Structural studies of (tetrathiotetracene)2(iodide)3 at room temperature and low temperatures

1981 ◽  
Vol 74 (3) ◽  
pp. 1966-1979 ◽  
Author(s):  
C. Lowe‐Ma ◽  
R. Williams ◽  
S. Samson
Keyword(s):  
Low Temperatures ◽  
Room Temperature ◽  
Structural Studies

scholarly journals Review of Multi-Physics Modeling on the Active Magnetic Regenerative Refrigeration

2021 ◽  
Vol 26 (2) ◽  
pp. 47
Author(s):  
Julien Eustache ◽  
Antony Plait ◽  
Frédéric Dubas ◽  
Raynal Glises
Keyword(s):  
Magnetic Field ◽  
Low Temperatures ◽  
Room Temperature ◽  
State Of The Art ◽  
Vapor Compression ◽  
Crucial Step ◽  
Potential Alternative ◽  
Vapor Compression Refrigeration ◽  
Preliminary Study ◽  
Physics Modeling

Compared to conventional vapor-compression refrigeration systems, magnetic refrigeration is a promising and potential alternative technology. The magnetocaloric effect (MCE) is used to produce heat and cold sources through a magnetocaloric material (MCM). The material is submitted to a magnetic field with active magnetic regenerative refrigeration (AMRR) cycles. Initially, this effect was widely used for cryogenic applications to achieve very low temperatures. However, this technology must be improved to replace vapor-compression devices operating around room temperature. Therefore, over the last 30 years, a lot of studies have been done to obtain more efficient devices. Thus, the modeling is a crucial step to perform a preliminary study and optimization. In this paper, after a large introduction on MCE research, a state-of-the-art of multi-physics modeling on the AMRR cycle modeling is made. To end this paper, a suggestion of innovative and advanced modeling solutions to study magnetocaloric regenerator is described.

scholarly journals On the measurement of the ratio of the specific heats using small volumes of gas.—The ratios of the specific heat of air and of hydrogen at atmospheric pressure and a temperatures between 20°C. and —183°C

1925 ◽  
Vol 107 (743) ◽  
pp. 510-543 ◽  
Keyword(s):  
Systematic Error ◽  
Low Temperatures ◽  
Room Temperature ◽  
Expansion Chamber ◽  
Small Vessels ◽  
Specific Heats ◽  
Large Expansion ◽  
Before And After ◽  
The One ◽  
Chamber Capacity

Introduction .—In nearly all the previous determinations of the ratio of the specific heats of gases, from measurements of the pressures and temperature before and after an adiabatic expansion, large expansion chambers of fror 50 to 130 litres capacity have been used. Professor Callendar first suggests the use of smaller vessels, and in 1914, Mercer (‘Proc. Phys. Soc.,’ vol. 26 p. 155) made some measurements with several gases, but at room temperature only, using volumes of about 300 and 2000 c. c. respectively. He obtained values which indicated that small vessels could be used, and that, with proper corrections, a considerable degree of accuracy might be obtained. The one other experimenter who has used a small expansion chamber, capacity about 1 litre, is M. C. Shields (‘Phys. Rev.,’ 1917), who measured this ratio for air and for hydrogen at room temperature, about 18° C., and its value for hydroger at — 190° C. The chief advantage gained by the use of large expansion chambers is that no correction, or at the most, a very small one, has to be made for any systematic error due to the size of the containing vessels, but it is clear that, in the determinations of the ratio of the specific heats of gases at low temperatures, the use of small vessels becomes a practical necessity in order that uniform and steady temperature conditions may be obtained. Owing, however, to the presence of a systematic error depending upon the dimensions of the expansion chamber, the magnitude of which had not been definitely settled by experiment, the following work was undertaken with the object of investigating the method more fully, especially with regard to it? applicability to the determination of this ratio at low temperatures.

scholarly journals The behaviour of visual purple at low temperature

1941 ◽  
Vol 179 (977) ◽  
pp. 151-159 ◽  
Keyword(s):  
Aqueous Solution ◽  
Low Temperature ◽  
Low Temperatures ◽  
Room Temperature ◽  
Absorption Curve ◽  
Quantum Yields

Visual purple is soluble and stable in a mixture of glycerol and water (3:1). At room temperature the spectrum of such a solution is identical with that of the aqueous solution. At — 73° C the peak of the absorption curve is higher and narrower than at room temperature, and it is shifted towards longer waves. The product of photodecomposition at — 73° C has a spectrum in ­ dependent of pH and is at low temperatures thermostable and photostable, but at room temperature it decomposes therm ally to indicator yellow. The primary product appears to be identical with transient orange. The quantum yields of the photoreaction at low and at room temperature are of the same order.

