Influence of size of achenes sown and depth of sowing on growth and yield of dryland oilseed sunflowers (Helianthus annuus) on the Darling Downs

1977 ◽  
Vol 17 (86) ◽  
pp. 489 ◽  
Author(s):  
BJ Radford
Keyword(s):  
Helianthus Annuus ◽  
Plant Density ◽  
Germination Percentage ◽  
Growth And Yield ◽  
Hypocotyl Length ◽  
Plant Populations ◽  
Delayed Emergence ◽  
Development Processes ◽  
Mean Size ◽  
Emergence Percentage

Large achenes of sunflower (Helianthus annuus) exhibited a slightly higher germination percentage and greater mean hypocotyl length than small achenes, resulting in a higher field emergence percentage at sowing depths exceeding 6 cm. Size of achenes sown had no effect on achene yield, provided plant populations from large and small achenes were equal. Plants grown from small achenes produced achenes of higher kernel percentage in both seasons, resulting in higher protein percentage in one season and higher oil percentage in the other. Performance of ungraded achenes was equal to that of graded achenes of the same mean size. Deep sowing reduced emergence percentage considerably, especially when small achenes were sown, but the effect of deep sowing on growth and yield was confounded with effects of reduced plant density (because of reduced emergence) and effects of delayed emergence causing slightly later timing of growth and development processes in relation to environmental factors.

Effects of high plant populations on the growth and yield of winter oilseed rape (Brassica napus)

1999 ◽  
Vol 132 (2) ◽  
pp. 173-180 ◽  
Author(s):  
J. E. LEACH ◽  
H. J. STEVENSON ◽  
A. J. RAINBOW ◽  
L. A. MULLEN
Keyword(s):  
Brassica Napus ◽  
Oilseed Rape ◽  
Plant Density ◽  
High Density ◽  
Growth And Yield ◽  
Winter Oilseed Rape ◽  
Plant Populations ◽  
Rothamsted Experimental Station ◽  
Plant Densities ◽  
Very High

The effects of plant density on the growth and yield of winter oilseed rape (Brassica napus) were examined in a series of five multifactorial experiments at Rothamsted Experimental Station between 1984 and 1989. Plant densities, manipulated by changing the seed rate and row spacing, or because of overwinter losses, ranged from 13·5 to 372 plants/m2. Normalized yields for the multifactorial plots increased with densities up to 50–60 plants/m2. In very high density plots in 1987/88, yield decreased as density increased >150 plants/m2. Plants grown at high density had fewer pod-bearing branches per plant but produced more branches/m2. Branch dry matter (DM) per plant was decreased by 42%, the number of fertile pods per plant and pod DM/plant by 37%. There was no effect of density on the number or DM of pods/m2. Over 74% of the fertile pods were carried on the terminal and uppermost branches of plants grown at high density in 1987/88 compared with only 34% in plants grown at low density in 1988/89. Seed DM/plant decreased with increase in density but seed size (1000-seed weight) increased. There was no effect of density on seed glucosinolate or oil contents.

scholarly journals Germination and Emergence of Parsley in Response to Osmotic or Matric Seed Priming and Treatment with Gibberellin

HortScience ◽  
2000 ◽  
Vol 35 (5) ◽  
pp. 907-909 ◽  
Author(s):  
Wallace G. Pill ◽  
Elizabeth A. Kilian
Keyword(s):  
Polyethylene Glycol ◽  
Gibberellic Acid ◽  
Seedling Emergence ◽  
Dry Weight ◽  
Seed Priming ◽  
Germination Percentage ◽  
Petroselinum Crispum ◽  
Hypocotyl Length ◽  
Shoot Dry Weight ◽  
Emergence Percentage

