An ultra-low-noise, low-frequency, six degrees of freedom active vibration isolator

1997 ◽  
Vol 68 (8) ◽  
pp. 3211-3219 ◽  
Author(s):  
D. B. Newell ◽  
S. J. Richman ◽  
P. G. Nelson ◽  
R. T. Stebbins ◽  
P. L. Bender ◽  
...  
2014 ◽  
Vol 494-495 ◽  
pp. 491-496
Author(s):  
Hua Ping Mei ◽  
Hao Yue Tian ◽  
Shuan Huang

The vibration isolators have witnessed significant developments due to pressing demands for high resolution metrology and manufacturing, optical, physical and chemical experiments. In the view of these requirements, the engineers and physicists have exploited different types of vibration isolators. This paper firstly presents the recent developments on the passive vibration isolators. It finds that the passive vibration isolators can constrain the high frequency oscillation. The active control is the efficient method to cancel the low frequency vibration. Then, the paper is concerned with the recent advances on the active vibration isolator. The appropriate actuator, sensor and advanced control method are the key component of the active vibration isolator to enhance their vibration isolation properties. Finally, the author proposes that the magnetic suspension vibration isolator is a future research direction in the field of the vibration isolation.


2014 ◽  
Vol 568 (3) ◽  
pp. 032009 ◽  
Author(s):  
Y Jin ◽  
Q Dong ◽  
Y X Liang ◽  
A Cavanna ◽  
U Gennser ◽  
...  

ACTA IMEKO ◽  
2020 ◽  
Vol 9 (5) ◽  
pp. 374
Author(s):  
Henrik Ingerslev ◽  
Soren Andresen ◽  
Jacob Holm Winther

The demand from industry to produce accurate acceleration measurements down to ever lower frequencies and with ever lower noise is increasing. Different vibration transducers are used today for many different purposes within this area, like detection and warning for earthquakes, detection of nuclear testing, and monitoring of the environment. Accelerometers for such purposes must be calibrated in order to yield trustworthy results and provide traceability to the SI-system accordingly. For these calibrations to be feasible, suitable ultra low-noise accelerometers and/or signal processing functions are needed. <br />Here we present two digital signal processing (DSP) functions designed to measure ultra low-noise acceleration in calibration systems. The DSP functions use dual channel signal analysis on signals from two accelerometers measuring the same stimuli and use the coherence between the two signals to reduce noise. Simulations show that the two DSP functions are estimating calibration signals better than the standard analysis. <br />The results presented here are intended to be used in key comparison studies of accelerometer calibration systems, and may help extend current general low frequency range from e.g. 100 mHz down to ultra-low frequencies of around 10mHz, possibly using somewhat same instrumentation.


Author(s):  
Toshiyuki Suzuki ◽  
Koji Tanida ◽  
Akira Tanji ◽  
Koichi Okubo

Abstract An active vibration isolation system, under development for use in microgravity environment, provides electromagnetic suspension by means of voice coils arranged in pairs to control the translational and rotational movements of the payload, three pairs of which cover the three axes to ensure control of payload movement in all six degrees of freedom. A series of tests performed on this system in microgravity environment created by parabolic flight proved that external disturbances in frequencies above 0.1 Hz were effectively reduced by applying the system. Also, good agreement was obtained between the measured performance and results of numerical simulation.


2017 ◽  
Vol 139 (3) ◽  
Author(s):  
Jiaxi Zhou ◽  
Kai Wang ◽  
Daolin Xu ◽  
Huajiang Ouyang ◽  
Yingli Li

A platform supported by a hexapod of quasi-zero-stiffness (QZS) struts is proposed to provide a solution for low-frequency vibration isolation in six degrees-of-freedom (6DOFs). The QZS strut is developed by combining a pair of mutually repelling permanent magnets in parallel connection with a coil spring. Dynamic analysis of the 6DOFs QZS platform is carried out to obtain dynamic responses by using the harmonic balance method, and the vibration isolation performance in each DOF is evaluated in terms of force/moment transmissibility, which indicates that the QZS platform perform a good function of low-frequency vibration isolation within broad bandwidth, and has notable advantages over its linear counterpart in all 6DOFs.


Sign in / Sign up

Export Citation Format

Share Document