Low temperature dependence of triboelectric effect for energy harvesting and self-powered active sensing

2015 ◽  
Vol 106 (1) ◽  
pp. 013114 ◽  
Author(s):  
Yuanjie Su ◽  
Jun Chen ◽  
Zhiming Wu ◽  
Yadong Jiang
Keyword(s):  
Energy Harvesting ◽  
Low Temperature ◽  
Temperature Dependence ◽  
Active Sensing ◽  
Self Powered ◽  
Triboelectric Effect

scholarly journals Electrode and electrolyte configurations for low frequency motion energy harvesting based on reverse electrowetting

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Pashupati R. Adhikari ◽  
Nishat T. Tasneem ◽  
Russell C. Reid ◽  
Ifana Mahbub
Keyword(s):  
Energy Harvesting ◽  
Bias Voltage ◽  
Energy Harvester ◽  
Superior Performance ◽  
Maximum Output ◽  
Electrowetting On Dielectric ◽  
External Bias ◽  
Motion Energy ◽  
Ac Current ◽  
Self Powered

AbstractIncreasing demand for self-powered wearable sensors has spurred an urgent need to develop energy harvesting systems that can reliably and sufficiently power these devices. Within the last decade, reverse electrowetting-on-dielectric (REWOD)-based mechanical motion energy harvesting has been developed, where an electrolyte is modulated (repeatedly squeezed) between two dissimilar electrodes under an externally applied mechanical force to generate an AC current. In this work, we explored various combinations of electrolyte concentrations, dielectrics, and dielectric thicknesses to generate maximum output power employing REWOD energy harvester. With the objective of implementing a fully self-powered wearable sensor, a “zero applied-bias-voltage” approach was adopted. Three different concentrations of sodium chloride aqueous solutions (NaCl-0.1 M, NaCl-0.5 M, and NaCl-1.0 M) were used as electrolytes. Likewise, electrodes were fabricated with three different dielectric thicknesses (100 nm, 150 nm, and 200 nm) of Al2O3 and SiO2 with an additional layer of CYTOP for surface hydrophobicity. The REWOD energy harvester and its electrode–electrolyte layers were modeled using lumped components that include a resistor, a capacitor, and a current source representing the harvester. Without using any external bias voltage, AC current generation with a power density of 53.3 nW/cm2 was demonstrated at an external excitation frequency of 3 Hz with an optimal external load. The experimental results were analytically verified using the derived theoretical model. Superior performance of the harvester in terms of the figure-of-merit comparing previously reported works is demonstrated. The novelty of this work lies in the combination of an analytical modeling method and experimental validation that together can be used to increase the REWOD harvested power extensively without requiring any external bias voltage.

scholarly journals Time-Multiplexed Self-Powered Wireless Current Sensor for Power Transmission Lines

Energies ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1561
Author(s):  
Hao Chen ◽  
Zhongnan Qian ◽  
Chengyin Liu ◽  
Jiande Wu ◽  
Wuhua Li ◽  
...  
Keyword(s):  
Energy Harvesting ◽  
Transmission Line ◽  
Transmission Lines ◽  
Power Transmission ◽  
Current Measurement ◽  
Current Sensor ◽  
Power Transmission Line ◽  
Power Transmission Lines ◽  
Current Sensing ◽  
Self Powered

Current measurement is a key part of the monitoring system for power transmission lines. Compared with the conventional current sensor, the distributed, self-powered and contactless current sensor has great advantages of safety and reliability. By integrating the current sensing function and the energy harvesting function of current transformer (CT), a time-multiplexed self-powered wireless sensor that can measure the power transmission line current is presented in this paper. Two operating modes of CT, including current sensing mode and energy harvesting mode, are analyzed in detail. Through the design of mode-switching circuit, harvesting circuit and measurement circuit are isolated using only one CT secondary coil, which eliminates the interference between energy harvesting and current measurement. Thus, the accurate measurement in the current sensing mode and the maximum energy collection in the energy harvesting mode are both realized, all of which simplify the online power transmission line monitoring. The designed time-multiplexed working mode allows the sensor to work at a lower transmission line current, at the expense of a lower working frequency. Finally, the proposed sensor is verified by experiments.

An all-rubber-based woven nanogenerator with improved triboelectric effect for highly efficient energy harvesting

2021 ◽  
Vol 287 ◽  
pp. 129271
Author(s):  
Shengnan Zhang ◽  
Jianming Xu ◽  
Junbin Yu ◽  
Linlin Song ◽  
Jian He ◽  
...  
Keyword(s):  
Energy Harvesting ◽  
Efficient Energy ◽  
Highly Efficient ◽  
Triboelectric Effect

Triboelectric Nanogenerator using Multiferroic Materials: An Approach for Energy Harvesting and Self-Powered Magnetic Field Detection

Nano Energy ◽  
2021 ◽  
pp. 105964
Author(s):  
Sugato Hajra ◽  
Venkateswaran Vivekananthan ◽  
Manisha Sahu ◽  
Gaurav Khandelwal ◽  
Nirmal Prashanth Maria Joseph Raj ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Energy Harvesting ◽  
Triboelectric Nanogenerator ◽  
Multiferroic Materials ◽  
Field Detection ◽  
Self Powered

scholarly journals Piezoelectric Impact Energy Harvester Based on the Composite Spherical Particle Chain for Self-Powered Sensors

Sensors ◽  
2021 ◽  
Vol 21 (9) ◽  
pp. 3151
Author(s):  
Shuo Yang ◽  
Bin Wu ◽  
Xiucheng Liu ◽  
Mingzhi Li ◽  
Heying Wang ◽  
...  
Keyword(s):  
Energy Harvesting ◽  
Spherical Particle ◽  
Impact Energy ◽  
Energy Harvester ◽  
Composite Particle ◽  
Piezoelectric Energy Harvesting ◽  
Particle Chain ◽  
Piezoelectric Energy ◽  
Self Powered ◽  
Particle Chains

