Influence of drain-induced barrier lowering on the dynamic conductance of short-channel MOSFETs

1986 ◽  
Vol 22 (19) ◽  
pp. 1010 ◽  
Author(s):  
G. Ghibaudo ◽  
B. Cabon
Keyword(s):  
Short Channel ◽  
Dynamic Conductance

Monte Carlo study of 50 nm-long single and dual-gate MODFETs: suppression of short-channel effects

1993 ◽  
Vol 3 (9) ◽  
pp. 1719-1728
Author(s):  
P. Dollfus ◽  
P. Hesto ◽  
S. Galdin ◽  
C. Brisset
Keyword(s):  
Monte Carlo ◽  
Monte Carlo Study ◽  
Short Channel Effects ◽  
Short Channel ◽  
Channel Effects ◽  
Dual Gate

A NEW PUNCHTHROUGH MODEL FOR SHORT CHANNEL MOSFET

1988 ◽  
Vol 49 (C4) ◽  
pp. C4-761-C4-764
Author(s):  
D. CHEN ◽  
Z. LI
Keyword(s):  
Short Channel

Short Channel Poly-Si TFT with Single Grain Boundary by Excimer Laser Annealing on Al-masked a-Si Layer

2002 ◽  
Vol 715 ◽  
Author(s):  
Sang-Hoon Jung ◽  
Jae-Hoon Lee ◽  
Min-Koo Han
Keyword(s):  
Grain Boundary ◽  
Laser Annealing ◽  
Thin Film Transistor ◽  
High Mobility ◽  
Silicon Layer ◽  
Silicon Thin Film ◽  
Short Channel ◽  
Excimer Laser Annealing ◽  
Boundary Density ◽  
Single Grain

AbstractA short channel polycrystalline silicon thin film transistor (poly-Si TFT), which has single grain boundary in the center of channel, is reported. The reported poly-Si TFT employs lateral grain growth method through aluminum patterns, which acts as a selective beam mask and a lateral heat sink during the laser irradiation, on an amorphous silicon layer. The electrical characteristics of the proposed poly-Si TFT have been considerably improved due to grain boundary density lowered. The reported short channel poly-Si TFT with single grain boundary exhibits high mobility as 222 cm2/Vsec and large on/off current ratio exceeding 1 × 108.

Co-planar two-dimensional Metal-Insulator-Semiconductor Capacitor: Numerical study of the device electrostatics.

2017 ◽  
Author(s):  
Varun Bheemireddy
Keyword(s):  
Space Charge ◽  
High Performance ◽  
Numerical Study ◽  
2D Materials ◽  
Space Charge Density ◽  
Two Dimensional ◽  
Short Channel ◽  
Metal Insulator ◽  
Metal Insulator Semiconductor ◽  
New Family

The two-dimensional(2D) materials are highly promising candidates to realise elegant and e cient transistor. In the present letter, we conjecture a novel co-planar metal-insulator-semiconductor(MIS) device(capacitor) completely based on lateral 2D materials architecture and perform numerical study of the capacitor with a particular emphasis on its di erences with the conventional 3D MIS electrostatics. The space-charge density features a long charge-tail extending into the bulk of the semiconductor as opposed to the rapid decay in 3D capacitor. Equivalently, total space-charge and semiconductor capacitance densities are atleast an order of magnitude more in 2D semiconductor. In contrast to the bulk capacitor, expansion of maximum depletion width in 2D semiconductor is observed with increasing doping concentration due to lower electrostatic screening. The heuristic approach of performance analysis(2D vs 3D) for digital-logic transistor suggest higher ON-OFF current ratio in the long-channel limit even without third dimension and considerable room to maximise the performance of short-channel transistor. The present results could potentially trigger the exploration of new family of co-planar at transistors that could play a signi significant role in the future low-power and/or high performance electronics.<br>

Correlation of Electronic and Thermal Properties of Short Channel nMOSFETS

1999 ◽  
Author(s):  
M. Palaniappan ◽  
V. Ng ◽  
R. Heiderhoff ◽  
J.C.H. Phang ◽  
G.B.M. Fiege ◽  
...  
Keyword(s):  
Thermal Properties ◽  
Temperature Distribution ◽  
Heat Generation ◽  
Hot Spots ◽  
Light Emission ◽  
Photon Emission ◽  
Thermal Image ◽  
Short Channel ◽  
Physical Phenomena ◽  
Backside Illuminated

Abstract Light emission and heat generation of Si devices have become important in understanding physical phenomena in device degradation and breakdown mechanisms. This paper correlates the photon emission with the temperature distribution of a short channel nMOSFET. Investigations have been carried out to localize and characterize the hot spots using a spectroscopic photon emission microscope and a scanning thermal microscope. Frontside investigations have been carried out and are compared and discussed with backside investigations. A method has been developed to register the backside thermal image with the backside illuminated image.

