scholarly journals Researches on Cellulose, II (1900-1905)

Nature ◽  
1906 ◽  
Vol 75 (1937) ◽  
pp. 147-148
Author(s):  
ARTHUR HARDEN
Keyword(s):  
Cellulose Ii

scholarly journals Stable, metastable and unstable cellulose solutions

2017 ◽  
Vol 4 (8) ◽  
pp. 170487 ◽  
Author(s):  
Marta Gubitosi ◽  
Pegah Nosrati ◽  
Mona Koder Hamid ◽  
Stefan Kuczera ◽  
Manja A. Behrens ◽  
...  
Keyword(s):  
Microcrystalline Cellulose ◽  
Small Angle ◽  
Supersaturated Solution ◽  
Cellulose Ii ◽  
Cellulose I ◽  
Tetrabutylammonium Hydroxide ◽  
X Ray ◽  
Stable Regime ◽  
X Ray Scattering ◽  
A Minor

We have characterized the dissolution state of microcrystalline cellulose (MCC) in aqueous tetrabutylammonium hydroxide, TBAH(aq), at different concentrations of TBAH, by means of turbidity and small-angle X-ray scattering. The solubility of cellulose increases with increasing TBAH concentration, which is consistent with solubilization driven by neutralization. When comparing the two polymorphs, the solubility of cellulose I is higher than that of cellulose II. This has the consequence that the dissolution of MCC (cellulose I) may create a supersaturated solution with respect to cellulose II. As for the dissolution state of cellulose, we identify three different regimes. (i) In the stable regime, corresponding to concentrations below the solubility of cellulose II, cellulose is molecularly dissolved and the solutions are thermodynamically stable. (ii) In the metastable regime, corresponding to lower supersaturations with respect to cellulose II, a minor aggregation of cellulose occurs and the solutions are kinetically stable. (iii) In the unstable regime, corresponding to larger supersaturations, there is macroscopic precipitation of cellulose II from solution. Finally, we also discuss strong alkali solvents in general and compare TBAH(aq) with the classical NaOH(aq) solvent.

The thermal expansion of cellulose II and IIIII crystals

Cellulose ◽  
2006 ◽  
Vol 13 (3) ◽  
pp. 281-290 ◽  
Author(s):  
Ritsuko Hori ◽  
Masahisa Wada
Keyword(s):  
Thermal Expansion ◽  
Cellulose Ii

Eco-Friendly Preparation of Nanofibrillated Cellulose from Water Hyacinth Using NaOH/Urea Pretreatment

2020 ◽  
Vol 990 ◽  
pp. 225-230
Author(s):  
Kraiwit Pakutsah ◽  
Duangdao Aht-Ong
Keyword(s):  
Crystal Structure ◽  
Electron Microscopy ◽  
Water Hyacinth ◽  
Aqueous Suspension ◽  
Nanofibrillated Cellulose ◽  
Cellulose Ii ◽  
Cellulose I ◽  
X Ray ◽  
Transmission Electron ◽  
Water Hyacinth Fiber

In this work, we described an effective approach to prepare nanofibrillated cellulose (NFC) with cellulose II structure under mild condition. Firstly, the water hyacinth (WH) was subjected to a series of a two-step chemical treatment, NaOH/urea pretreatment, and mechanical defibrillation at different defibrillation times. After that, raw water hyacinth fiber (RWF), bleached water hyacinth fiber (BWF), NaOH/urea pretreated water hyacinth fiber (PWF), and the resulting NFC were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), thermogravimetric analysis (TGA), Fourier transform infrared spectroscopy (FTIR), X-ray diffractometry (XRD) as well as rheological measurements. It was found that RWF and BWF exhibited cellulose I crystal structure, whereas PWF and the obtained NFC possessed cellulose II crystal structure. FTIR analysis confirmed the evidence that no other chemical reactions preferentially occurred during both NaOH/urea pretreatment and mechanical defibrillation. As evidenced by rheological properties analysis, the NFC aqueous suspension with a gel-like structure demonstrated a shear-thinning behavior. The obtained NFC could potentially be utilized as a reinforcement for polymeric composites.

scholarly journals Spinning Cellulose Hollow Fibers Using 1-Ethyl-3-methylimidazolium Acetate–Dimethylsulfoxide Co-Solvent

Polymers ◽  
2018 ◽  
Vol 10 (9) ◽  
pp. 972 ◽  
Author(s):  
Linfeng Lei ◽  
Arne Lindbråthen ◽  
Marius Sandru ◽  
Maria Gutierrez ◽  
Xiangping Zhang ◽  
...  
Keyword(s):  
Hollow Fiber ◽  
Average Diameter ◽  
Hollow Fibers ◽  
Cellulose Ii ◽  
Cellulose I ◽  
Structure Transition ◽  
Carbon Membranes ◽  
Ftir Characterization ◽  
Dope Solution ◽  
Mild Temperature

The mixture of the ionic liquid 1-ethyl-3-methylimidazolium acetate (EmimAc) and dimethylsulfoxide (DMSO) was employed to dissolve microcrystalline cellulose (MCC). A 10 wt % cellulose dope solution was prepared for spinning cellulose hollow fibers (CHFs) under a mild temperature of 50 °C by a dry–wet spinning method. The defect-free CHFs were obtained with an average diameter and thickness of 270 and 38 µm, respectively. Both the XRD and FTIR characterization confirmed that a crystalline structure transition from cellulose I (MCC) to cellulose II (regenerated CHFs) occurred during the cellulose dissolution in ionic liquids and spinning processes. The thermogravimetric analysis (TGA) indicated that regenerated CHFs presented a similar pyrolysis behavior with deacetylated cellulose acetate during pyrolysis process. This study provided a suitable way to directly fabricate hollow fiber carbon membranes using cellulose hollow fiber precursors spun from cellulose/(EmimAc + DMSO)/H2O ternary system.

Sign in / Sign up

Export Citation Format

Share Document