Unsteady effects of periodic wake passing frequency on aerodynamic performance of ultra-high-lift low pressure turbine cascades

2019 ◽  
Vol 31 (9) ◽  
pp. 094102 ◽  
Author(s):  
Xiao Qu ◽  
Yanfeng Zhang ◽  
Xingen Lu ◽  
Junqiang Zhu
Keyword(s):  
Low Pressure ◽  
Aerodynamic Performance ◽  
High Lift ◽  
Low Pressure Turbine ◽  
Turbine Cascades ◽  
Unsteady Effects ◽  
Wake Passing

Effect of Unsteady Wakes on Boundary Layer Separation on a Very High Lift Low Pressure Turbine Airfoil

2010 ◽  
Author(s):  
Ralph J. Volino
Keyword(s):  
Boundary Layer ◽  
Boundary Layer Separation ◽  
Low Pressure ◽  
Freestream Turbulence ◽  
Suction Surface ◽  
High Lift ◽  
Layer Separation ◽  
Low Pressure Turbine ◽  
Wake Passing ◽  
Very High

Boundary layer separation has been studied on a very high lift, low-pressure turbine airfoil in the presence of unsteady wakes. Experiments were done under low (0.6%) and high (4%) freestream turbulence conditions on a linear cascade in a low speed wind tunnel. Wakes were produced from moving rods upstream of the cascade. Flow coefficients were varied from 0.35 to 1.4 and wake spacing was varied from 1 to 2 blade spacings, resulting in dimensionless wake passing frequencies F = fLj-te/Uave (f is the frequency, Lj-te is the length of the adverse pressure gradient region on the suction surface of the airfoils, and Uave is the average freestream velocity) ranging from 0.14 to 0.56. Pressure surveys on the airfoil surface and downstream total pressure loss surveys were documented. Instantaneous velocity profile measurements were acquired in the suction surface boundary layer and downstream of the cascade. Cases were considered at Reynolds numbers (based on the suction surface length and the nominal exit velocity from the cascade) of 25,000 and 50,000. In cases without wakes, the boundary layer separated and did not reattach. With wakes, separation was largely suppressed, particularly if the wake passing frequency was sufficiently high. At lower frequencies the boundary layer separated between wakes. Background freestream turbulence had some effect on separation, but its role was secondary to the wake effect.

Effect of Unsteady Wakes on Boundary Layer Separation on a Very High Lift Low Pressure Turbine Airfoil

2011 ◽  
Vol 134 (1) ◽  
Author(s):  
Ralph J. Volino
Keyword(s):  
Boundary Layer ◽  
Boundary Layer Separation ◽  
Low Pressure ◽  
Freestream Turbulence ◽  
Suction Surface ◽  
High Lift ◽  
Layer Separation ◽  
Low Pressure Turbine ◽  
Wake Passing ◽  
Very High

Boundary layer separation has been studied on a very high lift, low pressure turbine airfoil in the presence of unsteady wakes. Experiments were done under low (0.6%) and high (4%) freestream turbulence conditions on a linear cascade in a low speed wind tunnel. Wakes were produced from moving rods upstream of the cascade. Flow coefficients were varied from 0.35 to 1.4 and wake spacing was varied from one to two blade spacings, resulting in dimensionless wake passing frequencies F=fLj-te/Uave (f is the frequency, Lj-te is the length of the adverse pressure gradient region on the suction surface of the airfoils, and Uave is the average freestream velocity) ranging from 0.14 to 0.56. Pressure surveys on the airfoil surface and downstream total pressure loss surveys were documented. Instantaneous velocity profile measurements were acquired in the suction surface boundary layer and downstream of the cascade. Cases were considered at Reynolds numbers (based on the suction surface length and the nominal exit velocity from the cascade) of 25,000 and 50,000. In cases without wakes, the boundary layer separated and did not reattach. With wakes, separation was largely suppressed, particularly if the wake passing frequency was sufficiently high. At lower frequencies the boundary layer separated between wakes. Background freestream turbulence had some effect on separation, but its role was secondary to the wake effect.

scholarly journals Direct Numerical Simulation on the Unsteady Flow Field of Low-Pressure Turbine Cascades With and Without Upstream Wake at Low Reynolds Number

