission from a point A In the source In the STEM. On this basis it can be demonstrated that contrast effects In the two types of instrument will be similar. The reciprocity relationship can be carried further to include the Instrument design and experimental procedures required to obtain particular types of information. For any. mode of operation providing particular information with one type of microscope, the analagous type of operation giving the same information can be postulated for the other type of microscope. Then the choice between the two types of instrument depends on the practical convenience for obtaining the required Information.

Sign in / Sign up

Export Citation Format

Share Document