The logarithmic and power law behaviors of the accelerating, turbulent thermal boundary layer

2017 ◽  
Vol 29 (2) ◽  
pp. 020718 ◽  
Author(s):  
Luciano Castillo ◽  
Fazle Hussain
Keyword(s):  
Boundary Layer ◽  
Power Law ◽  
Thermal Boundary Layer

Experimental studies of the viscous boundary layer properties in turbulent Rayleigh–Bénard convection

2008 ◽  
Vol 605 ◽  
pp. 79-113 ◽  
Author(s):  
CHAO SUN ◽  
YIN-HAR CHEUNG ◽  
KE-QING XIA
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Shear Stress ◽  
Rayleigh Number ◽  
Power Law ◽  
Thermal Boundary Layer ◽  
Viscous Sublayer ◽  
Viscous Boundary Layer ◽  
Velocity Boundary Layer ◽  
Viscous Boundary

We report high-resolution measurements of the properties of the velocity boundary layer in turbulent thermal convection using the particle image velocimetry (PIV) technique and measurements of the temperature profiles and the thermal boundary layer. Both velocity and temperature measurements were made near the lower conducting plate of a rectangular convection cell using water as the convecting fluid, with the Rayleigh number Ra varying from 109 to 1010 and the Prandtl number Pr fixed at 4.3. From the measured profiles of the horizontal velocity we obtain the viscous boundary layer thickness δυ. It is found that δυ follows the classical Blasius-like laminar boundary layer in the present range of Ra, and it scales with the Reynolds number Re as δυ/H = 0.64Re−0.50±0.03 (where H is the cell height). While the measured viscous shear stress and Reynolds shear stress show that the boundary layer is laminar for Ra < 2.0 × 1010, two independent extrapolations, one based on velocity measurements and the other on velocity and temperature measurements, both indicate that the boundary layer will become turbulent at Ra ~ 1013. Just above the thermal boundary layer but within the mixing zone, the measured temperature r.m.s. profiles σT(z) are found to follow either a power law or a logarithmic behaviour. The power-law fitting may be slightly favoured and its exponent is found to depend on Ra and varies from −0.6 to −0.77, which is much larger than the classical value of −1/3. In the same region, the measured profiles of the r.m.s. vertical velocity σw(z) exhibit a much smaller scaling range and are also consistent with either a power-law or a logarithmic behaviour. The Reynolds number dependence of several wall quantities is also measured directly. These are the wall shear stress τw ~ Re1.55, the viscous sublayer δw ~ Re−0.91, the friction velocity uτ ~ Re0.80, and the skin-friction coefficient cf ~ Re−0.34. All of these scaling properties are very close to those predicted for a classical Blasius-type laminar boundary layer, except that of cf. Similar to classical shear flows, a viscous sublayer is also found to exist in the present system despite the presence of a nested thermal boundary layer. However, velocity profiles normalized by wall units exhibit no obvious logarithmic region, which is likely to be a result of the very limited distance between the edge of the viscous sublayer and the position of the maximum velocity. Compared to traditional shear flows, the peak position of the wall-unit-normalized r.m.s. profiles is found to be closer to the plate (at z+ = z/δw ≃ 5). Our overall conclusion is that a Blasius-type laminar boundary condition is a good approximation for the velocity boundary layer in turbulent thermal convection for the present range of Rayleigh number and Prandtl number.

An analysis of the characteristics of the thermal boundary layer in power law fluid

2008 ◽  
Vol 17 (3) ◽  
pp. 233-237 ◽  
Author(s):  
Hao Zhang ◽  
Xinxin Zhang ◽  
Liancun Zheng
Keyword(s):  
Boundary Layer ◽  
Power Law ◽  
Thermal Boundary Layer ◽  
Power Law Fluid

An integral approach to the calculation of skin friction and heat transfer in the laminar flow of a high-Prandtl-number power-law non-Newtonian fluid past a wedge

1991 ◽  
Vol 69 (2) ◽  
pp. 83-89 ◽  
Author(s):  
G. Ramamurty ◽  
K. Narasimha Rao ◽  
K. N. Seetharamu
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Prandtl Number ◽  
Skin Friction ◽  
Layer Thickness ◽  
Power Law ◽  
Boundary Layer Thickness ◽  
Thermal Boundary Layer ◽  
Integral Approach ◽  
High Prandtl Number

An integral approach to the theoretical analysis for the skin friction of a non-Newtonian, power-law-fluid flow over a wedge is presented, when the inertia terms in the boundary-layer equations are small but need consideration. The method adopted for the solution of the equations considers an integrated average value of the inertia terms in the momentum equation. The values of the velocities and the boundary-layer thickness obtained from the hydrodynamic analysis are used for the calculation of the thermal-boundary-layer thickness. A linear velocity profile is assumed for the flow field within the thermal boundary layer as the fluids chosen for the analysis are high-Prandtl-number fluids. The results of the skin friction and the rates of the heat transfer are tabulated for a number of values of the flow behaviour index, n, varying from 0.05 to 5.0. This analysis is applicable to viscous polymer solutions having high Prandtl numbers.

Similarity Solution for Unsteady Free Convection From a Vertical Plate at Constant Temperature to Power Law Fluids

2012 ◽  
Vol 134 (10) ◽  
Author(s):  
J. Abolfazli Esfahani ◽  
B. Bagherian
Keyword(s):  
Boundary Layer ◽  
Differential Equations ◽  
Free Convection ◽  
Boundary Conditions ◽  
Ordinary Differential Equations ◽  
Power Law ◽  
Thermal Boundary Layer ◽  
Theoretic Approach ◽  
Local Skin ◽  
Power Law Fluids

The transformation group theoretic approach is applied to perform an analysis of unsteady free convection flow over a vertical flat plate immersed in a power law fluid. The thermal boundary layer induced within a vertical semi-infinite layer of Boussinseq fluid. The system of governing partial differential equations with boundary conditions reduces to a system of ordinary differential equations with appropriate boundary conditions via two-parameter group theory. The obtained ordinary differential equations are solved numerically for velocity and temperature using the fourth order Runge-Kutta and shooting method. The effect of Prandtl number and viscosity index (n) on the thermal boundary-layer, velocity boundary-layer, local Nusselt number, and local skin-friction were studied.

Sign in / Sign up

Export Citation Format

Share Document