Magnetic Properties of Sputtered Fe-O and Co-O Thin Films

1995 ◽  
Vol 403 ◽  
Author(s):  
D. V. Dimitrov ◽  
A. S. Murthy ◽  
G. C. Hadjipanayis ◽  
C. P. SWANN
Keyword(s):  
Grain Size ◽  
Low Temperatures ◽  
Room Temperature ◽  
Oxide Films ◽  
X Ray Diffraction ◽  
Dc Magnetron Sputtering ◽  
Large Shift ◽  
X Ray ◽  
Grain Size And Shape ◽  
Spherical Grains

AbstractFe-O and Co-O films were prepared by DC magnetron sputtering in a mixture of Ar and O2 gases. By varying the oxygen to argon ratio, oxide films with stoichiometry FeO, Fe3O4, α-Fe2O3, CoO and Co3O4 were produced. TEM studies showed that the Fe – oxide films were polycrystalline consisting of small almost spherical grains, about 10 nm in size. Co-O films had different microstructure with grain size and shape dependent on the amount of oxygen. X-ray diffraction studies showed that the grains in Fe-O films were randomly oriented in contrast to Co-O films in which a <111> texture was observed. Pure FeO and α-Fe2O3 films were found to be superparamagnetic at room temperature but strongly ferromagnetic at low temperatures in contrast to the antiferromagnetic nature of bulk samples. A very large shift in the hysteresis loop, about 3800 Oe, was observed in field cooled Co-CoO films indicating the presence of a large unidirectional exchange anisotropy.

scholarly journals Comparison of preservation methods of Atta spp. (Hymenoptera: Formicidae) for RAPD analysis

2000 ◽  
Vol 29 (3) ◽  
pp. 489-496 ◽  
Author(s):  
Alfredo O. R. Carvalho ◽  
Luiz G. E. Vieira
Keyword(s):  
Silica Gel ◽  
Low Temperatures ◽  
Room Temperature ◽  
Rapd Analysis ◽  
Limiting Factors ◽  
Dna Yield ◽  
Remote Locations ◽  
Leaf Cutting ◽  
Storage Methods ◽  
Plot Design

High quality DNA for molecular studies can be easily extracted from fresh specimens. However, live samples are difficult to keep for long periods thus making their preservation a serious problem, specially when they are collected and transported from remote locations. In order to establish an efficient method to preserve Atta spp. (leaf-cutting ants) for RAPD analysis, six different storage methods were examined: 1) -70°C; 2) 95% ethanol at -20°C; 3) 95% ethanol at 4°C; 4) 95% ethanol at room temperature; 5) silica gel at room temperature; and 6) buffer (0.25 M EDTA, 2.5% SDS, 0.5 M Tris-HCl, pH 9.2) at room temperature. DNA was extracted (Cheung et al., 1993 - modified) and examined after 90, 210 and 360 days of storage. Freshly killed specimens were used as control. DNA yield was measured with a minifluorometer. DNA quality was determined by scanning photographs with a densitometer and the integral of the scan was calculated for DNA of size > 9.4 kb. Data were analyzed using a completely randomized split-plot design with four replicates. All methods were efficient to preserve Atta spp. DNA up to 210 days. At 360 days, DNA was degraded only in 95% ethanol at room temperature, which resulted in RAPD profiles with missing bands. Although preservation at low temperatures is recommended for long periods, methods using silica gel and buffer can be considered satisfactory alternatives when refrigeration and transportation are limiting factors.

scholarly journals The principal magnetic susceptibilities of neodymium sulphate octahydrate at low temperatures

1939 ◽  
Vol 170 (941) ◽  
pp. 266-271 ◽  
Keyword(s):  
Low Temperatures ◽  
Room Temperature ◽  
Energy Levels ◽  
Constant Factor ◽  
The Other ◽  
Crystalline Field ◽  
Cubic Symmetry ◽  
The Subject ◽  
The Difference ◽  
The One

