MICROELECTRONICS APPLICATIONS OF DEPOSITED Si FILMS RECRYSTALLIZED FROM THE MELT

1982 ◽  
Vol 43 (C1) ◽  
pp. C1-353-C1-362
Author(s):  
G. K. Celler ◽  
L. E. Trimble
Keyword(s):  
Si Films

Electron Energy Analysis of Germanium and Silica Layers on Silicon Substrates

1975 ◽  
Vol 33 ◽  
pp. 96-97
Author(s):  
R. W. Ditchfield ◽  
A. G. Cullis
Keyword(s):  
Epitaxial Growth ◽  
Electron Energy ◽  
Silicon Substrates ◽  
Secondary Phases ◽  
Si Substrates ◽  
Transmission Electron ◽  
Layer Structures ◽  
Si Films ◽  
Electron Energy Loss ◽  
Growth Centres

An energy analyzing transmission electron microscope of the Möllenstedt type was used to measure the electron energy loss spectra given by various layer structures to a spatial resolution of 100Å. The technique is an important, method of microanalysis and has been used to identify secondary phases in alloys and impurity particles incorporated into epitaxial Si films.Layers Formed by the Epitaxial Growth of Ge on Si Substrates Following studies of the epitaxial growth of Ge on (111) Si substrates by vacuum evaporation, it was important to investigate the possible mixing of these two elements in the grown layers. These layers consisted of separate growth centres which were often triangular and oriented in the same sense, as shown in Fig. 1.

Growth of near noble metal Pd and Pt thin film silicides morphology and structure

1984 ◽  
Vol 42 ◽  
pp. 498-499
Author(s):  
E. I. Alessandrini ◽  
M. O. Aboelfotoh
Keyword(s):  
Noble Metals ◽  
Annealing Temperature ◽  
Chemical Compounds ◽  
Barrier Properties ◽  
Solid State Reactions ◽  
Transmission Electron ◽  
Stable Chemical ◽  
Metal Thickness ◽  
Amorphous Si ◽  
Si Films

Considerable interest has been generated in solid state reactions between thin films of near noble metals and silicon. These metals deposited on Si form numerous stable chemical compounds at low temperatures and have found applications as Schottky barrier contacts to silicon in VLSI devices. Since the very first phase that nucleates in contact with Si determines the barrier properties, the purpose of our study was to investigate the silicide formation of the near noble metals, Pd and Pt, at very thin thickness of the metal films on amorphous silicon.Films of Pd and Pt in the thickness range of 0.5nm to 20nm were made by room temperature evaporation on 40nm thick amorphous Si films, which were first deposited on 30nm thick amorphous Si3N4 membranes in a window configuration. The deposition rate was 0.1 to 0.5nm/sec and the pressure during deposition was 3 x 10 -7 Torr. The samples were annealed at temperatures in the range from 200° to 650°C in a furnace with helium purified by hot (950°C) Ti particles. Transmission electron microscopy and diffraction techniques were used to evaluate changes in structure and morphology of the phases formed as a function of metal thickness and annealing temperature.

TRANSPORT PROPERTIES OF COMPENSATED a-Si FILMS

1981 ◽  
Vol 42 (C4) ◽  
pp. C4-103-C4-106
Author(s):  
W. Beyer ◽  
H. Mell ◽  
H. Overhof
Keyword(s):  
Transport Properties ◽  
Si Films

Nanocrystalline silicon ( nc-Si ) from single ion beam sputtering

2003 ◽  
Vol 762 ◽  
Author(s):  
Z.B. Zhou ◽  
G.M. Hadi ◽  
R.Q. Cui ◽  
Z.M. Ding ◽  
G. Li
Keyword(s):  
Solar Cell ◽  
Ion Beam ◽  
Nanocrystalline Silicon ◽  
Silicon Films ◽  
Chamber Pressure ◽  
Ion Beam Sputtering ◽  
High Hydrogen ◽  
Beam Sputtering ◽  
Si Films ◽  
Nanocrystalline Silicon Films

AbstractBased on a small set of selected publications on the using of nanocrystalline silicon films (nc-Si) for solar cell from 1997 to 2001, this paper reviews the application of nc-Si films as intrinsic layers in p-i-n solar cells. The new structure of nc-Si films deposited at high chamber pressure and high hydrogen dilution have characters of nanocrystalline grains with dimension about several tens of nanometer embedded in matrix of amorphous tissue and a high volume fraction of crystallinity (60~80%). The new nc-Si material have optical gap of 1.89 eV. The efficiency of this single junction solar cell reaches 8.7%. This nc-Si layer can be used not only as an intrinsic layer and as a p-type layer. Also nanocrystalline layer may be used as a seed layer for the growth of polycrystalline Si films at a low temperature.We used single ion beam sputtering methods to synthesize nanocrystalline silicon films successfully. The films were characterized with the technique of X-ray diffraction, Atomic Force Micrographs. We found that the films had a character of nc-amorphous double phase structure. Conductivity test at different temperatures presented the transportation of electrons dominated by different mechanism within different temperature ranges. Photoconductivity gains of the material were obtained in our recent investigation.

