Synthetic, Structural and Vibrational Spectroscopic Studies in Bismuth(III) Halide/N,N′-Aromatic Bidentate Base Systems. IV. Bismuth(III) Halide/N,N′-Bidentate Ligand (1 : 1) Systems

1997 ◽  
Vol 50 (4) ◽  
pp. 309 ◽  
Author(s):  
Brian R. Davis ◽  
Mark G. Hinds
Keyword(s):  
Double Bond ◽  
Spectroscopic Studies ◽  
Bidentate Ligand ◽  
Unsaturated Ketone ◽  
Aryl Substituent ◽  
Reaction Proceeds

The generation of a number of 1,2-diarylcyclopropane-1,2-diols is reported. Reaction of these in situ with acid gives, primarily, an α,β-unsaturated ketone in which the aryl substituent attached to the double bond is that which is best able to stabilize a benzylic cation. It is proposed that the reaction proceeds by O-protonation of the cyclopropane-1,2-diol, followed by loss of water and opening of the resulting cyclopropyl cation and final deprotonation. Such initial O-protonation contrasts with the C-protonation normally observed in the acidolysis of cyclopropanols and other dialkyl- and alkylaryl-cyclopropane-1,2-diols.

scholarly journals Synthesis of a sucrose dimer with enone tether; a study on its functionalization

2014 ◽  
Vol 10 ◽  
pp. 1246-1254 ◽  
Author(s):  
Zbigniew Pakulski ◽  
Norbert Gajda ◽  
Magdalena Jawiczuk ◽  
Jadwiga Frelek ◽  
Piotr Cmoch ◽  
...  
Keyword(s):  
Circular Dichroism ◽  
Double Bond ◽  
Carbonyl Group ◽  
Osmium Tetroxide ◽  
Cd Spectroscopy ◽  
Allylic Alcohol ◽  
Circular Dichroïsm

The reaction of appropriately functionalized sucrose phosphonate with sucrose aldehyde afforded a dimer composed of two sucrose units connected via their C6-positions (‘the glucose ends’). The carbonyl group in this product (enone) was stereoselectively reduced with zinc borohydride and the double bond (after protection of the allylic alcohol formed after reduction) was oxidized with osmium tetroxide to a diol. Absolute configurations of the allylic alcohol as well as the diol were determined by circular dichroism (CD) spectroscopy using the in situ dimolybdenum methodology.

Reactions of 4-Pyrones with Azomethine Ylides as a Chemo­selective Method for the Construction of Multisubstituted Pyrano[2,3-c]pyrrolidines

Synthesis ◽  
2021 ◽  
Author(s):  
Dmitrii L. Obydennov ◽  
Vyacheslav D. Steben’kov ◽  
Konstantin L. Obydennov ◽  
Sergey A. Usachev ◽  
Vladimir S. Moshkin ◽  
...  
Keyword(s):  
Double Bond ◽  
Ring Opening ◽  
Azomethine Ylides ◽  
Azomethine Ylide ◽  
Dipolar Cycloaddition ◽  
Computational Studies ◽  
Carbon Double Bond ◽  
Reactivity Indexes ◽  
Reaction Proceeds

Abstract4-Pyrones bearing electron-donating and electron-withdrawing groups react with nonstabilized azomethine ylides to form pyrano[2,3-c]pyrrolidines in moderate to good yields. The reaction proceeds chemoselectively as a 1,3-dipolar cycloaddition of the azomethine ylide at the carbon–carbon double bond of the pyrone activated by the electron-withdrawing substituent. The reactivity of 4-pyrones toward azomethine ylides was rationalized by computational studies with the use of reactivity indexes. The pyrano[2,3-c]pyrrolidine moiety could be modified, for example by a ring-opening transformation under the action of hydrazine to provide pyrazolyl-substituted pyrrolidines.

scholarly journals Experimental and Theoretical Studies of Sonically Prepared Cu–Y, Cu–USY and Cu–ZSM-5 Catalysts for SCR deNOx

Catalysts ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 824
Author(s):  
Przemysław J. Jodłowski ◽  
Izabela Czekaj ◽  
Patrycja Stachurska ◽  
Łukasz Kuterasiński ◽  
Lucjan Chmielarz ◽  
...  
Keyword(s):  
Ion Exchange ◽  
Ultrasonic Irradiation ◽  
Active Phase ◽  
Spectroscopic Studies ◽  
In Situ Drifts ◽  
Ft Ir ◽  
Diffuse Reflectance Infrared ◽  
Experimental And Theoretical Studies

The objective of our study was to prepare Y-, USY- and ZSM-5-based catalysts by hydrothermal synthesis, followed by copper active-phase deposition by either conventional ion-exchange or ultrasonic irradiation. The resulting materials were characterized by XRD, BET, SEM, TEM, Raman, UV-Vis, monitoring ammonia and nitrogen oxide sorption by FT-IR and Diffuse Reflectance Infrared Fourier Transform Spectroscopy (DRIFTS). XRD data confirmed the purity and structure of the Y/USY or ZSM-5 zeolites. The nitrogen and ammonia sorption results indicated that the materials were highly porous and acidic. The metallic active phase was found in the form of cations in ion-exchanged zeolites and in the form of nanoparticle metal oxides in sonochemically prepared catalysts. The latter showed full activity and high stability in the SCR deNOx reaction. The faujasite-based catalysts were fully active at 200–400 °C, whereas the ZSM-5-based catalysts reached 100% activity at 400–500 °C. Our in situ DRIFTS experiments revealed that Cu–O(NO) and Cu–NH3 were intermediates, also indicating the role of Brønsted sites in the formation of NH4NO3. Furthermore, the results from our experimental in situ spectroscopic studies were compared with DFT models. Overall, our findings suggest two possible mechanisms for the deNOx reaction, depending on the method of catalyst preparation (i.e., conventional ion-exchange vs. ultrasonic irradiation).

