scholarly journals Pectin as an Extraordinary Natural Kinetic Hydrate Inhibitor

2016 ◽  
Vol 6 (1) ◽  
Author(s):  
Shurui Xu ◽  
Shuanshi Fan ◽  
Songtian Fang ◽  
Xuemei Lang ◽  
Yanhong Wang ◽  
...  
Keyword(s):  
Growth Rate ◽  
Crystal Growth ◽  
Induction Time ◽  
Methane Hydrate ◽  
Hydrate Formation ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Inhibition Activity ◽  
Hydrate Crystal ◽  
Crystal Growth Inhibition

Abstract Pectin as a novel natural kinetic hydrate inhibitor, expected to be eco-friendly and sufficiently biodegradable, was studied in this paper. The novel crystal growth inhibition (CGI) and standard induction time methods were used to evaluate its effect as hydrate inhibitor. It could successfully inhibit methane hydrate formation at subcooling temperature up to 12.5 °C and dramatically slowed the hydrate crystal growth. The dosage of pectin decreased by 66% and effective time extended 10 times than typical kinetic inhibitor. Besides, its maximum growth rate was no more than 2.0%/h, which was far less than 5.5%/h of growth rate for PVCap at the same dosage. The most prominent feature was that it totally inhibited methane hydrate crystal rapid growth when hydrate crystalline occurred. Moreover, in terms of typical natural inhibitors, the inhibition activity of pectin increased 10.0-fold in induction time and 2.5-fold in subcooling temperature. The extraordinary inhibition activity is closely related to its hydrogen bonding interaction with water molecules and the hydrophilic structure. Finally, the biodegradability and economical efficiency of pectin were also taken into consideration. The results showed the biodegradability improved 75.0% and the cost reduced by more than 73.3% compared to typical commercial kinetic inhibitors.

The inhibition of tetrahydrofuran clathrate-hydrate formation with antifreeze protein

2003 ◽  
Vol 81 (1-2) ◽  
pp. 17-24 ◽  
Author(s):  
H Zeng ◽  
L D Wilson ◽  
V K Walker ◽  
J A Ripmeester
Keyword(s):  
Induction Time ◽  
Crystal Morphology ◽  
Choristoneura Fumiferana ◽  
Hydrate Formation ◽  
Antifreeze Protein ◽  
Clathrate Hydrate ◽  
Inhibition Mechanism ◽  
Type I ◽  
Inhibition Activity ◽  
Hydrate Crystal

The effect of Type I fish antifreeze protein (AFP) from the winter flounder, Pleuronectes americanus (Walbaum), (WfAFP) on the formation of tetrahydrofuran (THF) clathrate hydrate was studied by observing changes in THF crystal morphology and determining the induction time for nucleation. AFP retarded THF clathrate-hydrate growth at the tested temperatures and modified the THF clathrate-hydrate crystal morphology from octahedral to plate-like. AFP appears to be even more effective than the kinetic inhibitor, polyvinylpyrrolidone (PVP). Recombinant AFP from an insect, a spruce budworm, Choristoneura fumiferana (Clem.), moth, (Cf) was also tested for inhibition activity by observation of the THF-hydrate-crystal-growth habit. Like WfAFP, CfAFP appeared to show adsorption on multiple THF-hydrate-crystal faces. A protein with no antifreeze activity, cytochrome C, was used as a control and it neither changed the morphology of the THF clathrate-hydrate crystals, nor retarded the formation of the hydrate. Preliminary experiments on the inhibition activity of WfAFP on a natural gas hydrate assessed induction time and the amount of propane gas consumed. Similar to the observations for THF, the data indicated that WfAFP inhibited propane-hydrate growth. Taken together, these results support our hypothesis that AFPs can inhibit clathrate-hydrate growth and as well, offer promise for the understanding of the inhibition mechanism. PACS No.: 87.90ty

