Structural characterization of nickel and zinc aluminate prepared by sol-gel technique

2021 ◽  
Author(s):  
Inaam M. Abdulmajeed ◽  
Dunia Kamel Mahdi ◽  
Suha H. Ibraheem
2018 ◽  
Vol 10 ◽  
pp. 956-963 ◽  
Author(s):  
Piaw Phatai ◽  
Cybelle Morales Futalan ◽  
Songkot Utara ◽  
Pongtanawat Khemthong ◽  
Sirilak Kamonwannasit

2008 ◽  
Vol 46 (2) ◽  
pp. 152-160 ◽  
Author(s):  
S. Kurajica ◽  
E. Tkalcec ◽  
J. Sipusic ◽  
G. Matijasic ◽  
I. Brnardic ◽  
...  

RSC Advances ◽  
2015 ◽  
Vol 5 (125) ◽  
pp. 103752-103759 ◽  
Author(s):  
Lidiaine M. Santos ◽  
Werick A. Machado ◽  
Marcela D. França ◽  
Karen A. Borges ◽  
Roberto M. Paniago ◽  
...  

Ag-doped TiO2 nanoparticles with different metallic content (0.5, 2.0, and 5.0% m/m) were prepared using a simple and cost-effective method based on a sol–gel technique, followed by thermal treatment.


1997 ◽  
Vol 474 ◽  
Author(s):  
E. Ching-Prado ◽  
W. Pérez ◽  
A. Reynés-figueroa ◽  
R. S. Katiyar ◽  
D. Ravichandran ◽  
...  

ABSTRACTThin films of SrBiTa2O9, (SBT) were deposited on Si using Sol-Gel technique. The thicknesses of the films are 200 nm (A) and 400 nm (B), respectively. SEM studies show isolated grains in both SBT films with a grain size distribution between 0.1 and 0.5 μ. However, most of the grain size in the film is smaller than 0.1 μ. EDX analysis indicates that the films are inhomogeneous. FTIR external reflectivity measurements of the samples show bands around 1260, 936(for SBT2), 955(for SBT4), 770, 600 cm−1. Micro Raman spectra shows inhomogeneities in the SBT films. Bands corresponding to the SBT materials were found, but frequency shifts and broadening were observed in almost every band. Particularly, the band around 818 cm−1 was found to change from 785 to 827 cm−1. Also, due to the stretching of the Ta06 octahedron, the Alg mode was found to be approximately 163 cm−1. This change seems to be related to the Ta-0 bond length.


Author(s):  
Abdu. I. Abdallah ◽  
M. Sayed ◽  
M. Awaad ◽  
Adam H. E. Yousif ◽  
S.M. Naga
Keyword(s):  
Sol Gel ◽  

2011 ◽  
Vol 685 ◽  
pp. 367-370 ◽  
Author(s):  
Min Qi ◽  
Da Yi Yang ◽  
Jing Ying Zhang ◽  
Hong Jun Ai

In order to improve the osteoblast growth and bacteria resistance, Zn-containing hydroxyapatite (Zn-HA) and titanium oxide (TiO2) composite coatings were prepared to improve binding between coating and Ti substrate. TiO2 film was prepared on the surface of Ti by micro-arc oxidation (MAO) and Zn-HA coating was deposited on TiO2 using sol–gel technique. Phase structure, composition and microstructure of the surface coatings were analyzed by X-ray diffraction (XRD) and Energy Dispersive Spectrometer (EDS), respectively. The adhesion strength between the coatings with different Zn content was measured by tensile testing. The results showed that there was no significant influence of Zn content on adhesion strength between coating and Ti substrate.


1996 ◽  
Vol 459 ◽  
Author(s):  
E. Ching-Prado ◽  
W. Pérez ◽  
A. Reynés-Figueroa ◽  
R. S. Katiyar ◽  
D. Ravichandran ◽  
...  

ABSTRACTThin films of SrBi2Nb2O9 (SBN) with thicknesses of 0.1, 0.2, and 0.4 μ were grown by Sol-gel technique on silicon, and annealed at 650°C. The SBN films were investigated by Raman scatering for the first time. Raman spectra in some of the samples present bands around 60, 167, 196, 222, 302, 451, 560, 771, 837, and 863 cm−1, which correspond to the SBN formation. The study indicates that the films are inhomogeneous, and only in samples with thicknesses 0.4 μ the SBN material was found in some places. The prominent Raman band around 870 cm−1, which is the A1g mode of the orthorhombic symmetry, is assigned to the symmetric stretching of the NbO6 octahedrals. The frequency of this band is found to shift in different places in the same sample, as well as from sample to sample. The frequency shifts and the width of the Raman bands are discussed in term of ions in non-equilibrium positions. FT-IR spectra reveal a sharp peak at 1260 cm−1, and two broad bands around 995 and 772 cm−1. The bandwidths of the latter two bands are believed to be associated with the presence of a high degree of defects in the films. The experimental results of the SBN films are compared with those obtained in SBT (T=Ta) films. X-ray diffraction and SEM techniques are also used for the structural characterization.


2008 ◽  
Vol 396-398 ◽  
pp. 153-156 ◽  
Author(s):  
Xanthippi Chatzistavrou ◽  
E. Hatzistavrou ◽  
Nikolaos Kantiranis ◽  
Lambrini Papadopoulou ◽  
Eleana Kontonasaki ◽  
...  

The aim of this study was the fabrication using a sol-gel technique of a new glass-ceramic with potential use in dental applications. The characterization of the composition and microstructural properties of the produced material confirmed the similarity between the new sol-gel derived glass-ceramic and a commercial leucite based fluorapatite dental glass-ceramic. The produced material has potential application in dental restorations and it is expected to exhibit better control of composition, microstructure and properties due to the intrinsic advantages of the sol-gel preparation method.


Sign in / Sign up

Export Citation Format

Share Document