Low-Voltage Ride-Through Control Strategy of PV System Based on Active and Reactive Power Control

2015 ◽  
Author(s):  
F. Yang ◽  
T. Zhang ◽  
L.H. Yang ◽  
X.K. Ma
Keyword(s):  
Power Control ◽  
Control Strategy ◽  
Reactive Power ◽  
Low Voltage ◽  
Pv System ◽  
Reactive Power Control ◽  
Low Voltage Ride Through ◽  
Active And Reactive Power

scholarly journals Fuzzy Logic Control for Low-Voltage Ride-Through Single-Phase Grid-Connected PV Inverter

Energies ◽  
2019 ◽  
Vol 12 (24) ◽  
pp. 4796 ◽  
Author(s):  
Eyad Radwan ◽  
Mutasim Nour ◽  
Emad Awada ◽  
Ali Baniyounes
Keyword(s):  
Fuzzy Logic ◽  
Output Power ◽  
Single Phase ◽  
Reactive Power ◽  
Low Voltage ◽  
Operating Conditions ◽  
Pv System ◽  
Utilization Factor ◽  
Low Voltage Ride Through ◽  
Active And Reactive Power

This paper presents a control scheme for a photovoltaic (PV) system that uses a single-phase grid-connected inverter with low-voltage ride-through (LVRT) capability. In this scheme, two PI regulators are used to adjust the power angle and voltage modulation index of the inverter; therefore, controlling the inverter’s active and reactive output power, respectively. A fuzzy logic controller (FLC) is also implemented to manage the inverter’s operation during the LVRT operation. The FLC adjusts (or de-rates) the inverter’s reference active and reactive power commands based on the grid voltage sag and the power available from the PV system. Therefore, the inverter operation has been divided into two modes: (i) Maximum power point tracking (MPPT) during the normal operating conditions of the grid, and (ii) LVRT support when the grid is operating under faulty conditions. In the LVRT mode, the de-rating of the inverter active output power allows for injection of some reactive power, hence providing voltage support to the grid and enhancing the utilization factor of the inverter’s capacity. The proposed system was modelled and simulated using MATLAB Simulink. The simulation results showed good system performance in response to changes in reference power command, and in adjusting the amount of active and reactive power injected into the grid.

Sign in / Sign up

Export Citation Format

Share Document