Intensified photodiode array applied to one‐dimensional auroral imaging

1985 ◽  
Vol 56 (1) ◽  
pp. 116-120 ◽  
Author(s):  
Åke Steen
Keyword(s):  
One Dimensional ◽  
Photodiode Array ◽  
Auroral Imaging

scholarly journals Micro-Optoelectromechanical Tilt Sensor

2008 ◽  
Vol 2008 ◽  
pp. 1-7 ◽  
Author(s):  
Timothy G. Constandinou ◽  
Julius Georgiou
Keyword(s):  
Rigid Body ◽  
Tilt Angle ◽  
Optical Sensor ◽  
Sensor Surface ◽  
One Dimensional ◽  
Hybrid Cmos ◽  
Cmos Mems ◽  
Photodiode Array ◽  
Tilt Sensor

This paper presents a novel hybrid CMOS/MEMS tilt sensor with a5∘resolution over a300∘range. The device uses a MEMS-based semicircular mass suspended from a rigid body, projecting a shadow onto the CMOS-based optical sensor surface. A one-dimensional photodiode array arranged as a uniformly segmented ring is then used to determine the tilt angle by detecting the position of the semicircular mass. The complete sensor occupies an area of under 2.5 mm×2.5 mm.

One Dimensional Imaging Of High PRF Excimer Laser Beam With Photodiode Array

1987 ◽  
Author(s):  
PH. C. Delaporte ◽  
B. M. Forestier ◽  
M. L. Sentis ◽  
B. L. Fontaine
Keyword(s):  
Laser Beam ◽  
Excimer Laser ◽  
One Dimensional ◽  
Photodiode Array

A one-dimensional self-gravitating stellar gas

1966 ◽  
Vol 25 ◽  
pp. 46-48 ◽  
Author(s):  
M. Lecar
Keyword(s):  
Gravitational Field ◽  
Phase Space ◽  
Motion Picture ◽  
Space Distribution ◽  
Two Dimensional ◽  
One Dimensional ◽  
Phase Space Distribution ◽  
Dimensional Phase Space ◽  
The Mean

“Dynamical mixing”, i.e. relaxation of a stellar phase space distribution through interaction with the mean gravitational field, is numerically investigated for a one-dimensional self-gravitating stellar gas. Qualitative results are presented in the form of a motion picture of the flow of phase points (representing homogeneous slabs of stars) in two-dimensional phase space.

Analysis of electron-diffraction intensity profiles using a photodiode-array detection system

1983 ◽  
Vol 41 ◽  
pp. 322-323
Author(s):  
J. B. Warren
Keyword(s):  
Electron Diffraction ◽  
Diffraction Pattern ◽  
Detection System ◽  
High Energy ◽  
Photographic Emulsion ◽  
Diffraction Intensity ◽  
Silicon Photodiode ◽  
Photodiode Array Detection ◽  
Analog To Digital ◽  
Photodiode Array

Electron diffraction intensity profiles have been used extensively in studies of polycrystalline and amorphous thin films. In previous work, diffraction intensity profiles were quantitized either by mechanically scanning the photographic emulsion with a densitometer or by using deflection coils to scan the diffraction pattern over a stationary detector. Such methods tend to be slow, and the intensities must still be converted from analog to digital form for quantitative analysis. The Instrumentation Division at Brookhaven has designed and constructed a electron diffractometer, based on a silicon photodiode array, that overcomes these disadvantages. The instrument is compact (Fig. 1), can be used with any unmodified electron microscope, and acquires the data in a form immediately accessible by microcomputer.Major components include a RETICON 1024 element photodiode array for the de tector, an Analog Devices MAS-1202 analog digital converter and a Digital Equipment LSI 11/2 microcomputer. The photodiode array cannot detect high energy electrons without damage so an f/1.4 lens is used to focus the phosphor screen image of the diffraction pattern on to the photodiode array.

Electron-Mirror Microscopic Aspects of Ferroelectric Domains of BaTiO3 And Ca2Sr (C2H5CO2)6

1970 ◽  
Vol 28 ◽  
pp. 478-479
Author(s):  
Teruo Someya ◽  
Jinzo Kobayashi
Keyword(s):  
Surface Layer ◽  
Electric Fields ◽  
Quantitative Study ◽  
Recent Progress ◽  
Ferroelectric Domain ◽  
Resolving Power ◽  
Surface Pattern ◽  
Crystal Surfaces ◽  
One Dimensional ◽  
Ferroelectric Domains

Recent progress in the electron-mirror microscopy (EMM), e.g., an improvement of its resolving power together with an increase of the magnification makes it useful for investigating the ferroelectric domain physics. English has recently observed the domain texture in the surface layer of BaTiO3. The present authors ) have developed a theory by which one can evaluate small one-dimensional electric fields and/or topographic step heights in the crystal surfaces from their EMM pictures. This theory was applied to a quantitative study of the surface pattern of BaTiO3).

