High-precision in situ measurements of size and optical properties of single microparticles in an RF plasma

2021 ◽  
Vol 28 (12) ◽  
pp. 123701
Author(s):  
Sören Wohlfahrt ◽  
Dietmar Block
Keyword(s):  
Optical Properties ◽  
High Precision ◽  
In Situ Measurements ◽  
Rf Plasma

scholarly journals Helicopter-borne observations of the continental background aerosol in combination with remote sensing and ground-based measurements

2017 ◽  
Author(s):  
Sebastian Düsing ◽  
Birgit Wehner ◽  
Patric Seifert ◽  
Albert Ansmann ◽  
Holger Baars ◽  
...  
Keyword(s):  
Optical Properties ◽  
Aerosol Particle ◽  
Extinction Coefficient ◽  
Cloud Condensation Nuclei ◽  
In Situ Measurements ◽  
Light Extinction ◽  
Backscatter Coefficient ◽  
Light Extinction Coefficient ◽  
Lidar Measurements

Abstract. This study presents vertical profiles up to a height of 2300 m a.s.l. of aerosol microphysical and optical properties and cloud condensation nuclei (CCN). Corresponding data have been measured during a field campaign as part of the High-Definition Clouds and Precipitation for Advancing Climate Prediction (HD(CP)2) Observational Prototype Experiments (HOPE), which took place at Melpitz, Germany from September 9 to 29, 2013. The helicopter-borne payload ACTOS (Airborne Cloud and Turbulence Observation System) was used to determine the aerosol particle number size distribution (PNSD), the number concentrations of aerosol particles (PNC) and cloud condensation nuclei (CCN) (CCN-NC), the ambient relative humidity (RH), and temperature (T). Simultaneous measurements on ground provided a holistic view on aerosol microphysical properties such as the PNSD, the chemical composition and the CCN-NC. Additional measurements of a 3 + 2 wavelength polarization lidar system (PollyXT) provided profiles of the aerosol particle light backscatter coefficient (σbsc) for three wavelengths (355, 532 and 1064 nm). From profiles of σbsc profiles of the aerosol particle light extinction coefficient (σext) were determined using the extinction-to-backscatter ratio. Furthermore, CCN-NC profiles were estimated on basis of the lidar-measurements. Ambient state optical properties of aerosol particles were derived on the basis of airborne in situ measurements of ACTOS (PNSD) and in situ measurements on ground (chemical aerosol characterization) using Mie-theory. On the basis of ground-based and airborne measurements, this work investigates the representativeness of ground-based aerosol microphysical properties for the boundary layer for two case-studies. The PNSD measurements on ground showed a good agreement with the measurements provided with ACTOS for lower altitudes. The ground-based measurements of PNC and CCN-NC are representative for the PBL when the PBL is well mixed. Locally isolated new particle formation events on ground or at the top of the PBL led to vertical variability in the here presented cases and ground-based measurements are not representative for the PBL. Furthermore, the lidar-based estimates of CCN-NC profiles were compared with the airborne in situ measurements of ACTOS. This comparison showed good agreements within the uncertainty range. Finally, this work provides a closure study between the optical aerosol particle properties in ambient state based on the airborne ACTOS measurements and derived with the lidar measurements. The investigation of the optical properties shows for 14 measurement-points that the airborne-based particle light backscatter coefficient is for 1064 nm 50 % smaller than the measurements of the lidar system, 27.6 % smaller for 532 nm and 29.9 % smaller for 355 nm. These results are quite promising, since in-situ measurement based Mie-calculations of the particle light backscattering are scarce and the modelling is quite challenging. In contradiction for the particle light extinction coefficient retrieved from the airborne in situ measurements were found a good agreement. The airborne-based particle light extinction coefficient was just 7.9 % larger for 532 nm and 3.5 % smaller for 355 nm, for an assumed lidar ratio (LR) of 55 sr. The particle light extinction coefficient for 1064 nm was derived with a LR of 30 sr. For this wavelength, the airborne-based particle light extinction coefficient is 5.2 % smaller than the lidar-measurements. Also, the correlation for the particle light extinction coefficient in combination with Mie-based LR's are in agreement for typical LR's of European background aerosol.

scholarly journals DERIVING INHERENT OPTICAL PROPERTIES FROM MERIS IMAGERY AND IN SITU MEASUREMENT USING QUASI-ANALYTICAL ALGORITHM

2014 ◽  
Vol 10 (1) ◽  
Author(s):  
Wiwin Ambarwulan ◽  
Widiatmaka ◽  
Syarif Budhiman
Keyword(s):  
Optical Properties ◽  
Optical Measurement ◽  
In Situ Measurements ◽  
In Situ Measurement ◽  
Coefficient Of Determination ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Inherent Optical Properties ◽  
Analytical Algorithm

The  paper  describes inherent optical properties  (IOP)  of  the  Berau  coastal  waters  derived from in  situ measurements  and Medium  Resolution  Imaging  Spectrometer  (MERIS) satellite  data. Field  measurements  of optical  water,  total  suspended  matter  (TSM), and  chlorophyll-a  (Chl-a) concentrations were carried out during the dry season of 2007. During this periode, only four MERISdata were  coincided with in  situ measurements on 31 August  2007. The MERIS  top-of-atmosphere radiances were atmospherically corrected using the MODTRAN radiative transfer model. The in situ optical  measurement  have  been  processed  into apparent optical properties  (AOP) and sub  surface irradiance. The remote sensing reflectance of in situ measurement as well as MERIS data were inverted into  the  IOP  using quasi-analytical algorithm  (QAA).  The  result  indicated  that coefficient  of determination (R 2) of backscattering coefficients of suspended particles (bbp) increased with increasing wavelength,  however  the  R2 of  absorption  spectra  of  phytoplankton  (aph)  decreased  with  increasing wavelength.

