Vibrationally resolved inelastic scattering and charge transfer in H+–C2H4 collisions

1993 ◽  
Vol 99 (4) ◽  
pp. 2682-2694 ◽  
Author(s):  
N. Aristov ◽  
W. Maring ◽  
G. Niedner‐Schatteburg ◽  
J. P. Toennies ◽  
Y.‐N. Chiu ◽  
...  
Keyword(s):  
Charge Transfer ◽  
Inelastic Scattering

Vibrationally resolved inelastic scattering and charge transfer in H+ +C2H2 collisions

1991 ◽  
Vol 95 (11) ◽  
pp. 7969-7983 ◽  
Author(s):  
Natasha Aristov ◽  
Gereon Niedner‐Schatteburg ◽  
J. Peter Toennies ◽  
Ying‐Nan Chiu
Keyword(s):  
Charge Transfer ◽  
Inelastic Scattering

Core-hole induced charge transfer and Coster-Kronig enhanced fluorescence at the3dthreshold of lanthanum studied by resonant inelastic scattering

1998 ◽  
Vol 58 (24) ◽  
pp. R15951-R15954 ◽  
Author(s):  
A. Moewes ◽  
S. Stadler ◽  
R. P. Winarski ◽  
D. L. Ederer ◽  
M. M. Grush ◽  
...  
Keyword(s):  
Charge Transfer ◽  
Inelastic Scattering ◽  
Enhanced Fluorescence ◽  
Core Hole ◽  
Induced Charge

Analysis of STEM micrographs of thick objects

1978 ◽  
Vol 36 (2) ◽  
pp. 106-107
Author(s):  
S. Golladay
Keyword(s):  
Inelastic Scattering ◽  
Multiple Scattering ◽  
Mass Distribution ◽  
Cross Sections ◽  
Phase Contrast ◽  
Image Point ◽  
Contrast Effects ◽  
Total Cross Sections ◽  
Elastic And Inelastic Scattering

The theory of multiple scattering has been worked out by Groves and comparisons have been made between predicted and observed signals for thick specimens observed in a STEM under conditions where phase contrast effects are unimportant. Independent measurements of the collection efficiencies of the two STEM detectors, calculations of the ratio σe/σi = R, where σe, σi are the total cross sections for elastic and inelastic scattering respectively, and a model of the unknown mass distribution are needed for these comparisons. In this paper an extension of this work will be described which allows the determination of the required efficiencies, R, and the unknown mass distribution from the data without additional measurements or models. Essential to the analysis is the fact that in a STEM two or more signal measurements can be made simultaneously at each image point.

Study of charge transfer in FeTi

1983 ◽  
Vol 41 ◽  
pp. 296-297
Author(s):  
J. Taft∅
Keyword(s):  
Charge Transfer ◽  
Charge Distribution ◽  
Electron Scattering ◽  
Periodic System ◽  
Electron Distribution ◽  
Scattering Amplitude ◽  
Transition Elements ◽  
Hartree Fock ◽  
Cscl Structure ◽  
The Right

It is well known that for reflections corresponding to large interplanar spacings (i.e., sin θ/λ small), the electron scattering amplitude, f, is sensitive to the ionicity and to the charge distribution around the atoms. We have used this in order to obtain information about the charge distribution in FeTi, which is a candidate for storage of hydrogen. Our goal is to study the changes in electron distribution in the presence of hydrogen, and also the ionicity of hydrogen in metals, but so far our study has been limited to pure FeTi. FeTi has the CsCl structure and thus Fe and Ti scatter with a phase difference of π into the 100-ref lections. Because Fe (Z = 26) is higher in the periodic system than Ti (Z = 22), an immediate “guess” would be that Fe has a larger scattering amplitude than Ti. However, relativistic Hartree-Fock calculations show that the opposite is the case for the 100-reflection. An explanation for this may be sought in the stronger localization of the d-electrons of the first row transition elements when moving to the right in the periodic table. The tabulated difference between fTi (100) and ffe (100) is small, however, and based on the values of the scattering amplitude for isolated atoms, the kinematical intensity of the 100-reflection is only 5.10-4 of the intensity of the 200-reflection.

Temperature Dependence of the Critical Electron Dose for Fatty Acid Monolayers

1982 ◽  
Vol 40 ◽  
pp. 78-79
Author(s):  
Kenneth H. Downing ◽  
Robert M. Glaeser
Keyword(s):  
Electron Beam ◽  
Fatty Acid ◽  
Inelastic Scattering ◽  
Temperature Dependence ◽  
Structural Damage ◽  
Direct Result ◽  
Second Step ◽  
Strong Temperature Dependence ◽  
Electron Dose ◽  
Covalent Bonds

The structural damage of molecules irradiated by electrons is generally considered to occur in two steps. The direct result of inelastic scattering events is the disruption of covalent bonds. Following changes in bond structure, movement of the constituent atoms produces permanent distortions of the molecules. Since at least the second step should show a strong temperature dependence, it was to be expected that cooling a specimen should extend its lifetime in the electron beam. This result has been found in a large number of experiments, but the degree to which cooling the specimen enhances its resistance to radiation damage has been found to vary widely with specimen types.