Growth of Triglycine Sulfate (Tgs) Crystals by Solution Technique

1981 ◽  
Vol 9 ◽  
Author(s):  
R. B. Lal ◽  
R. L. Kroes ◽  
W. R. Wilcox
Keyword(s):  
Growth Rate ◽  
Crystal Growth ◽  
Mass Transport ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Triglycine Sulfate ◽  
Solution Technique ◽  
Flight Experiment ◽  
Buoyancy Driven Convection ◽  
And Diffusion

ABSTRACTThe growth of crystals from solution is greatly influenced by buoyancy driven convection. In a low-g environment, convection is greatly suppressed and diffusion becomes the predominant mechanism for thermal and mass transport. An experiment to grow TGS crystals by solution technique during the orbital Spacelab III mission has been designed. Crystals are grown by a new and unique technique of extracting heat from the crystal through a sting. The cooling at the sting tip is responsible for the desired supersaturation near the growing crystal. Calculations indicate that the cooled sting technique for solution crystal growth is necessary in low-g to maintain a maximum growth rate of 1 mm/day. Results of groundbased work in support of the flight experiment are discussed.

Solidification of YBa2Cu3O6+δ: Part I. Morphology

1998 ◽  
Vol 13 (3) ◽  
pp. 565-573 ◽  
Author(s):  
Hua Shen ◽  
Merton C. Flemings ◽  
Michael J. Cima ◽  
John Haggerty ◽  
Shoichi Honjo ◽  
...  
Keyword(s):  
Growth Rate ◽  
Crystal Growth ◽  
Single Crystal ◽  
Dendritic Growth ◽  
Maximum Growth ◽  
Single Crystal Growth ◽  
Maximum Growth Rate ◽  
Growth Interface ◽  
Particle Spacing ◽  
Microstructural Examination

A new quenching technique was used for detailed microstructural examination of quenched YBa2Cu3O6+δ/liquid interfaces. The examination revealed that the growth rate and the amount of excess Y2BaCuO5 (211) had a strong influence on the growth morphology of YBa2Cu3O6+δ (123). The maximum growth rate at which single crystal growth could be obtained increased from 1 μm/s to 1.5 μm/s as excess 211 content increased from 0 to 20 wt. %. It then decreased to 1 μm/s as excess 211 increased to 40 wt. %. Dendritic growth with distinguishable secondary arms occurred for stoichiometric 123 samples in the regime of cellular/dendritic growth. A highly curved 123 envelope was formed on 211 particles located at the 123 growth interface for stoichiometric 123 samples in the regime of single crystal growth. The microscopic 123 growth interface became flat as excess 211 content increased to 20 wt. %. The engulfment of 211 particles into 123 matrix is discussed based on detailed microstructural examination. It is found that the formation of a small highly curved 123 envelope on 211 particles for stoichiometric 123 samples is due to the large 211 particle spacing.

A note on growth curves of rabbit lines selected on growth rate or litter size

1993 ◽  
Vol 57 (2) ◽  
pp. 332-334 ◽  
Author(s):  
A. Blasco ◽  
E. Gómez
Keyword(s):  
Growth Rate ◽  
Litter Size ◽  
Growth Curves ◽  
Live Weight ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Standard Errors ◽  
Adult Weight ◽  
Weight Growth ◽  
Using Data

Two synthetic lines of rabbits were used in the experiment. Line V, selected on litter size, and line R, selected on growth rate. Ninety-six animals were randomly collected from 48 litters, taking a male and a female each time. Richards and Gompertz growth curves were fitted. Sexual dimorphism appeared in the line V but not in the R. Values for b and k were similar in all curves. Maximum growth rate took place in weeks 7 to 8. A break due to weaning could be observed in weeks 4 to 5. Although there is a remarkable similarity of the values of all the parameters using data from the first 20 weeks only, the higher standard errors on adult weight would make 30 weeks the preferable time to take data for live-weight growth curves.

