A High-Power and High-Linearity Photodetector Module with 25 dBm RF Output Power at 10 GHz

2013 ◽  
Author(s):  
E. Rouvalis ◽  
A.S. Cross ◽  
Qiugui Zhou ◽  
A.G. Steffan ◽  
A. Beling ◽  
...  
Keyword(s):  
Output Power ◽  
High Power ◽  
High Linearity

Output power feedforward technique applied to a high power factor rectifier with high frequency transformer

2013 ◽  
Author(s):  
Julio Cesar Secolo Ganacim ◽  
Martin Breus Meier ◽  
Alceu Andre Badin ◽  
Roger Gules ◽  
Eduardo Felix Ribeiro Romaneli ◽  
...  
Keyword(s):  
Output Power ◽  
Power Factor ◽  
High Power ◽  
High Frequency ◽  
High Frequency Transformer ◽  
High Power Factor

LD-pumped high-power continuous-wave Pr3+:YLF deep red lasers at 718.5 and 720.8 nm

Laser Physics ◽  
2021 ◽  
Vol 32 (2) ◽  
pp. 025801
Author(s):  
Xiangrui Liu ◽  
Zhuang Li ◽  
Chengkun Shi ◽  
Bo Xiao ◽  
Run Fang ◽  
...  
Keyword(s):  
Output Power ◽  
High Power ◽  
Slope Efficiency ◽  
Laser Emission ◽  
Continuous Wave ◽  
Optical Glass ◽  
Maximum Output Power ◽  
Glass Plate ◽  
Maximum Output ◽  
First Time

Abstract We demonstrated 22 W LD-pumped high-power continuous-wave (CW) deep red laser operations at 718.5 and 720.8 nm based on an a-cut Pr3+:YLF crystal. The output power of both polarized directions reached the watt-level without output power saturation. A single wavelength laser operated at 720.8 nm in the π-polarized direction was achieved, with a high output power of 4.5 W and high slope efficiency of approximately 41.5%. To the best of our knowledge, under LD-pumped conditions, the laser output power and slope efficiency are the highest at 721 nm. By using a compact optical glass plate as an intracavity etalon, we suppressed the π-polarized 720.8 nm laser emission. And σ-polarized single-wavelength laser emission at 718.5 nm was achieved, with a maximum output power of 1.45 W and a slope efficiency of approximately 17.8%. This is the first time that we have achieved the σ-polarized laser emission at 718.5 nm generated by Pr3+:YLF lasers.

scholarly journals Review of the high-power vacuum tube microwave sources based on Cherenkov radiation

2020 ◽  
Author(s):  
Weiye Xu
Keyword(s):  
Output Power ◽  
High Power ◽  
Traveling Wave ◽  
Cherenkov Radiation ◽  
Continuous Wave ◽  
Vacuum Tube ◽  
Microwave Source ◽  
Vacuum Tubes ◽  
Traveling Wave Tubes ◽  
Microwave Sources

Since the first vacuum tube (X-ray tube) was invented by Wilhelm Röntgen in Germany, after more than one hundred years of development, the average power density of the vacuum tube microwave source has reached the order of 108 [MW][GHz]2. In the high-power microwave field, the vacuum devices are still the mainstream microwave sources for applications such as scientific instruments, communications, radars, magnetic confinement fusion heating, microwave weapons, etc. The principles of microwave generation by vacuum tube microwave sources include Cherenkov or Smith-Purcell radiation, transition radiation, and Bremsstrahlung. In this paper, the vacuum tube microwave sources based on Cherenkov radiation were reviewed. Among them, the multi-wave Cherenkov generators can produce 15 GW output power in X-band. Cherenkov radiation vacuum tubes that can achieve continuous-wave operation include Traveling Wave Tubes and Magnetrons, with output power up to 1MW. Cherenkov radiation vacuum tubes that can generate frequencies of the order of 100 GHz and above include Traveling Wave Tubes, Backward Wave Oscillators, Magnetrons, Surface Wave Oscillators, Orotrons, etc.

scholarly journals Design of W-Band GaN-on-Silicon Power Amplifier Using Low Impedance Lines

2021 ◽  
Vol 11 (19) ◽  
pp. 9017
Author(s):  
Jinho Jeong ◽  
Yeongmin Jang ◽  
Jongyoun Kim ◽  
Sosu Kim ◽  
Wansik Kim
Keyword(s):  
Power Density ◽  
Output Power ◽  
Power Amplifier ◽  
High Power ◽  
Common Source ◽  
High Electron ◽  
Large Signal ◽  
Power Added Efficiency ◽  
W Band ◽  
Gan On Si