The Resolution and Contrast in Biological Sections Determined by Inelastic and Elastic Scattering

1973 ◽  
Vol 31 ◽  
pp. 224-225
Author(s):  
D. L. Misell
Keyword(s):  
Electron Microscopy ◽  
Adverse Effect ◽  
Elastic Scattering ◽  
Inelastic Scattering ◽  
Amorphous Carbon ◽  
Polymeric Materials ◽  
Chromatic Aberration ◽  
Image Resolution ◽  
Quantitative Estimates ◽  
Elastic Ratio

In the electron microscopy of biological sections the adverse effect of chromatic aberration on image resolution is well known. In this paper calculations are presented for the inelastic and elastic image intensities using a wave-optical formulation. Quantitative estimates of the deterioration in image resolution as a result of chromatic aberration are presented as an alternative to geometric calculations. The predominance of inelastic scattering in the unstained biological and polymeric materials is shown by the inelastic to elastic ratio, I/E, within an objective aperture of 0.005 rad for amorphous carbon of a thickness, t=50nm, typical of biological sections; E=200keV, I/E=16.

Resolving Crystallites in Zirconium Oxide Films

1969 ◽  
Vol 27 ◽  
pp. 140-141
Author(s):  
R.A. Ploc
Keyword(s):  
Electron Microscope ◽  
Inelastic Scattering ◽  
Zirconium Oxide ◽  
Oxide Films ◽  
Optic Axis ◽  
Objective Lens ◽  
Microscope Objective ◽  
Linear Optic ◽  
A Current ◽  
Microscope Objective Lens

The optic axis of an electron microscope objective lens is usually assumed to be straight and co-linear with the mechanical center. No reason exists to assume such perfection and, indeed, simple reasoning suggests that it is a complicated curve. A current centered objective lens with a non-linear optic axis when used in conjunction with other lenses, leads to serious image errors if the nature of the specimen is such as to produce intense inelastic scattering.

An Environmental Wet Cell For High Voltage Electron Microscopy

1973 ◽  
Vol 31 ◽  
pp. 18-19
Author(s):  
N.J. Tighe ◽  
H.M. Flower ◽  
P.R. Swann
Keyword(s):  
Electron Microscopy ◽  
High Temperature ◽  
Image Quality ◽  
Inelastic Scattering ◽  
High Voltage ◽  
High Voltage Electron Microscopy ◽  
Voltage Electron ◽  
Environmental Cell ◽  
Water Saturated ◽  
High Temperature Gas

A differentially pumped environmental cell has been developed for use in the AEI EM7 million volt microscope. In the initial version the column of gas traversed by the beam was 5.5mm. This permited inclusion of a tilting hot stage in the cell for investigating high temperature gas-specimen reactions. In order to examine specimens in the wet state it was found that a pressure of approximately 400 torr of water saturated helium was needed around the specimen to prevent dehydration. Inelastic scattering by the water resulted in a sharp loss of image quality. Therefore a modified cell with an ‘airgap’ of only 1.5mm has been constructed. The shorter electron path through the gas permits examination of specimens at the necessary pressure of moist helium; the specimen can still be tilted about the side entry rod axis by ±7°C to obtain stereopairs.

The effect of temperature on high-resolution TEM image contrast

1995 ◽  
Vol 53 ◽  
pp. 640-641
Author(s):  
T. Geipel ◽  
W. Mader ◽  
P. Pirouz
Keyword(s):  
Form Factor ◽  
Inelastic Scattering ◽  
Accurate Method ◽  
Waller Factor ◽  
Effect Of Temperature ◽  
Specimen Thickness ◽  
Influence Of Temperature ◽  
Debye Waller Factor ◽  
Influence Of Temperature On ◽  
Atomic Form Factor

Temperature affects both elastic and inelastic scattering of electrons in a crystal. The Debye-Waller factor, B, describes the influence of temperature on the elastic scattering of electrons, whereas the imaginary part of the (complex) atomic form factor, fc = fr + ifi, describes the influence of temperature on the inelastic scattering of electrons (i.e. absorption). In HRTEM simulations, two possible ways to include absorption are: (i) an approximate method in which absorption is described by a phenomenological constant, μ, i.e. fi; - μfr, with the real part of the atomic form factor, fr, obtained from Hartree-Fock calculations, (ii) a more accurate method in which the absorptive components, fi of the atomic form factor are explicitly calculated. In this contribution, the inclusion of both the Debye-Waller factor and absorption on HRTEM images of a (Oll)-oriented GaAs crystal are presented (using the EMS software.Fig. 1 shows the the amplitudes and phases of the dominant 111 beams as a function of the specimen thickness, t, for the cases when μ = 0 (i.e. no absorption, solid line) and μ = 0.1 (with absorption, dashed line).

Sign in / Sign up

Export Citation Format

Share Document