Reassessment of Maximum Growth Rates for C3 and C4 Crops

1978 ◽  
Vol 14 (1) ◽  
pp. 1-5 ◽  
Author(s):  
J. L. Monteith
Keyword(s):  
Growth Rate ◽  
Growth Rates ◽  
Growing Season ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Crop Growth ◽  
Close Inspection ◽  
Similar Difference ◽  
Photosynthetic Efficiencies

SUMMARYFigures for maximum crop growth rates, reviewed by Gifford (1974), suggest that the productivity of C3 and C4 species is almost indistinguishable. However, close inspection of these figures at source and correspondence with several authors revealed a number of errors. When all unreliable figures were discarded, the maximum growth rate for C3 stands fell in the range 34–39 g m−2 d−1 compared with 50–54 g m−2 d−1 for C4 stands. Maximum growth rates averaged over the whole growing season showed a similar difference: 13 g m−2 d−1 for C3 and 22 g m−2 d−1 for C4. These figures correspond to photosynthetic efficiencies of approximately 1·4 and 2·0%.

Kinetic analysis of dual impellers on methane hydrate formation

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Sotirios Nik Longinos ◽  
Mahmut Parlaktuna
Keyword(s):  
Power Consumption ◽  
Kinetic Analysis ◽  
Induction Time ◽  
Methane Hydrate ◽  
Formation Rate ◽  
Hydrate Formation ◽  
Mixed Flow ◽  
Pitched Blade Turbine ◽  
Decline Rate

Abstract This study investigates the effects of types of impellers and baffles on methane hydrate formation. Induction time, water conversion to hydrates (hydrate yield), hydrate formation rate and hydrate productivity are components that were estimated. The initial hydrate formation rate is generally higher with the use of Ruston turbine (RT) with higher values 28.93 × 10−8 mol/s in RT/RT with full baffle (FB) experiment, but the decline rate of hydrate formation was also high compared to up-pumping pitched blade turbine (PBTU). Power consumption is higher also in RT/RT and PBT/RT with higher value 392,000 W in PBT/RT with no baffle (NB) experiment compared to PBT/PBT and RT/PBT experiments respectively. Induction time values are higher in RT/RT experiments compared to PBT/PBT ones. Hydrate yield is always smaller when there is no baffle in all four groups of experiments while the higher values exist in experiments with full baffle. It should be noticed that PBT is the same with PBTU, since all experiments with mixed flow have upward trending.

Interpretation of Experimental Data with Regard to the Activated Sludge Model No.1 and Calibration of the Model for Municipal Wastewater Treatment Plants

1992 ◽  
Vol 25 (6) ◽  
pp. 167-183 ◽  
Author(s):  
H. Siegrist ◽  
M. Tschui
Keyword(s):  
Experimental Data ◽  
Growth Rate ◽  
Activated Sludge ◽  
Municipal Wastewater ◽  
Wastewater Treatment Plants ◽  
Treatment Plant ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Municipal Wastewater Treatment ◽  
Activated Sludge Model

The wastewater of the municipal treatment plants Zürich-Werdhölzli (350000 population equivalents), Zürich-Glatt (110000), and Wattwil (20000) have been characterized with regard to the activated sludge model Nr.1 of the IAWPRC task group. Zürich-Glatt and Wattwil are partly nitrifying treatment plants and Zürich-Werdhölzli is fully nitrifying. The mixing characteristics of the aeration tanks at Werdhölzli and Glatt were determined with sodium bromide as a tracer. The experimental data were used to calibrate hydrolysis, heterotrophic growth and nitrification. Problems arising by calibrating hydrolysis of the paniculate material and by measuring oxygen consumption of heterotrophic and nitrifying microorganisms are discussed. For hydrolysis the experimental data indicate first-order kinetics. For nitrification a maximum growth rate of 0.40±0.07 d−1, corresponding to an observed growth rate of 0.26±0.04 d−1 was calculated at 10°C. The half velocity constant found for 12 and 20°C was 2 mg NH4-N/l. The calibrated model was verified with experimental dam of me Zürich-Werdhölzli treatment plant during ammonia shock load.

Sign in / Sign up

Export Citation Format

Share Document