In this study, a novel piezoelectric energy harvester (PEH) based on the array composite spherical particle chain was constructed and explored in detail through simulation and experimental verification. The power test of the PEH based on array composite particle chains in the self-powered system was realized. Firstly, the model of PEH based on the composite spherical particle chain was constructed to theoretically realize the collection, transformation, and storage of impact energy, and the advantages of a composite particle chain in the field of piezoelectric energy harvesting were verified. Secondly, an experimental system was established to test the performance of the PEH, including the stability of the system under a continuous impact load, the power adjustment under different resistances, and the influence of the number of particle chains on the energy harvesting efficiency. Finally, a self-powered supply system was established with the PEH composed of three composite particle chains to realize the power supply of the microelectronic components. This paper presents a method of collecting impact energy based on particle chain structure, and lays an experimental foundation for the application of a composite particle chain in the field of piezoelectric energy harvesting.

The Microscopic Structure Of Shallow Donors In Silicon Carbide

1996 ◽  
Vol 442 ◽  
Author(s):  
J.-M. Spaeth ◽  
S. Greulich-Weber ◽  
M. März ◽  
E. N. Kalabukhova ◽  
S. N. Lukin
Keyword(s):  
High Temperature ◽  
Low Temperature ◽  
Temperature Dependence ◽  
Double Resonance ◽  
Epr Spectra ◽  
Electron Nuclear Double Resonance ◽  
Paramagnetic Resonance ◽  
Vacancy Pair ◽  
Temperature Spectra ◽  
Electron Paramagnetic

AbstractThe electronic structure of nitrogen donors in 6H-, 4H- and 3C-SiC is investigated by measuring the nitrogen hyperfine (hf) interactions with electron nuclear double resonance (ENDOR) and the temperature dependence of the hf split electron paramagnetic resonance (EPR) spectra. Superhyperfine (shf) interactions with many shells of 13C and 29Si were measured in 6H-SiC. The hf and shf interactions are discussed in the framework of effective mass theory. The temperature dependence is explained with the thermal occupation of the lowest valley-orbit split A1 and E states. It is proposed that the EPR spectra of P donors observed previously in neutron transmuted 6H-SiC at low temperature (<10K) and high temperature (>60K) are all due to substitutional P donors on the two quasi-cubic and hexagonal Si sites, whereby at low temperature the E state is occupied and at high temperature the A1 state. The low temperature spectra are thus thought not to be due to P-vacancy pair defects as proposed previously.

scholarly journals A Self-Powered PMFC-Based Wireless Sensor Node for Smart City Applications

2019 ◽  
Vol 2019 ◽  
pp. 1-10 ◽  
Author(s):  
Daniel Ayala-Ruiz ◽  
Alejandro Castillo Atoche ◽  
Erica Ruiz-Ibarra ◽  
Edith Osorio de la Rosa ◽  
Javier Vázquez Castillo
Keyword(s):  
Energy Harvesting ◽  
Low Power ◽  
Sensor Node ◽  
Smart Cities ◽  
Cloud Services ◽  
Environmental Data ◽  
Security And Privacy ◽  
Wireless Sensor ◽  
Ultra Low Power ◽  
Self Powered

Long power wide area networks (LPWAN) systems play an important role in monitoring environmental conditions for smart cities applications. With the development of Internet of Things (IoT), wireless sensor networks (WSN), and energy harvesting devices, ultra-low power sensor nodes (SNs) are able to collect and monitor the information for environmental protection, urban planning, and risk prevention. This paper presents a WSN of self-powered IoT SNs energetically autonomous using Plant Microbial Fuel Cells (PMFCs). An energy harvesting device has been adapted with the PMFC to enable a batteryless operation of the SN providing power supply to the sensor network. The low-power communication feature of the SN network is used to monitor the environmental data with a dynamic power management strategy successfully designed for the PMFC-based LoRa sensor node. Environmental data of ozone (O3) and carbon dioxide (CO2) are monitored in real time through a web application providing IoT cloud services with security and privacy protocols.

scholarly journals Triboelectric Effect Enabled Self-Powered, Point-of-Care Diagnostics: Opportunities for Developing ASSURED and REASSURED Devices

Micromachines ◽  
2021 ◽  
Vol 12 (3) ◽  
pp. 337
Author(s):  
Navneet Soin ◽  
Sam J. Fishlock ◽  
Colin Kelsey ◽  
Suzanne Smith
Keyword(s):  
High Efficiency ◽  
Resource Constraints ◽  
Point Of Care ◽  
Wearable Sensors ◽  
Middle Income ◽  
Physiological Signal ◽  
Point Of Care Diagnostics ◽  
Self Powered ◽  
Triboelectric Nanogenerators ◽  
Triboelectric Effect

The use of rapid point-of-care (PoC) diagnostics in conjunction with physiological signal monitoring has seen tremendous progress in their availability and uptake, particularly in low- and middle-income countries (LMICs). However, to truly overcome infrastructural and resource constraints, there is an urgent need for self-powered devices which can enable on-demand and/or continuous monitoring of patients. The past decade has seen the rapid rise of triboelectric nanogenerators (TENGs) as the choice for high-efficiency energy harvesting for developing self-powered systems as well as for use as sensors. This review provides an overview of the current state of the art of such wearable sensors and end-to-end solutions for physiological and biomarker monitoring. We further discuss the current constraints and bottlenecks of these devices and systems and provide an outlook on the development of TENG-enabled PoC/monitoring devices that could eventually meet criteria formulated specifically for use in LMICs.

Sign in / Sign up

Export Citation Format

Share Document