In this paper, a high-power amplifier integrated circuit (IC) in gallium-nitride (GaN) on silicon (Si) technology is presented at a W-band (75–110 GHz). In order to mitigate the losses caused by relatively high loss tangent of Si substrate compared to silicon carbide (SiC), low-impedance microstrip lines (20–30 Ω) are adopted in the impedance matching networks. They allow for the impedance transformation between 50 Ω and very low impedances of the wide-gate transistors used for high power generation. Each stage is matched to produce enough power to drive the next stage. A Lange coupler is employed to combine two three-stage common source amplifiers, providing high output power and good input/output return loss. The designed power amplifier IC was fabricated in the commercially available 60 nm GaN-on-Si high electron mobility transistor (HEMT) foundry. From on-wafer probe measurements, it exhibits the output power higher than 26.5 dBm and power added efficiency (PAE) higher than 8.5% from 88 to 93 GHz with a large-signal gain > 10.5 dB. Peak output power is measured to be 28.9 dBm with a PAE of 13.3% and a gain of 9.9 dB at 90 GHz, which corresponds to the power density of 1.94 W/mm. To the best of the authors’ knowledge, this result belongs to the highest output power and power density among the reported power amplifier ICs in GaN-on-Si HEMT technologies operating at the W-band.

scholarly journals High-power long-wave infrared laser based on polarization beam coupling technique

2020 ◽  
Vol 8 ◽  
Author(s):  
Yingjie Shen ◽  
Chuanpeng Qian ◽  
Xiaoming Duan ◽  
Ruijun Lan
Keyword(s):  
Output Power ◽  
High Power ◽  
Beam Quality ◽  
Maximum Output Power ◽  
Infrared Laser ◽  
Maximum Output ◽  
Coupling Technique ◽  
Long Wave ◽  
Beam Coupling ◽  
Long Wave Infrared

We demonstrated a high-power long-wave infrared laser based on a polarization beam coupling technique. An average output power at $8.3~\unicode[STIX]{x03BC}\text{m}$ of 7.0 W was achieved at a maximum available pump power of 107.6 W, corresponding to an optical-to-optical conversion of 6.5%. The coupling efficiency of the polarization coupling system was calculated to be approximately 97.2%. With idler single resonance operation, a good beam quality factor of ${\sim}1.8$ combined with an output wavelength of $8.3~\unicode[STIX]{x03BC}\text{m}$ was obtained at the maximum output power.

A 4.2-to-5.4 GHz stacked GaAs HBT power amplifier for C-band applications

Circuit World ◽  
2020 ◽  
Vol 46 (4) ◽  
pp. 243-248
Author(s):  
Min Liu ◽  
Panpan Xu ◽  
Jincan Zhang ◽  
Bo Liu ◽  
Liwen Zhang
Keyword(s):  
Output Power ◽  
Power Amplifier ◽  
High Power ◽  
High Efficiency ◽  
Common Source ◽  
Power Performance ◽  
Matching Network ◽  
Content Type ◽  
Power Added Efficiency ◽  
Saturated Output Power

Purpose Power amplifiers (PAs) play an important role in wireless communications because they dominate system performance. High-linearity broadband PAs are of great value for potential use in multi-band system implementation. The purpose of this paper is to present a cascode power amplifier architecture to achieve high power and high efficiency requirements for 4.2∼5.4 GHz applications. Design/methodology/approach A common emitter (CE) configuration with a stacked common base configuration of heterojunction bipolar transistor (HBT) is used to achieve high power. T-type matching network is used as input matching network. To increase the bandwidth, the output matching networks are implemented using the two L-networks. Findings By using the proposed method, the stacked PA demonstrates a maximum saturated output power of 26.2 dBm, a compact chip size of 1.17 × 0.59 mm2 and a maximum power-added efficiency of 46.3 per cent. The PA shows a wideband small signal gain with less than 3 dB variation over working frequency. The saturated output power of the proposed PA is higher than 25 dBm between 4.2 and 5.4 GHz. Originality/value The technology adopted for the design of the 4.2-to-5.4 GHz stacked PA is the 2-µm gallium arsenide HBT process. Based on the proposed method, a better power performance of 3 dB improvement can be achieved as compared with the conventional CE or common-source amplifier because of high output stacking impedance.

Phase-Modulated Analog Photonic Link With a High-Power High-Linearity Photodiode

2018 ◽  
Vol 36 (18) ◽  
pp. 3805-3814 ◽  
Author(s):  
Zhanyu Yang ◽  
Qianhuan Yu ◽  
Jizhao Zang ◽  
Joe C. Campbell ◽  
Andreas Beling
Keyword(s):  
High Power ◽  
High Linearity

scholarly journals High power mid-infrared supercontinuum generation in a single-mode ZBLAN fiber with up to 218 W average output power

2014 ◽  
Vol 22 (20) ◽  
pp. 24384 ◽  
Author(s):  
Kun Liu ◽  
Jiang Liu ◽  
Hongxing Shi ◽  
Fangzhou Tan ◽  
Pu Wang
Keyword(s):  
Output Power ◽  
High Power ◽  
Average Output Power ◽  
Single Mode ◽  
Supercontinuum Generation ◽  
Average Output ◽  
Mid Infrared

High-power high-linearity SiGe based E-BAND transceiver chipset for broadband communication

2012 ◽  
Author(s):  
Oded Katz ◽  
Roee Ben-Yishay ◽  
Roi Carmon ◽  
Benny Sheinman ◽  
Frank Szenher ◽  
...  
Keyword(s):  
High Power ◽  
Broadband Communication ◽  
High Linearity
Sign in / Sign up

Export Citation Format

Share Document