The high viscosity of the lubricant oil in internal combustion engines at cold starts is responsible for poor friction reduction and inadequate thermal stabilization of metallic masses and represents a major bottleneck in the efforts to reduce specific fuel consumption and pollutant emissions. Consequently, the possibility of integrating techniques for proper thermal management of the lubricant oil on internal combustion engines is of utmost importance to both homologation and daily on-road operation. Main options for reducing the warm-up time for the engine lubricant are the upgrade of the engine cooling and lubricating circuits, dedicated heating, different flow management of the oil/coolant heat exchanger, a renewed design of the oil sump or a thermal storage section to increase the oil temperature in the early phases of the warm up. The paper presents a new opportunity, using a hot storage medium to heat up the oil in the early phase of a driving cycle. A certain quantity of hot water, so, is stored in a tank, which can be used to warm up the lubricating oil when the engine is started up. The heating of this service water can be done by using exhaust gas heat, which is always wasted in the atmosphere. The activity is realized on an IVECO 3.0 L light-duty diesel engine, during a transient cycle (NEDC) on a dynamometric test bench. The benefits in terms of both fuel consumption and CO2 emissions reduction. The characterization of the backpressure associated with an eventual additional heat exchangers and the more complex layout of the oil circuit is assessed, as well as the transient effects produced by the faster oil warm-up and oil-coolant interaction on the engine thermal stabilization.
Technical review of opportunities to reduce the warm-up time of lubricant oil in a light-duty diesel engine