Structure and function of neural networks in the retina

1988 ◽  
Vol 46 ◽  
pp. 26-27
Author(s):  
Peter Sterling
Keyword(s):  
Ganglion Cells ◽  
Three Dimensional ◽  
Structure And Function ◽  
Synaptic Connections ◽  
Visual Axis ◽  
One Dimensional ◽  
Cat Retina ◽  
Ultrathin Sections ◽  
And Function ◽  
Insight Into

The synaptic connections in cat retina that link photoreceptors to ganglion cells have been analyzed quantitatively. Our approach has been to prepare serial, ultrathin sections and photograph en montage at low magnification (˜2000X) in the electron microscope. Six series, 100-300 sections long, have been prepared over the last decade. They derive from different cats but always from the same region of retina, about one degree from the center of the visual axis. The material has been analyzed by reconstructing adjacent neurons in each array and then identifying systematically the synaptic connections between arrays. Most reconstructions were done manually by tracing the outlines of processes in successive sections onto acetate sheets aligned on a cartoonist's jig. The tracings were then digitized, stacked by computer, and printed with the hidden lines removed. The results have provided rather than the usual one-dimensional account of pathways, a three-dimensional account of circuits. From this has emerged insight into the functional architecture.

Confocal Raman mapping

1992 ◽  
Vol 50 (2) ◽  
pp. 1514-1515
Author(s):  
J. Barbillat ◽  
M. Delhaye ◽  
P. Dhamelincourt
Keyword(s):  
Chemical Species ◽  
Diffraction Limit ◽  
Microscopic Level ◽  
Raman Mapping ◽  
Complete Spectrum ◽  
Laser Illumination ◽  
Ccd Detector ◽  
Raman Microprobe ◽  
Photodiode Array ◽  
Raman Image

Raman mapping, with a spatial resolution close to the diffraction limit, can help to reveal the distribution of chemical species at the surface of an heterogeneous sample.As early as 1975,three methods of sample laser illumination and detector configuration have been proposed to perform Raman mapping at the microscopic level (Fig. 1),:- Point illumination:The basic design of the instrument is a classical Raman microprobe equipped with a PM tube or either a linear photodiode array or a two-dimensional CCD detector. A laser beam is focused on a very small area ,close to the diffraction limit.In order to explore the whole surface of the sample,the specimen is moved sequentially beneath the microscope by means of a motorized XY stage. For each point analyzed, a complete spectrum is obtained from which spectral information of interest is extracted for Raman image reconstruction.- Line illuminationA narrow laser line is focused onto the sample either by a cylindrical lens or by a scanning device and is optically conjugated with the entrance slit of the stigmatic spectrograph.

Intergrowth of modulated structures in high Tc Bi-Sr-Ca-Cu-O superconductors

1990 ◽  
Vol 48 (4) ◽  
pp. 76-77
Author(s):  
A.Q. He ◽  
G.W. Qiao ◽  
J. Zhu ◽  
H.Q. Ye
Keyword(s):  
Twin Structure ◽  
Modulated Structure ◽  
High Tc ◽  
One Dimensional ◽  
Lattice Constants ◽  
Superconducting Phases ◽  
Modulated Structures ◽  
Layer Structures

Since the first discovery of high Tc Bi-Sr-Ca-Cu-O superconductor by Maeda et al, many EM works have been done on it. The results show that the superconducting phases have a type of ordered layer structures similar to that in Y-Ba-Cu-O system formulated in Bi2Sr2Can−1CunO2n+4 (n=1,2,3) (simply called 22(n-1) phase) with lattice constants of a=0.358, b=0.382nm but the length of c being different according to the different value of n in the formulate. Unlike the twin structure observed in the Y-Ba-Cu-O system, there is an incommensurate modulated structure in the superconducting phases of Bi system superconductors. Modulated wavelengths of both 1.3 and 2.7 nm have been observed in the 2212 phase. This communication mainly presents the intergrowth of these two kinds of one-dimensional modulated structures in 2212 phase.

Electronic structure studies of conducting polymers by electron energy-loss spectroscopy

1996 ◽  
Vol 54 ◽  
pp. 160-161
Author(s):  
J. Fink
Keyword(s):  
Electronic Structure ◽  
Conducting Polymers ◽  
Conjugated Polymers ◽  
Electron Acceptors ◽  
Electron Donors ◽  
Light Emitting ◽  
One Dimensional ◽  
New Class ◽  
Electrical Conductivities ◽  
Electron Energy Loss

Conducting polymers comprises a new class of materials achieving electrical conductivities which rival those of the best metals. The parent compounds (conjugated polymers) are quasi-one-dimensional semiconductors. These polymers can be doped by electron acceptors or electron donors. The prototype of these materials is polyacetylene (PA). There are various other conjugated polymers such as polyparaphenylene, polyphenylenevinylene, polypoyrrole or polythiophene. The doped systems, i.e. the conducting polymers, have intersting potential technological applications such as replacement of conventional metals in electronic shielding and antistatic equipment, rechargable batteries, and flexible light emitting diodes.Although these systems have been investigated almost 20 years, the electronic structure of the doped metallic systems is not clear and even the reason for the gap in undoped semiconducting systems is under discussion.

Sign in / Sign up

Export Citation Format

Share Document