Effects of sine wave contexts on compensation for coarticulation

2009 ◽  
Author(s):  
Navin Viswanathan ◽  
James S. Magnuson ◽  
Carol A. Fowler
Keyword(s):  
Sine Wave

High-precision Steady Speed Flywheel System based on Sine Wave Drive

2019 ◽  
Author(s):  
Enyu Ma ◽  
Hui Zhao ◽  
Shuo Chen ◽  
Shuai Wang ◽  
Xin Huo ◽  
...  
Keyword(s):  
High Precision ◽  
Sine Wave ◽  
Wave Drive

Trombone Transfer Functions: Comparison Between Frequency-Swept Sine Wave and Human Performer Input

2012 ◽  
Vol 37 (4) ◽  
pp. 447-454
Author(s):  
James W. Beauchamp
Keyword(s):  
Transfer Function ◽  
Transfer Functions ◽  
Cutoff Frequency ◽  
Sine Wave ◽  
Nonlinear Propagation ◽  
Linear Filter ◽  
Wave System ◽  
General Effect ◽  
Filter Characteristic ◽  
High Pass

Abstract Source/filter models have frequently been used to model sound production of the vocal apparatus and musical instruments. Beginning in 1968, in an effort to measure the transfer function (i.e., transmission response or filter characteristic) of a trombone while being played by expert musicians, sound pressure signals from the mouthpiece and the trombone bell output were recorded in an anechoic room and then subjected to harmonic spectrum analysis. Output/input ratios of the signals’ harmonic amplitudes plotted vs. harmonic frequency then became points on the trombone’s transfer function. The first such recordings were made on analog 1/4 inch stereo magnetic tape. In 2000 digital recordings of trombone mouthpiece and anechoic output signals were made that provide a more accurate measurement of the trombone filter characteristic. Results show that the filter is a high-pass type with a cutoff frequency around 1000 Hz. Whereas the characteristic below cutoff is quite stable, above cutoff it is extremely variable, depending on level. In addition, measurements made using a swept-sine-wave system in 1972 verified the high-pass behavior, but they also showed a series of resonances whose minima correspond to the harmonic frequencies which occur under performance conditions. For frequencies below cutoff the two types of measurements corresponded well, but above cutoff there was a considerable difference. The general effect is that output harmonics above cutoff are greater than would be expected from linear filter theory, and this effect becomes stronger as input pressure increases. In the 1990s and early 2000s this nonlinear effect was verified by theory and measurements which showed that nonlinear propagation takes place in the trombone, causing a wave steepening effect at high amplitudes, thus increasing the relative strengths of the upper harmonics.

Development of Pure Sine Wave Inversion System with Inbuilt Charging and Display Mechanisms

2018 ◽  
Vol 3 (2) ◽  
pp. 1-6
Author(s):  
Raji A. Abimbola
Keyword(s):  
Energy Demand ◽  
Noise Pollution ◽  
Sine Wave ◽  
Maintenance Cost ◽  
Air Conditioner ◽  
Health It ◽  
Power Generator ◽  
Available Energy ◽  
Wave Inversion ◽  
Running Cost

In recent years, Nigeria’s power generation output from all the available energy sources such as coal, natural gas, and water, is far from the expected number required to meet the energy demand of her teeming populace. This culminates in long hours of power outages frequently experienced in many parts of the country. However, there appears to be no end in sight to the problem. Alternatively, few citizens who can afford generator have wittingly resulted to the use of this device to supply power. Generator set has unavoidable disadvantages of high maintenance or running cost, noise pollution, and release of dangerous gases that pose danger to human lives. Evidently, that solution is risky and inadequate. Power inverter is an alternative and better means of generating electricity with little or no maintenance cost, environment or eco- friendly and poses no risk to human health. It is in that connection that we develop in this work 2KVA sine wave inversion system which produces sinusoidal A.C. signal required in homes for lightning and powering electronic gadgets like television, radio, refrigerator, Air conditioner etc. It is an improvement over square wave and modified sine wave inversion systems that generate digital approximations of A.C. signal. An interesting but new addition is the use of LCD display, interfaced with PIC16F688 microcontroller for showing the design specifications of the inverter.

Multicenter Comparison of Truncated Biphasic Shocks and Standard Damped Sine Wave Monophasic Shocks for Transthoracic Ventricular Defibrillation

Circulation ◽  
1996 ◽  
Vol 94 (10) ◽  
pp. 2507-2514 ◽  
Author(s):  
Gust H. Bardy ◽  
Francis E. Marchlinski ◽  
Arjun D. Sharma ◽  
Seth J. Worley ◽  
Richard M. Luceri ◽  
...  
Keyword(s):  
Sine Wave ◽  
Ventricular Defibrillation

scholarly journals The Power Losses in Cable Lines Supplying Nonlinear Loads

Energies ◽  
2021 ◽  
Vol 14 (5) ◽  
pp. 1374
Author(s):  
Bartosz Rozegnał ◽  
Paweł Albrechtowicz ◽  
Dominik Mamcarz ◽  
Monika Rerak ◽  
Maciej Skaza
Keyword(s):  
Bessel Function ◽  
Cross Section ◽  
Power Loss ◽  
Sine Wave ◽  
Active Power ◽  
New Method ◽  
Power Losses ◽  
Nonlinear Loads ◽  
Current Harmonics ◽  
Cable Lines

This paper presents the skin effect impact on the active power losses in the sheathless single-core cables/wires supplying nonlinear loads. There are significant conductor losses when the current has a distorted waveform (e.g., the current supplying diode rectifiers). The authors present a new method for active power loss calculation. The obtained results have been compared to the IEC-60287-1-1:2006 + A1:2014 standard method and the method based on the Bessel function. For all methods, the active power loss results were convergent for small-cable cross-section areas. The proposed method gives smaller power loss values for these cable sizes than the IEC and Bessel function methods. For cable cross-section areas greater than 185 mm2, the obtained results were better than those for the other methods. There were also analyses of extra power losses for distorted currents compared to an ideal 50 Hz sine wave for all methods. The new method is based on the current penetration depth factor calculated for every considered current harmonics, which allows us to calculate the precise equivalent resistance for any cable size. This research is part of our work on a cable thermal analysis method that has been developed.

Sign in / Sign up

Export Citation Format

Share Document