The magnetic and other related properties of neodymium sulphate have been the subject of numerous investigations in recent years, but there is still a remarkable conflict of evidence on all the essential points. The two available determinations of the susceptibility of the powdered salt at low temperatures, those of Gorter and de Haas (1931) from 290 to 14° K and of Selwood (1933) from 343 to 83° K both fit the expression X ( T + 45) = constant over the range of temperature common to both, but the constants are not the same and the susceptibilities at room temperature differ by 11%. The fact that the two sets of results can be converted the one into the other by multiplying throughout by a constant factor suggested that the difference in the observed susceptibilities was due to some error of calibration. It could, however, also be due to the different purity of the samples examined though the explanation of the occurrence of the constant factor is then by no means obvious. From their analysis of the absorption spectrum of crystals of neodymium sulphate octahydrate Spedding and others (1937) conclude that the crystalline field around the Nd+++ ion is predominantly cubic in character since they find three energy levels at 0, 77 and 260 cm. -1 .* Calculations of the susceptibility from these levels reproduce Selwood’s value at room temperature but give no agreement with the observations-at other temperatures. On the other hand, Penney and Schlapp (1932) have shown that Gorter and de Haas’s results fit well on the curve calculated for a crystalline field of cubic symmetry and such a strength that the resultant three levels lie at 0, 238 and 834 cm. -1 , an overall spacing almost three times as great as Spedding’s.

Unterscheidung von Stickstoff- und Phosphor-Inversion, Rotation um die N-P-Bindung und Ligandenaustausch am Phosphor

1968 ◽  
Vol 23 (6) ◽  
pp. 759-766 ◽  
Author(s):  
D. Imbery ◽  
H. Friebolin
Keyword(s):  
Low Temperatures ◽  
Room Temperature ◽  
Nitrogen Inversion ◽  
Kinetic Processes ◽  
Derivatives Of

A large number of aminophosphines were prepared to study the kinetic processes. It could be shown that at room temperature there is rapid nitrogen-inversion but slow phosphorous-inversion. At higher temperatures ( + 80 °C), a rapid chlorine-exchange takes place with inversion of configuration at phosphorous. At low temperatures ( — 80 °C), rotation around the N-P-bond was slow. A dependence of the barrier of rotation on the size of the substituents could be recognized. It is possible that pπ-dπ-bonding is partially responsible for the relatively high barrier of rotation compared with derivatives of ethane and hydrazine.

Crystallochemistry and structural studies of two newly CaSb0.50Fe1.50(PO4)3 and Ca0.50SbFe(PO4)3 Nasicon phases

2006 ◽  
Vol 21 (1) ◽  
pp. 45-51 ◽  
Author(s):  
Abderrahim Aatiq ◽  
My Rachid Tigha ◽  
Rabia Hassine ◽  
Ismael Saadoune
Keyword(s):  
Solid State ◽  
Room Temperature ◽  
Rietveld Analysis ◽  
Structural Studies ◽  
Hexagonal Cell ◽  
Conventional Solid State Reaction ◽  
Space Group ◽  
X Ray ◽  
Cell Parameters ◽  
Crystallographic Structures

Crystallographic structures of two new orthophosphates Ca0.50SbFe(PO4)3 and CaSb0.50Fe1.50(PO4)3 obtained by conventional solid state reaction techniques at 900 °C, were determined at room temperature from X-ray powder diffraction using Rietveld analysis. The two compounds belong to the Nasicon structural family. The space group is R3 for Ca0.50SbFe(PO4)3 and R3c for CaSb0.50Fe1.50(PO4)3. Hexagonal cell parameters for Ca0.50SbFe(PO4)3 and CaSb0.50Fe1.50(PO4)3 are: a=8.257(1) Å, c=22.276(2) Å, and a=8.514(1) Å, c=21.871(2) Å, respectively. Ca2+ and vacancies in {[Ca0.50]3a[◻0.50]3b}M1SbFe(PO4)3 are ordered within the two positions, 3a and 3b, of M1 sites. Structure refinements show also a quasi-ordered distribution of Sb5+ and Fe3+ ions within the Nasicon framework. Thus, in {[Ca0.50]3a[◻0.50]3b}M1SbFe(PO4)3, each Ca(3a)O6 octahedron shares two faces with two Fe3+O6 octahedra and each vacancy (◻(3b)O6) site is located between two Sb5+O6 octahedra. In [Ca]M1Sb0.50Fe1.50(PO4)3 compound (R3c space group), all M1 sites are occupied by Ca2+ and the Sb5+ and Fe3+ ions are randomly distributed within the Nasicon framework.

Sign in / Sign up

Export Citation Format

Share Document