Numerical Simulation Techniques for Modeling Advectively-Disturbed Thermal Regimes

2013 ◽  
pp. 1-5 ◽  
Author(s):  
Leslie Smith ◽  
Craig Forster ◽  
Allan Woodbury
Keyword(s):  
Numerical Simulation ◽  
Simulation Techniques ◽  
Thermal Regimes

Simulation and Modeling of Turbulent Flows

1996 ◽  
Keyword(s):  
Numerical Simulation ◽  
Turbulent Flow ◽  
Turbulent Flows ◽  
Simulation And Modeling ◽  
Simulation Techniques ◽  
Rational Development ◽  
Group Methods ◽  
Turbulent Closure ◽  
The Subject ◽  
Renormalization Group Methods

This book provides students and researchers in fluid engineering with an up-to-date overview of turbulent flow research in the areas of simulation and modeling. A key element of the book is the systematic, rational development of turbulence closure models and related aspects of modern turbulent flow theory and prediction. Starting with a review of the spectral dynamics of homogenous and inhomogeneous turbulent flows, succeeding chapters deal with numerical simulation techniques, renormalization group methods and turbulent closure modeling. Each chapter is authored by recognized leaders in their respective fields, and each provides a thorough and cohesive treatment of the subject.

A Comparison of Self-Rectifying Turbines for OWC Based Wave Energy Power Extracting Device Using Numerical Simulation

2002 ◽  
Author(s):  
A. R. Ansari ◽  
H. B. Khaleeq ◽  
A. Thakker
Keyword(s):  
Numerical Simulation ◽  
Wave Energy ◽  
Sea Water ◽  
Time History ◽  
Flow Conditions ◽  
Wells Turbine ◽  
Impulse Turbine ◽  
Simulation Techniques ◽  
Simple Geometry ◽  
Wide Range

This paper presents a comparison of self-rectifying turbines for the Oscillating Water Column (OWC) based Wave Energy power extracting device using numerical simulation. The two most commonly used turbines for OWC based devices, the Impulse and the Wells turbines were evaluated under real sea simulated conditions. Assuming the quasi-steady condition, experimental data for both 0.6m turbines with 0.6 hub to tip ratio was used to predict their behavior under real sea conditions. The real sea water surface elevation time history data was used to simulate the flow conditions using standard numerical simulation techniques. A simple geometry of the OWC was considered for the simulation. The results show that the overall mean performance of an Impulse turbine is better than the Wells turbine under unsteady, irregular real sea conditions. The Impulse turbine was observed to be more stable over a wide range of flow conditions. This paper reports the comparison of performance characteristics of both these turbines under simulated real sea conditions.

Modelling a helicopter rotor’s response to wake encounters

2004 ◽  
Vol 108 (1079) ◽  
pp. 15-26 ◽  
Author(s):  
G. R. Whitehouse ◽  
R. E. Brown
Keyword(s):  
Numerical Simulation ◽  
Numerical Simulations ◽  
Helicopter Rotor ◽  
Forward Speed ◽  
Transport Aircraft ◽  
Simulation Techniques ◽  
Airport Capacity ◽  
Aircraft Wake ◽  
The Impact ◽  
Rotary Wing

In recent years, various strategies for the concurrent operation of fixed-and rotary-wing aircraft have been proposed as a means of increasing airport capacity. Some of these strategies will increase the likelihood of encounters with the wakes of aircraft operating nearby. Several studies now exist where numerical simulations have been used to assess the impact of encounters with the wakes of large transport aircraft on the safety of helicopter operations under such conditions. This paper contrasts the predictions of several commonly-used numerical simulation techniques when each is used to model the dynamics of a helicopter rotor during the same idealised wake encounter. In most previous studies the mutually-induced distortion of the wakes of the rotor and the interacting aircraft has been neglected, yielding the so-called ‘frozen vortex’ assumption. This assumption is shown to be valid only when the helicopter encounters the aircraft wake at high forward speed. At the low forward speeds most relevant to near-airfield operations, however, injudicious use of the frozen vortex assumption may lead to significant errors in predicting the severity of a helicopter’s response to a wake encounter.

Categorized Application Technology of Numerical Simulation on Electronic Equipment Thermal Design

2009 ◽  
Author(s):  
Yasuyuki Yokono ◽  
Katsumi Hisano ◽  
Kenji Hirohata
Keyword(s):  
Numerical Simulation ◽  
Product Development ◽  
Statistical Approach ◽  
Thermal Design ◽  
Electronic Equipment ◽  
Product Development Process ◽  
Design Stage ◽  
Application Technology ◽  
Simulation Techniques ◽  
Simulation Based

In order to utilize a numerical simulation on a product development for electronic equipment, not only the simulation techniques themselves, but the application technologies of the simulation in the product design, were examined. The design process of electronic equipment was categorized into four stages, which were a concept, a function, a layout and a parameter design. Each design stage consists of a specifying that a human decide the specification for the next stage and a verification whether the specification satisfy the previous stage requirements. The specifying and the verification are conducted over and over again. Numerical simulation is corresponded to the verification and is used to accelerate this iteration instead of experiments. The examples of numerical simulation corresponding to these four verifications were shown in the present paper. There are few examples in last two type of simulation. The progress of the numerical technology for function and concept verification is expected. The product development process requires not only numerical simulation based on physics but also statistical approach.

scholarly journals 500.09 SimulTAVI - Personalized Medicine: Predicting Device Behaviour and Possible Outcomes of a TAVI by Using Image Processing and Numerical Simulation Techniques

2019 ◽  
Vol 12 (4) ◽  
pp. S41
Author(s):  
Marcos Loureiro-Ga ◽  
Cesar Veiga ◽  
Generosa Fdez-Manin ◽  
Pablo Juan Salvadores ◽  
Victor A. Jimenez ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Image Processing ◽  
Personalized Medicine ◽  
Simulation Techniques
Sign in / Sign up

Export Citation Format

Share Document