scholarly journals Comparison of ambient aerosol extinction coefficients obtained from in-situ, MAX-DOAS and LIDAR measurements at Cabauw

2010 ◽  
Vol 10 (12) ◽  
pp. 29683-29734 ◽  
Author(s):  
P. Zieger ◽  
E. Weingartner ◽  
J. Henzing ◽  
M. Moerman ◽  
G. de Leeuw ◽  
...  
Keyword(s):  
Optical Properties ◽  
Extinction Coefficient ◽  
In Situ Measurements ◽  
Optical Absorption Spectroscopy ◽  
Aerosol Composition ◽  
Large Variability ◽  
Extinction Coefficients ◽  
Ambient Aerosol ◽  
Wide Range

Abstract. In the field, aerosol in-situ measurements are often performed under dry conditions (relative humidity RH<30–40%). Since ambient aerosol particles experience hygroscopic growth at enhanced RH, also their microphysical and optical properties – especially the aerosol light scattering – are strongly dependent on RH. The knowledge of this RH effect is of crucial importance for climate forcing calculations or for the comparison of remote sensing with in-situ measurements. Here, we will present results from a four-month campaign which took place in summer 2009 in Cabauw, The Netherlands. The aerosol scattering coefficient σsp(λ) was measured dry and at various, predefined RH conditions between 20 and 95% with a humidified nephelometer. The scattering enhancement factor f(RH,λ) is the key parameter to describe the effect of RH on σsp(λ) and is defined as σsp(RH,λ) measured at a certain RH divided by the dry σsp(dry,λ). The measurement of f(RH,λ) together with the dry absorption measurement (assumed not to change with RH) allows the determination of the actual extinction coefficient σep(RH,λ) at ambient RH. In addition, a wide range of other aerosol properties were measured in parallel. The measurements were used to characterize the effects of RH on the aerosol optical properties. A closure study showed the consistency of the aerosol in-situ measurements. Due to the large variability of air mass origin (and thus aerosol composition) a simple parameterization of f(RH,λ) could not be established. If f(RH,λ) needs to be predicted, the chemical composition and size distribution needs to be known. Measurements of four MAX-DOAS (multi-axis differential optical absorption spectroscopy) instruments were used to retrieve vertical profiles of σep(λ). The values of the lowest layer were compared to the in-situ values after conversion of the latter to ambient RH. The comparison showed a good correlation of R2=0.62–0.78, but the extinction coefficients were a factor of 1.5–3.4 larger than the in-situ values. Best agreement is achieved for a few cases characterized by low aerosol optical depths and low planetary boundary layer heights. Differences showed to be dependent on the applied MAX-DOAS retrieval algorithm. The comparison of the in-situ data to a Raman lidar (light detection and ranging) showed a good correlation and higher values measured by the lidar (R2=0.79, slope of 1.81) if the Raman retrieved profile was used to extrapolate the directly measured extinction coefficient to the ground. The comparison improved if only nighttime measurements were used in the comparison (R2=0.93, slope of 1.19).

scholarly journals Glint Removal Assessment to Estimate the Remote Sensing Reflectance in Inland Waters with Widely Differing Optical Properties

2018 ◽  
Vol 10 (10) ◽  
pp. 1655 ◽  
Author(s):  
Nariane Bernardo ◽  
Enner Alcântara ◽  
Fernanda Watanabe ◽  
Thanan Rodrigues ◽  
Alisson Carmo ◽  
...  
Keyword(s):  
Remote Sensing ◽  
Optical Properties ◽  
Wind Speed ◽  
In Situ Measurements ◽  
Colored Dissolved Organic Matter ◽  
The Third ◽  
Sensing Applications ◽  
Remote Sensing Reflectance ◽  
Remote Sensing Applications

The quality control of remote sensing reflectance (Rrs) is a challenging task in remote sensing applications, mainly in the retrieval of accurate in situ measurements carried out in optically complex aquatic systems. One of the main challenges is related to glint effect into the in situ measurements. Our study evaluates four different methods to reduce the glint effect from the Rrs spectra collected in cascade reservoirs with widely differing optical properties. The first (i) method adopts a constant coefficient for skylight correction (ρ) for any geometry viewing of in situ measurements and wind speed lower than 5 m·s−1; (ii) the second uses a look-up-table with variable ρ values accordingly to viewing geometry acquisition and wind speed; (iii) the third method is based on hyperspectral optimization to produce a spectral glint correction, and (iv) computes ρ as a function of wind speed. The glint effect corrected Rrs spectra were assessed using HydroLight simulations. The results showed that using the glint correction with spectral ρ achieved the lowest errors, however, in a Colored Dissolved Organic Matter (CDOM) dominated environment with no remarkable chlorophyll-a concentrations, the best method was the second. Besides, the results with spectral glint correction reduced almost 30% of errors.

Sign in / Sign up

Export Citation Format

Share Document