In-Situ Study of Ti/TiN Stability under Nitrogen Anneal

1999 ◽  
Vol 564 ◽  
Author(s):  
P. W. DeHaven ◽  
K. P. Rodbell ◽  
L. Gignac
Keyword(s):  
Annealing Temperature ◽  
Time Range ◽  
Second Phase ◽  
Transformation Rate ◽  
Transformation Mechanism ◽  
Second Stage ◽  
Transmission Electron ◽  
Reaction Proceeds ◽  
Two Stages

AbstractThe effectiveness of a TiN capping layer to prevent the conversion of α-titantium to titanium nitride when annealed in a nitrogen ambient has been studied over the temperature range 300–700°C using in-situ high temperature diffraction and transmission electron microscopy. Over the time range of interest (four hours), no evidence of Ti reaction was observed at 300°C. At 450°C. nitrogen was found to diffuse into the Ti to form a Ti(N) solid solution. Above 500°C the titanium is transformed to a second phase: however this reaction follows two different kinetic paths, depending on the annealing temperature. Below 600°C. the reaction proceeds in two stages, with the first stage consisting of Ti(N) formation, and the second stage consisting of the conversion of the Ti(N) with a transformation mechanism characteristic of short range diffusion (grain edge nucleation). Above 600°C, a simple linear transformation rate is observed.

In-situ infrared spectroscopic studies of hydroxyl in amphiboles at high pressure

2016 ◽  
Vol 101 (3) ◽  
pp. 706-712 ◽  
Author(s):  
Elizabeth C. Thompson ◽  
Andrew J. Campbell ◽  
Zhenxian Liu
Keyword(s):  
High Pressure ◽  
Spectroscopic Studies ◽  
Infrared Spectroscopic

scholarly journals Insertion of Phosphenium Ions into a Bicyclo[1.1.0]Tetraphosphabutane Iron Complex

Molecules ◽  
2021 ◽  
Vol 26 (13) ◽  
pp. 3920
Author(s):  
Martin Weber ◽  
Gábor Balázs ◽  
Alexander V. Virovets ◽  
Eugenia Peresypkina ◽  
Manfred Scheer
Keyword(s):  
Diffraction Analysis ◽  
Room Temperature ◽  
31P Nmr ◽  
Spectroscopic Studies ◽  
Iron Complex ◽  
The Novel ◽  
X Ray Diffraction ◽  
X Ray ◽  
Phosphenium Ions

By reacting [{Cp‴Fe(CO)2}2(µ,η1:1-P4)] (1) with in situ generated phosphenium ions [Ph2P][A] ([A]− = [OTf]− = [O3SCF3]−, [PF6]−), a mixture of two main products of the composition [{Cp‴Fe(CO)2}2(µ,η1:1-P5(C6H5)2)][PF6] (2a and 3a) could be identified by extensive 31P NMR spectroscopic studies at 193 K. Compound 3a was also characterized by X-ray diffraction analysis, showing the rarely observed bicyclo[2.1.0]pentaphosphapentane unit. At room temperature, the novel compound [{Cp‴Fe}(µ,η4:1-P5Ph2){Cp‴(CO)2Fe}][PF6] (4) is formed by decarbonylation. Reacting 1 with in situ generated diphenyl arsenium ions gives short-lived intermediates at 193 K which disproportionate at room temperature into tetraphenyldiarsine and [{Cp‴Fe(CO)2}4(µ4,η1:1:1:1-P8)][OTf]2 (5) containing a tetracyclo[3.3.0.02,7.03,6]octaphosphaoctane ligand.

scholarly journals Toward a mechanistic understanding of electrocatalytic nanocarbon

2021 ◽  
Vol 12 (1) ◽  
Author(s):  
Erik J. Askins ◽  
Marija R. Zoric ◽  
Matthew Li ◽  
Zhengtang Luo ◽  
Khalil Amine ◽  
...  
Keyword(s):  
Spectroscopic Studies ◽  
Synthetic Methods ◽  
Computational Studies ◽  
Molecular Models ◽  
Chemical Production ◽  
True Nature ◽  
Catalytic Mechanisms ◽  
Mechanistic Understanding ◽  
Further Development

AbstractElectrocatalytic nanocarbon (EN) is a class of material receiving intense interest as a potential replacement for expensive, metal-based electrocatalysts for energy conversion and chemical production applications. The further development of EN will require an intricate knowledge of its catalytic behaviors, however, the true nature of their electrocatalytic activity remains elusive. This review highlights work that contributed valuable knowledge in the elucidation of EN catalytic mechanisms. Experimental evidence from spectroscopic studies and well-defined molecular models, along with the survey of computational studies, is summarized to document our current mechanistic understanding of EN-catalyzed oxygen, carbon dioxide and nitrogen electrochemistry. We hope this review will inspire future development of synthetic methods and in situ spectroscopic tools to make and study well-defined EN structures.

Sign in / Sign up

Export Citation Format

Share Document