scholarly journals Influence of substrate topography on the nucleation of diamond thin films

1991 ◽  
Vol 59 (13) ◽  
pp. 1562-1564 ◽  
Author(s):  
Paul A. Dennig ◽  
David A. Stevenson
Keyword(s):  
Thin Films ◽  
Substrate Topography ◽  
Diamond Thin Films ◽  
Influence Of Substrate

scholarly journals Influence of substrate material on spectral properties and thermal quenching of photoluminescence of silicon vacancy colour centres in diamond thin films

2017 ◽  
Vol 68 (7) ◽  
pp. 3-9
Author(s):  
Kateřina Dragounová ◽  
Tibor Ižák ◽  
Alexander Kromka ◽  
Zdeněk Potůček ◽  
Zdeněk Bryknar ◽  
...  
Keyword(s):  
Thin Films ◽  
Thermal Quenching ◽  
Substrate Material ◽  
Photoluminescence Intensity ◽  
Zero Phonon Line ◽  
Colour Centres ◽  
Silicon Vacancy ◽  
Diamond Peak ◽  
Diamond Thin Films ◽  
Influence Of Substrate

AbstractNanocrystalline diamond films with bright photoluminescence of silicon-vacancy colour centres have been grown using a microwave plasma enhanced CVD technique. The influence of substrate material (quartz, Al2O3, Mo and Si) on a reproducible fabrication of diamond thin films with Si-V optical centres is presented. Film quality and morphology are characterized by Raman spectroscopy and SEM technique. SEM shows well faceted diamond grains with sizes from 170 to 300 nm. The diamond peak is confirmed in Raman spectra for all samples. In the case of the quartz substrate, a redshift of the diamond peak is observed (≈3.5 cm−1) due to tension in the diamond film. The steady-state photoluminescence intensity was measured in the temperature range from 11 K to 300 K. All spectra consist of a broad emission band with a maximum near 600 nm and of a sharp zero phonon line in the vicinity of 738 nm corresponding to Si-V centres that is accompanied with a phonon sideband peaking at 757 nm. Activation energies for the thermal quenching of Si-V centre photoluminescence were determined and the effect of the substrate on photoluminescence properties is discussed too.

Electron microscopic characterization of diamond thin films and substrates for diamond heteroepitaxial growth

1989 ◽  
Vol 47 ◽  
pp. 592-593
Author(s):  
J.B. Posthill ◽  
R.P. Burns ◽  
R.A. Rudder ◽  
Y.H. Lee ◽  
R.J. Markunas ◽  
...  
Keyword(s):  
Thin Films ◽  
Wide Band ◽  
Deposition Process ◽  
Heteroepitaxial Growth ◽  
Electron Microscopic ◽  
Wide Band Gap ◽  
Lattice Matching ◽  
Different Types ◽  
Diamond Thin Films

Because of diamond’s wide band gap, high thermal conductivity, high breakdown voltage and high radiation resistance, there is a growing interest in developing diamond-based devices for several new and demanding electronic applications. In developing this technology, there are several new challenges to be overcome. Much of our effort has been directed at developing a diamond deposition process that will permit controlled, epitaxial growth. Also, because of cost and size considerations, it is mandatory that a non-native substrate be developed for heteroepitaxial nucleation and growth of diamond thin films. To this end, we are currently investigating the use of Ni single crystals on which different types of epitaxial metals are grown by molecular beam epitaxy (MBE) for lattice matching to diamond as well as surface chemistry modification. This contribution reports briefly on our microscopic observations that are integral to these endeavors.

scholarly journals Influence of Substrate Materials on Nucleation and Properties of Iridium Thin Films Grown by ALD

Coatings ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 173
Author(s):  
Paul Schmitt ◽  
Vivek Beladiya ◽  
Nadja Felde ◽  
Pallabi Paul ◽  
Felix Otto ◽  
...  
Keyword(s):  
Thin Films ◽  
Film Growth ◽  
Bulk Material ◽  
Atomic Layer ◽  
Substrate Material ◽  
Fused Silica ◽  
Silicon Wafers ◽  
Force Microscopy ◽  
Angle Measurements ◽  
Influence Of Substrate

Ultra-thin metallic films are widely applied in optics and microelectronics. However, their properties differ significantly from the bulk material and depend on the substrate material. The nucleation, film growth, and layer properties of atomic layer deposited (ALD) iridium thin films are evaluated on silicon wafers, BK7, fused silica, SiO2, TiO2, Ta2O5, Al2O3, HfO2, Ru, Cr, Mo, and graphite to understand the influence of various substrate materials. This comprehensive study was carried out using scanning electron and atomic force microscopy, X-ray reflectivity and diffraction, four-point probe resistivity and contact angle measurements, tape tests, and Auger electron spectroscopy. Within few ALD cycles, iridium islands occur on all substrates. Nevertheless, their size, shape, and distribution depend on the substrate. Ultra-thin (almost) closed Ir layers grow on a Ta2O5 seed layer after 100 cycles corresponding to about 5 nm film thickness. In contrast, the growth on Al2O3 and HfO2 is strongly inhibited. The iridium growth on silicon wafers is overall linear. On BK7, fused silica, SiO2, TiO2, Ta2O5, Ru, Cr, and graphite, three different growth regimes are distinguishable. The surface free energy of the substrates correlates with their iridium nucleation delay. Our work, therefore, demonstrates that substrates can significantly tailor the properties of ultra-thin films.

Photoemission properties of nanocrystalline diamond thin films on silicon

2015 ◽  
Vol 33 (3) ◽  
pp. 03C105 ◽  
Author(s):  
Jean-Paul Mazellier ◽  
Cyril Di Giola ◽  
Pierre Legagneux ◽  
Clément Hébert ◽  
Emmanuel Scorsone ◽  
...  
Keyword(s):  
Thin Films ◽  
Nanocrystalline Diamond ◽  
Diamond Thin Films
Sign in / Sign up

Export Citation Format

Share Document