Analysis of an Anomalous Transistor Exhibiting Dual-Vt Characteristics and Its Cause in a 90nm Node CMOS Technology

2012 ◽  
Author(s):  
Yuk L. Tsang ◽  
Xiang D. Wang ◽  
Reyhan Ricklefs ◽  
Jason Goertz
Keyword(s):  
Threshold Voltage ◽  
Electrical Characterization ◽  
Cmos Technology ◽  
Short Channel ◽  
Visual Defect ◽  
Subthreshold Region ◽  
Short Channel Effect ◽  
Channel Effect ◽  
Transistor Model

Abstract In this paper, we report a transistor model that has successfully led to the identification of a non visual defect. This model was based on detailed electrical characterization of a MOS NFET exhibiting a threshold voltage (Vt) of just about 40mv lower than normal. This small Vt delta was based on standard graphical extrapolation method in the usual linear Id-Vg plots. We observed, using a semilog plot, two slopes in the Id-Vg curves with Vt delta magnified significantly in the subthreshold region. The two slopes were attributed to two transistors in parallel with different Vts. We further found that one of the parallel transistors had short channel effect due to a punch-through mechanism. It was proposed and ultimately confirmed the cause was due to a dopant defect using scanning capacitance microscopy (SCM) technique.

An Analytical Modeling and Performance Analysis of Graded Work Function Gate Recessed Channel SOI-MOSFET

2019 ◽  
Vol 9 (4) ◽  
pp. 504-511
Author(s):  
Sikha Mishra ◽  
Urmila Bhanja ◽  
Guru Prasad Mishra
Keyword(s):  
Analytical Model ◽  
Surface Potential ◽  
Threshold Voltage ◽  
Silicon On Insulator ◽  
Junction Depth ◽  
Short Channel ◽  
Soi Mosfet ◽  
Minimum Surface ◽  
Recessed Channel ◽  
The Impact

Introduction: A new analytical model is designed for Workfunction Modulated Rectangular Recessed Channel-Silicon On Insulator (WMRRC-SOI) MOSFET that considers the concept of groove gate and implements an idea of workfunction engineering. Methods: The impact of Negative Junction Depth (NJD) and oxide thickness (tox) are analyzed on device performances such as Sub-threshold Slope (SS), Drain Induced Barrier Lowering (DIBL) and threshold voltage. Results: The results of the proposed work are evaluated with the Rectangular Recessed Channel-Silicon On Insulator (RRC-SOI) MOSFET keeping the metal workfunction constant throughout the gate region. Furthermore, an analytical model is developed using 2D Poisson’s equation and threshold voltage is estimated in terms of minimum surface potential. Conclusion: In this work, the impact of Negative Junction Depth (NJD) on minimum surface potential and the drain current are also evaluated. It is observed from the analysis that the analog switching performance of WMRRC-SOI MOSFET surpasses RRC-SOI MOSFET in terms of better driving capability, high Ion/Ioff ratio, minimized Short Channel Effects (SCEs) and hot carrier immunity. Results are simulated using 2D Sentaurus TCAD simulator for validation of the proposed structure.

Projected Performance of Sub-10 nm GaN-based Double Gate MOSFETs

2017 ◽  
Vol 2 (2) ◽  
pp. 15-19 ◽  
Author(s):  
Md. Saud Al Faisal ◽  
Md. Rokib Hasan ◽  
Marwan Hossain ◽  
Mohammad Saiful Islam
Keyword(s):  
High Speed ◽  
Field Effect Transistors ◽  
Cmos Technology ◽  
Channel Length ◽  
Capacitive Coupling ◽  
Oxide Semiconductor ◽  
Double Gate ◽  
Short Channel ◽  
Channel Effects ◽  
Silvaco Atlas

GaN-based double gate metal-oxide semiconductor field-effect transistors (DG-MOSFETs) in sub-10 nm regime have been designed for the next generation logic applications. To rigorously evaluate the device performance, non-equilibrium Green’s function formalism are performed using SILVACO ATLAS. The device is turn on at gate voltage, VGS =1 V while it is going to off at VGS = 0 V. The ON-state and OFF-state drain currents are found as 12 mA/μm and ~10-8 A/μm, respectively at the drain voltage, VDS = 0.75 V. The sub-threshold slope (SS) and drain induced barrier lowering (DIBL) are ~69 mV/decade and ~43 mV/V, which are very compatible with the CMOS technology. To improve the figure of merits of the proposed device, source to gate (S-G) and gate to drain (G-D) distances are varied which is mentioned as underlap. The lengths are maintained equal for both sides of the gate. The SS and DIBL are decreased with increasing the underlap length (LUN). Though the source to drain resistance is increased for enhancing the channel length, the underlap architectures exhibit better performance due to reduced capacitive coupling between the contacts (S-G and G-D) which minimize the short channel effects. Therefore, the proposed GaN-based DG-MOSFETs as one of the excellent promising candidates to substitute currently used MOSFETs for future high speed applications.

Sign in / Sign up

Export Citation Format

Share Document