`Moss Curled' seeds of parsley (Petroselinum crispum L.) were primed osmotically in polyethylene glycol or matrically in fine, exfoliated vermiculite at –0.5 MPa for 4 or 7 days at 20 or 30 °C with 0 or 1 mm GA3. All priming treatments stimulated and hastened germination. Matric priming resulted in greater germination (89%) than osmotic priming (83%) when seeds were primed for 7 days at 30 °C, but priming agent had no effect on germination percentage following priming at 20 °C or for 4 days. In seeds primed for 4 days at 20 or 30 °C, matric priming hastened germination more than did osmotic priming. Germination was generally less synchronous with matric than with osmotic priming. Increasing priming time from 4 to 7 days increased the rate of germination, but increased germination synchrony only when seeds were primed at 20 °C. Inclusion of 1 mm GA3 during priming had little or no effect on germination. All matric priming treatments (other than 4-day priming) were repeated to assess seedling emergence in a greenhouse (25°C day/22 °C night). Priming increased the percentage, rate and synchrony of emergence, and increased hypocotyl length at 3 weeks after planting. Priming at 30 °C with 1 mm GA3 resulted in the greatest emergence percentage, hypocotyl length, and shoot dry weight. We conclude that matric priming is a satisfactory alternative to osmotic priming of parsley seeds. Chemical name used: gibberellic acid (GA3).

Growth and Yield of Irrigated Sesame II. Effects of Population and Variety on Reproductive Growth and Seed Yield

1974 ◽  
Vol 10 (1) ◽  
pp. 71-76
Author(s):  
A. H. El Nadi ◽  
M. H. Lazim
Keyword(s):  
Soil Moisture ◽  
Seed Yield ◽  
Seed Weight ◽  
Plant Density ◽  
Growth And Yield ◽  
Reproductive Growth ◽  
Plant Populations ◽  
Plant Seeds ◽  
Irrigation Interval

SUMMARYFour local sesame varieties were tested at three plant populations. Increase in plant density increased seed yield, which was positively related to number of pods per plant, seeds per pod, 1000-seed weight, heights of main stems and numbers of nodes per plant. Changes in soil moisture did not affect relative turgidity, whereas stomatal openness decreased as the irrigation interval became longer.

scholarly journals OKRA IN-ROW SPACING ALTERS PLANT GROWTH AND YIELD IN SOUTHERN FLORIDA

HortScience ◽  
2006 ◽  
Vol 41 (3) ◽  
pp. 507E-508
Author(s):  
Teresa Olczyk ◽  
Kent Cushman ◽  
Waldemar Klassen
Keyword(s):  
Plant Density ◽  
Calcareous Soils ◽  
Economic Incentive ◽  
South Florida ◽  
Growth And Yield ◽  
Plant Populations ◽  
Clear Trend ◽  
Harvest Data ◽  
Direct Seeded ◽  
Southern Florida

Okra (Abelmoschus esculentus) is grown as a direct-seeded cash crop at high plant populations (>87,000 plants/acre) on calcareous soils in Homestead, south Florida. A study was established in a commercial field in May 2005 to evaluate if high populations translated to higher yields. Seedlings were thinned to within-row spacings of 2, 4, 6, 8, and 10 inches in rows set 3 ft apart (87120, 43560, 29040, 21780, and 17420 plants/acre). Harvest data was collected from 29 July to 30 Sept. 2005 (26 harvests) from 10 ft of the center row within plots 15 ft long and 3 rows wide. Decreasing plant density resulted in decreasing plant height early in the season and increasing height late in the season. Density affected stem caliper with a clear trend of decreasing density and increasing caliper. Early, mid-, and total yields by weight (boxes/acre) were not affected by density, but plants at the lowest density produced 55% more late yield than plants at the highest density. Plants at the lowest density produced 30% fewer early pods and 31% more late pods than plants at the highest density. Decreasing plant density resulted in increasing average pod weight for early, late, and total harvests by as much as 14% to 18%. With inexpensive open pollinated cultivars such as `Clemson Spineless 80', there seems little economic incentive to reduce plant populations below what is commonly used in the Homestead area. Growers should not be alarmed, however, if plant stands are reduced to some extent after seeding.

scholarly journals Germination and Emergence of Parsley in Response to Osmotic or Matric Seed Priming and Treatment with Gibberellin

2001 ◽  
Vol 11 (1) ◽  
pp. 152
Author(s):  
Wallace G. Pill ◽  
Elizabeth A. Kilian
Keyword(s):  
Polyethylene Glycol ◽  
Gibberellic Acid ◽  
Seedling Emergence ◽  
Dry Weight ◽  
Seed Priming ◽  
Germination Percentage ◽  
Petroselinum Crispum ◽  
Hypocotyl Length ◽  
Shoot Dry Weight ◽  
Emergence Percentage

