scholarly journals Tuning the near infrared II emitting wavelength of small molecule dyes by single atom alteration

2020 ◽  
Vol 56 (4) ◽  
pp. 523-526 ◽  
Author(s):  
Kun Qian ◽  
Chunrong Qu ◽  
Xiangyu Ma ◽  
Hao Chen ◽  
Martha Kandawa-Schulz ◽  
...  

Replacing donors’ S with O and Se will red shift NIR-II dyes’ fluorescence emission and offer good clarity/brightness for imaging.

2010 ◽  
Vol 88 (3) ◽  
pp. 192-201 ◽  
Author(s):  
Gang Qian ◽  
Zhi Yuan Wang

A novel low-band-gap chromophore (5, 0.86 eV) having fluorene as a donor, benzobisthiadiazole (BBTD) as an acceptor, and pyrrole as a π-spacer was successfully designed and synthesized, to probe the effect of π-spacer on the band-gap level of the donor–π–acceptor–π–donor type of chromophores. Compared with the thiophene spacer analogue (in compound 3), the intramolecular hydrogen bonding between the pyrrole and the neighboring BBTD unit pushes the absorption maximum and fluorescence emission of chromophore 5 into the near-infrared spectral region with a red shift of 172 and 158 nm, respectively. The same red-shift phenomenon can also be realized by addition of Lewis acid (e.g., BF3) to the BBTD-containing chromophores with other spacers. Attempt of using low-band-gap chromophore 5 in bulk heterojunction (BHJ) solar cells was made, showing a non-optimized photovoltaic device with the power conversion efficiency of 0.01%. A precursor approach to introduction of the alkaline-labile BBTD acceptor into the polymer backbone has been demonstrated by successful synthesis of low-band-gap polymer P2. The same strategy can be in principle applied to the synthesis of a series of low-band-gap chromophores or polymers with strong acceptors.


2021 ◽  
Author(s):  
Chonglu Li ◽  
Chang Liu ◽  
Yifan Fan ◽  
Xin Ma ◽  
Yibei Zhan ◽  
...  

In this review, we discuss the recent development of near-infrared photoacoustic probes based on small molecule dyes, which focus on their “always on” and “activatable” form in biomedicine.


2014 ◽  
Vol 940 ◽  
pp. 11-15
Author(s):  
Jun Qin Feng ◽  
Jun Fang Chen

Zinc nitride films were deposited by ion sources-assisted magnetron sputtering with the use of Zn target (99.99% purity) on 7059 glass substrates. The films were characterized by XRD, SEM and EDS, the results of which show that the polycrystalline zinc nitride thin film can be grown on the glass substrates, the EDS spectrum confirmed the chemical composition of the films and the SEM images revealed that the zinc nitride thin films have a dense structure. Ultraviolet-visible-near infrared spectrophotometer was used to study the transmittance behaviors of zinc nitride thin films, which calculated the optical band gap by Davis Mott model. The results of the fluorescence emission spectra show the zinc nitride would be a direct band gap semiconductor material.


2018 ◽  
Vol 2 (12) ◽  
pp. 2333-2339 ◽  
Author(s):  
Junhui Miao ◽  
Junxia Wang ◽  
Bin Meng ◽  
Jun Liu ◽  
Lixiang Wang

We report a new A–D–A′–D–A type small molecule acceptor with a wide absorption spectrum spanning from 300 nm to 900 nm and a bandgap of only 1.39 eV.


2014 ◽  
Vol 18 (08n09) ◽  
pp. 752-761 ◽  
Author(s):  
Tetsuo Okujima ◽  
Yoichi Shida ◽  
Keishi Ohara ◽  
Yuya Tomimori ◽  
Motoyoshi Nishioka ◽  
...  

A series of O-chelated BODIPYs fused with aromatic rings such as benzene and acenaphthylene at β,β-positions was synthesized as a near-infrared dye. The photophysical properties were examined by UV-vis-NIR absorption and fluorescence measurement. Acenaphthylene-fused O-BODIPYs showed a intense absorption at 750–840 nm with the ε of 105 M-1.cm-1. and a fluorescence emission at 770–850 nm with the high Φ value of 0.06–0.43.


2018 ◽  
Vol 6 (13) ◽  
pp. 3341-3345 ◽  
Author(s):  
Liangang Xiao ◽  
Song Chen ◽  
Xuebin Chen ◽  
Xiaobin Peng ◽  
Yong Cao ◽  
...  

A dimeric porphyrin-based photodetector shows a strong spectral response at 1000 nm with a detectivity of 1013Jones at zero bias.