2021 ◽  
Author(s):  
Xiyuan Pang ◽  
Hongbo Zhu ◽  
Feng Wu ◽  
Yan Bao ◽  
Hui Xu
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Flow Separation ◽  
Low Reynolds Number ◽  
Low Pressure ◽  
Aerodynamic Performance ◽  
High Fidelity ◽  
Low Pressure Turbine ◽  
Turbine Cascades ◽  
Element Method

Abstract The spectral/hp element method is a high fidelity method that has good numerical dispersion-diffusion characteristics and is flexible and applicable to quasi-three-dimensional aerodynamic problems with complex geometric configurations in the streamline direction and the pitch direction. This paper uses this method to directly solve the incompressible Navier-Stokes equations, and analyzes the aerodynamic performance of the T106A low-pressure turbine cascade at low Reynolds number. Two different conditions, i.e. uniform inlet flow and cylinder’s wake flow, are adopted and their basic characteristics of flow separation and transition are quantitatively analyzed and compared, by observing the distribution of cascade wall surface pressure and friction coefficient, the distribution of wake profile pressure loss and the evolution characteristics of boundary layer flow structure. The numerical results show that the spectral/hp element method can accurately predict the flow separation and transition performance of low-pressure turbine cascades, which implies that it can be used as a high-fidelity simulation and calculation tool for the optimal design of this type of cascade. It is also found that cylinder’s wake can effectively inhibit boundary layer separation of the T106A LPT blade and improve aerodynamic performance and efficiency of it.

Redesign of High-Lift LP-Turbine Airfoils for Low Speed Testing

2010 ◽  
Author(s):  
Michele Marconcini ◽  
Filippo Rubechini ◽  
Roberto Pacciani ◽  
Andrea Arnone ◽  
Francesco Bertini
Keyword(s):  
Separated Flow ◽  
Low Pressure ◽  
High Lift ◽  
Low Speed ◽  
Low Pressure Turbine ◽  
Wide Range ◽  
Flow Configurations ◽  
Artificial Neural Network Ann ◽  
Lp Turbine ◽  
Turbine Airfoils

Low pressure turbine airfoils of the present generation usually operate at subsonic conditions, with exit Mach numbers of about 0.6. To reduce the costs of experimental programs it can be convenient to carry out measurements in low speed tunnels in order to determine the cascades performance. Generally speaking, low speed tests are usually carried out on airfoils with modified shape, in order to compensate for the effects of compressibility. A scaling procedure for high-lift, low pressure turbine airfoils to be studied in low speed conditions is presented and discussed. The proposed procedure is based on the matching of a prescribed blade load distribution between the low speed airfoil and the actual one. Such a requirement is fulfilled via an Artificial Neural Network (ANN) methodology and a detailed parameterization of the airfoil. A RANS solver is used to guide the redesign process. The comparison between high and low speed profiles is carried out, over a wide range of Reynolds numbers, by using a novel three-equation, transition-sensitive, turbulence model. Such a model is based on the coupling of an additional transport equation for the so-called laminar kinetic energy (LKE) with the Wilcox k–ω model and it has proven to be effective for transitional, separated-flow configurations of high-lift cascade flows.

The Effect of Wake Passing on a Flow Separation in a Low-Pressure Turbine Cascade

2004 ◽  
Vol 126 (2) ◽  
pp. 250-256 ◽  
Author(s):  
Michael J. Brear ◽  
Howard P. Hodson
Keyword(s):  
Separation Bubble ◽  
Phase Locking ◽  
Experimental Studies ◽  
Leading Edge ◽  
Low Pressure ◽  
Pressure Surface ◽  
Low Pressure Turbine ◽  
Numerical Predictions ◽  
Unsteady Interaction ◽  
Wake Passing

This paper describes an investigation into the effect that passing wakes have on a separation bubble that exists on the pressure surface and near the leading edge of a low-pressure turbine blade. Previous experimental studies have shown that the behavior of this separation is strongly incidence dependent and that it responds to its disturbance environment. The results presented in this paper examine the effect of wake passing in greater detail. Two-dimensional, Reynolds averaged, numerical predictions are first used to examine qualitatively the unsteady interaction between the wakes and the separation bubble. The separation is predicted to consist of spanwise vortices whose development is in phase with the wake passing. However, comparison with experiments shows that the numerical predictions exaggerate the coherence of these vortices and also overpredict the time-averaged length of the separation. Nonetheless, experiments strongly suggest that the predicted phase locking of the vortices in the separation onto the wake passing is physical.

Sign in / Sign up

Export Citation Format

Share Document