Formation of Large, Orientation-Controlled, Nearly Single Crystalline Si Thin Films on SiO2 Using Contact Printing of Rolled and Annealed Nickel Tapes

2003 ◽  
Vol 762 ◽  
Author(s):  
Hwang Huh ◽  
Jung H. Shin
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
High Resolution ◽  
Amorphous Silicon ◽  
Tem Analysis ◽  
Contact Printing ◽  
Single Crystalline ◽  
High Resolution Tem ◽  
Lateral Crystallization ◽  
Si Films

AbstractAmorphous silicon (a-Si) films prepared on oxidized silicon wafer were crystallized to a highly textured form using contact printing of rolled and annealed nickel tapes. Crystallization was achieved by first annealing the a-Si film in contact with patterned Ni tape at 600°C for 20 min in a flowing forming gas (90 % N2, 10 % H2) environment, then removing the Ni tape and further annealing the a-Si film in vacuum for2hrsat600°C. An array of crystalline regions with diameters of up to 20 μm could be formed. Electron microscopy indicates that the regions are essentially single-crystalline except for the presence of twins and/or type A-B formations, and that all regions have the same orientation in all 3 directions even when separated by more than hundreds of microns. High resolution TEM analysis shows that formation of such orientation-controlled, nearly single crystalline regions is due to formation of nearly single crystalline NiSi2 under the point of contact, which then acts as the template for silicide-induced lateral crystallization. Furthermore, the orientation relationship between Si grains and Ni tape is observed to be Si (110) || Ni (001)

Rapid Epitaxial Growth of Si and SiGe Mono-Crystalline Films on Silicon-on-Glass Substrates by Reactive CVD Using SiH4, GeH4, and F2

2012 ◽  
Vol 1426 ◽  
pp. 331-337
Author(s):  
Hiroshi Noge ◽  
Akira Okada ◽  
Ta-Ko Chuang ◽  
J. Greg Couillard ◽  
Michio Kondo
Keyword(s):  
Epitaxial Growth ◽  
Heating Temperature ◽  
Exothermic Reaction ◽  
Epitaxial Films ◽  
Si Substrates ◽  
Glass Substrates ◽  
Good Crystallinity ◽  
Crystalline Films ◽  
Si Films ◽  
First Time

ABSTRACTWe have succeeded in the rapid epitaxial growth of Si, Ge, and SiGe films on Si substrates below 670 ºC by reactive CVD utilizing the spontaneous exothermic reaction between SiH4, GeH4, and F2. Mono-crystalline SiGe epitaxial films with Ge composition ranging from 0.1 to 1.0 have been successfully grown by reactive CVD for the first time.This technique has also been successfully applied to the growth of these films on silicon-on-glass substrates by a 20 - 50 ºC increase of the heating temperature. Over 10 μm thick epitaxial films at 3 nm/s growth rate are obtained. The etch pit density of the 5.2 μm-thick Si0.5Ge0.5 film is as low as 5 x 106 cm-2 on top. Mobilities of the undoped SiGe and Si films are 180 to 550 cm2/Vs, confirming the good crystallinity of the epitaxial films.

Epitaxial Growth Following Crystal Nucleation in Laser-Quenched Si Films on SiO2

2015 ◽  
Vol 1770 ◽  
pp. 67-72
Author(s):  
Vernon K. Wong ◽  
A. M. Chitu ◽  
A. B. Limanov ◽  
James S. Im
Keyword(s):  
Epitaxial Growth ◽  
Growth Model ◽  
Crystal Nucleation ◽  
Key Factors ◽  
Complete Melting ◽  
Melting Regime ◽  
Direct Growth ◽  
Crystal Core ◽  
Excimer Laser Irradiation ◽  
Si Films

ABSTRACTWe have investigated the solidified microstructure of nucleation-generated grains obtained via complete melting of Si films on SiO2 at high nucleation temperatures. This was achieved using a high-temperature-capable hot stage in conjunction with excimer laser irradiation. As predicted by the direct-growth model that considers (1) the evolution in the temperature of the solidifying interface and (2) the subsequent modes of growth (consisting of amorphous, defective, and epitaxial) as key factors, we were able to observe the appearance of “normal” grains that possess a single-crystal core area. These grains, which are in contrast to previously reported flower-shaped grains that fully make up the microstructure of the solidified films obtained via irradiation at lower preheating temperatures (and amongst which these “normal” grains emerge), indicate that epitaxial growth of nucleated crystals must have taken place within the grains. We discuss the implications of our findings regarding (1) the validity of the direct-growth model, (2) the nature of the heterogeneous nucleation mechanism, and (3) the alternative explanations and assumptions that have been previously employed in order to explain the microstructure of Si films obtained via nucleation and growth within the complete melting regime.

Intermixing and formation of Pd–Mg intermetallics in Pd/Mg/Si films

2009 ◽  
Vol 481 (1-2) ◽  
pp. 714-718 ◽  
Author(s):  
G.L.N. Reddy ◽  
Sanjiv Kumar ◽  
Y. Sunitha ◽  
S. Kalavathi ◽  
V.S. Raju
Keyword(s):  
Si Films
Sign in / Sign up

Export Citation Format

Share Document