2000 ◽  
Vol 15 (2) ◽  
pp. 278-281 ◽  
Author(s):  
Yong Gyu Choi ◽  
Kyong Hon Kim ◽  
Yong Seop Han ◽  
Jong Heo

We have demonstrated that an efficient energy transfer takes place from Yb3+ to Cr4+ in calcium aluminate glasses. Yb3+ improves excitation efficiency at around 980 nm, enhancing emission intensity of Cr4+ fluorescence at 1.2–1.6 μm. Nonradiative energy transfer via electric dipole–dipole interaction between ytterbium and chromium ions was found to be dominant over radiative Yb3+ → Cr4+ energy transfer. A diffusionlimited energy transfer mechanism well explains the decay behavior of Yb3+/Cr4+- codoped glasses. This codoping scheme may be applicable to other Cr4+-containing crystals and glasses.


2021 ◽  
Vol 8 ◽  
Author(s):  
Kenneth S. Hettie

Thrombosis within the vasculature arises when pathological factors compromise normal hemostasis. On doing so, arterial thrombosis (AT) and venous thrombosis (VT) can lead to life-threatening cardio-cerebrovascular complications. Unfortunately, the therapeutic window following the onset of AT and VT is insufficient for effective treatment. As such, acute AT is the leading cause of heart attacks and constitutes ∼80% of stroke incidences, while acute VT can lead to fatal therapy complications. Early lesion detection, their accurate identification, and the subsequent appropriate treatment of thrombi can reduce the risk of thrombosis as well as its sequelae. As the success rate of therapy of fresh thrombi is higher than that of old thrombi, detection of the former and accurate identification of lesions as thrombi are of paramount importance. Magnetic resonance imaging, x-ray computed tomography (CT), and ultrasound (US) are the conventional non-invasive imaging modalities used for the detection and identification of AT and VT, but these modalities have the drawback of providing only image-delayed indirect visualization of only late stages of thrombi development. To overcome such limitations, near-infrared (NIR, ca. 700–1,700 nm) fluorescence (NIRF) imaging has been implemented due to its capability of providing non-invasive real-time direct visualization of biological structures and processes. Contrast agents designed for providing real-time direct or indirect visualization of thrombi using NIRF imaging primarily provide peak NIR-I fluorescence emission (ca. 700–1,000 nm), which affords limited tissue penetration depth and suboptimal spatiotemporal resolution. To facilitate the enhancement of the visualization of thrombosis via providing detection of smaller, fresh, and/or deep-seated thrombi in real time, the development of contrast agents with peak NIR-II fluorescence emission (ca. 1000–1,700 nm) has been recently underway. Currently, however, most contrast agents that provide peak NIR-II fluorescence emissions that are purportedly capable of providing direct visualization of thrombi or their resultant occlusions actually afford only the indirect visualization of such because they only provide for the (i) measuring of the surrounding vascular blood flow and/or (ii) simple tracing of the vasculature. These contrast agents do not target thrombi or occlusions. As such, this mini review summarizes the extremely limited number of targeting contrast agents with peak NIR-II fluorescence emission developed for non-invasive real-time direct visualization of thrombosis that have been recently reported.


2018 ◽  
Vol 5 (2) ◽  
pp. 38-47
Author(s):  
Nikolay Uzunov ◽  
Michele Bello ◽  
Laura Melendez-Alafort ◽  
Laura De Nardo

Abstract In recent years, there is a constantly increasing interest in the application of nanoparticles for cancer diagnosis and cancer therapy. In this respect, the most promising nano-objects at present are the gold nanoparticles. A very convenient and powerful property of these objects is their ability to increase their temperature under electro-magnetic irradiation with certain wavelength. In our research we have directed our efforts toward particular nano-objects specifically sensitive to electromagnetic radiation in the near-infrared region (NIR). In order to study the photothermic properties of the solutions of gold nanoparticles in the NIR we constructed a specific electronic setup consisting of a laser system with interchangeable laser diodes with different wavelength NIR light, a thermally-insulated cuvette-holder compartment with temperature measuring probes and a NIR spectrometer to control the stimulated fluorescence emission of the nanoparticles’ solutions. The temperature measurement compartment with the thermal-insulated cuvette holder was designed to maintain the solutions’ temperature at a fixed value right before the moment of laser irradiation. To maintain the measurement setup at a fixed temperature before the irradiation we used a thermal stabilized system based on two Peltier cells with electronic temperature control. The temperatures of the ambient air and the temperature of the cuvette walls were continuously measured in order to make corrections about the temperature dissipation during the irradiation.


Sign in / Sign up

Export Citation Format

Share Document