`Moss Curled' seeds of parsley (Petroselinum crispum L.) were primed osmotically in polyethylene glycol or matrically in fine, exfoliated vermiculite at -0.5 MPa for 4 or 7 days at 20 or 30 °C with 0 or 1 mm GA3. All priming treatments stimulated and hastened germination. Matric priming resulted in greater germination (89%) than osmotic priming (83%) when seeds were primed for 7 days at 30 °C, but priming agent had no effect on germination percentage following priming at 20 °C or for 4 days. In seeds primed for 4 days at 20 or 30 °C, matric priming hastened germination more than did osmotic priming. Germination was generally less synchronous with matric than with osmotic priming. Increasing priming time from 4 to 7 days increased the rate of germination, but increased germination synchrony only when seeds were primed a t 20 °C. Inclusion of 1 mm GA3 during priming had little or no effect on germination. All matric priming treatments (other than 4-day priming) were repeated to assess seedling emergence in a greenhouse (25°C day/22 °C night). Priming increased the percentage, rate and synchrony of emergence, and increased hypocotyl length at 3 weeks after planting. Priming at 30 °C with 1 mm GA3 resulted in the greatest emergence percentage, hypocotyl length, and shoot dry weight. We conclude that matric priming is a satisfactory alternative to osmotic priming of parsley seeds. Chemical name used: gibberellic acid (GA3).

Effects of Plant Density and Thinning on High-Yielding Dry Beans (Phaseolus vulgaris) in Mexíco

1977 ◽  
Vol 13 (4) ◽  
pp. 325-335 ◽  
Author(s):  
Aguilar M. Immer ◽  
R. A. Fischer ◽  
Joshue Kohashi S.
Keyword(s):  
Phaseolus Vulgaris ◽  
Leaf Area ◽  
Seed Weight ◽  
Plant Density ◽  
Plant Competition ◽  
Growth And Yield ◽  
Positive Relation ◽  
Dry Beans ◽  
Leaf Area Duration ◽  
Pod Number

SUMMARYThe influence of leaf area and inter-plant competition on the growth and yield of a crop of high-yielding dry beans (Phaseolus vulgaris L.) in central Mexico was studied, using density and thinning treatments. The highest seed yield (4210 kg/ha at 14% moisture) was obtained with the highest density (28·8 plants/m2). Thinning showed that pods/plant was sensitive to inter-plant competition between 36 and 78 days after seeding (first flower at 50 days), but seeds/pod, and especially seed weight, were not sensitive. It is suggested that the close positive relation between yield and leaf area duration derives from the influence of photosynthate supply upon pod number.

scholarly journals Drip irrigation in coffee crop under different planting densities: Growth and yield in southeastern Brazil

2014 ◽  
Vol 18 (11) ◽  
pp. 1116-1123 ◽  
Author(s):  
Gleice A. de Assis ◽  
Myriane S. Scalco ◽  
Rubens J. Guimarães ◽  
Alberto Colombo ◽  
Anderson W. Dominghetti ◽  
...  
Keyword(s):  
Plant Density ◽  
Block Design ◽  
Irrigation Management ◽  
Growth And Yield ◽  
Southeastern Brazil ◽  
Soil Water Tension ◽  
Randomized Block Design ◽  
Coffee Plants ◽  
Coffee Cultivation ◽  
Water Tension

Irrigation associated to reduction on planting spaces between rows and between coffee plants has been a featured practice in coffee cultivation. The objective of the present study was to assess, over a period of five consecutive years, influence of different irrigation management regimes and planting densities on growth and bean yield of Coffea arabica L.. The treatments consisted of four irrigation regimes: climatologic water balance, irrigation when the soil water tension reached values close to 20 and 60 kPa; and a control that was not irrigated. The treatments were distributed randomly in five planting densities: 2,500, 3,333, 5,000, 10,000 and 20,000 plants ha-1. A split-plot in randomized block design was used with four replications. Irrigation promoted better growth of coffee plants and increased yield that varied in function of the plant density per area. For densities from 10,000 to 20,000 plants ha-1, regardless of the used irrigation management, mean yield increases were over 49.6% compared to the non-irrigated crop.

Sign in / Sign up

Export Citation Format

Share Document