Patterning graphene nanoribbons using copper oxide nanowires

2012 ◽  
Vol 100 (10) ◽  
pp. 103106 ◽  
Author(s):  
Alexander Sinitskii ◽  
James M. Tour
Keyword(s):  
Copper Oxide ◽  
Graphene Nanoribbons ◽  
Oxide Nanowires

On the growth of copper oxide nanowires by thermal oxidation near the threshold temperature at atmospheric pressure

2021 ◽  
pp. 161130
Author(s):  
Calin Constantin Moise ◽  
Laura-Bianca Enache ◽  
Veronica Anastasoaie ◽  
Oana Andreea Lazar ◽  
Geanina Valentina Mihai ◽  
...  
Keyword(s):  
Copper Oxide ◽  
Thermal Oxidation ◽  
Atmospheric Pressure ◽  
Threshold Temperature ◽  
Oxide Nanowires

scholarly journals Fabrication of temperature sensor based on copper oxide nanowires grown on titanium coated glass substrate

2018 ◽  
Vol 36 (3) ◽  
pp. 460-468 ◽  
Author(s):  
Ali A. Aljubouri ◽  
Abdulqader D. Faisal ◽  
Wafaa K. Khalef
Keyword(s):  
Copper Oxide ◽  
Temperature Sensor ◽  
Glass Substrate ◽  
Physical Vapor Deposition ◽  
Copper Film ◽  
High Sensitivity ◽  
Infrared Thermal Imaging ◽  
Oxide Nanowires ◽  
Vapor Deposition Technique ◽  
Physical Vapor Deposition Technique

AbstractSingle phase, adherent films of copper oxide nanowires (CuO NWs) were successfully grown on a glass substrate. Titanium nanofilm was pre-coated on the glass substrate to assist the growth of a layer adherent to the substrate. The copper film of 1.5 μm thickness was deposited via physical vapor deposition technique followed by thermal oxidation in air at various temperatures for 4 h. The product was characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), ultraviolet-visible (UV-Vis) and Fourier transformation infrared (FT-IR) spectroscopy to find the crystal structure, morphology, phases, and optical properties of the deposited films. The CuO NWs film with 60% transmittance at wavelengths greater than 800 nm was obtained. It can be used as an infrared thermal imaging filter and in optoelectronic devices. The fabricated temperature sensor exhibited high sensitivity in the temperature range of 20 °C to 180 °C.

scholarly journals Electrical, structural, and photocatalytic properties of copper oxide nanowire

2020 ◽  
Vol 44 (7-8) ◽  
pp. 471-474
Author(s):  
Azadeh Jafari ◽  
SAA Terohid ◽  
Alireza Kokabi ◽  
Amir Moradiani
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Copper Oxide ◽  
Growth Temperature ◽  
Photocatalytic Properties ◽  
X Ray Diffraction ◽  
Direct Oxidation ◽  
Oxide Nanowires ◽  
X Ray ◽  
Scanning Electron

Using a direct oxidation method in a horizontal quartz tube, copper oxide nanowires are grown on a Cu substrate. In order to investigate the growth temperature effects on the structural, morphological, electrical, and photocatalytic properties of the copper oxide nanowires, X-ray diffraction, scanning electron microscopy, a KEITHLEY 2361 system, and a homemade photoreactor are used. The X-ray diffraction results show that both CuO and Cu2O phases are formed, and while increasing the growth temperature, the crystallinity is improved and the intensity of most of the diffraction peaks increases. The scanning electron microscopy images at different growth temperatures show that the number, density, and length of the copper oxide nanowires on pre-formed micro-scaled grains increase, when the growth temperature increases to 700°C and sharper nanowires with average diameters of 1–3 µm grow on the surface. Also I–V curves show that by raising the growth temperature, the conductivity of the samples increases. In addition, the photocatalytic activities are studied by photocatalytic degradation of Congo red dye, and based on these results, the sample grown at 700°C with the highest number and density of the nanowires showed the best photocatalytic performance and electrical conductivity. The results can be used to guide better understanding of the growth behavior of copper oxide nanowires and can be useful for the development of novel photocatalytic nanodevices.

scholarly journals Ultraviolet Light-Assisted Copper Oxide Nanowires Hydrogen Gas Sensor

2018 ◽  
Vol 13 (1) ◽  
Author(s):  
Nabihah Sihar ◽  
Teck Yaw Tiong ◽  
Chang Fu Dee ◽  
Poh Choon Ooi ◽  
Azrul Azlan Hamzah ◽  
...  
Keyword(s):  
Copper Oxide ◽  
Gas Sensor ◽  
Ultraviolet Light ◽  
Hydrogen Gas ◽  
Oxide Nanowires

Synthesis of copper oxalate in ether–water bilayer refluxing system and their conversion to copper oxide nanowires

2009 ◽  
Vol 63 (29) ◽  
pp. 2560-2563 ◽  
Author(s):  
Ni Liang ◽  
Wang Lei ◽  
Shao Bing ◽  
Wang Yinjue ◽  
Zhang Wenli ◽  
...  
Keyword(s):  
Copper Oxide ◽  
Oxide Nanowires ◽  
Copper Oxalate

Copper oxide nanowires: a review of growth

2012 ◽  
Vol 23 (19) ◽  
pp. 194001 ◽  
Author(s):  
G Filipič ◽  
U Cvelbar
Keyword(s):  
Copper Oxide ◽  
Oxide Nanowires

Enhanced antibacterial activity of copper/copper oxide nanowires prepared by pulsed laser ablation in water medium

2016 ◽  
Vol 122 (7) ◽  
Author(s):  
R. K. Swarnkar ◽  
J. K. Pandey ◽  
K. K. Soumya ◽  
P. Dwivedi ◽  
S. Sundaram ◽  
...  
Keyword(s):  
Antibacterial Activity ◽  
Laser Ablation ◽  
Copper Oxide ◽  
Pulsed Laser ◽  
Pulsed Laser Ablation ◽  
Water Medium ◽  
Oxide Nanowires

scholarly journals Physical Vapor Deposition of Copper Oxide Nanowires

2010 ◽  
Vol 5 ◽  
pp. 1051-1054 ◽  
Author(s):  
E. Comini ◽  
G. Faglia ◽  
M. Ferroni ◽  
D. Zappa ◽  
G. Sberveglieri
Keyword(s):  
Copper Oxide ◽  
Vapor Deposition ◽  
Physical Vapor Deposition ◽  
Oxide Nanowires
Sign in / Sign up

Export Citation Format

Share Document