Electron microscopy, neutron diffraction, and physical properties of bismuth strontium copper oxide (Bi4Sr8Cu5O19+y)

1991 ◽  
Vol 3 (5) ◽  
pp. 844-852 ◽  
Author(s):  
M. T. Caldes ◽  
J. M. Navarro ◽  
F. Perez ◽  
M. Carrera ◽  
J. Fontcuberta ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Neutron Diffraction ◽  
Physical Properties ◽  
Copper Oxide ◽  
Strontium Copper Oxide

ChemInform Abstract: Electron Microscopy, Neutron Diffraction, and Physical Properties of Bi4Sr8Cu5O19+y.

ChemInform ◽  
2010 ◽  
Vol 23 (1) ◽  
pp. no-no
Author(s):  
M. T. CALDES ◽  
J. M. NAVARRO ◽  
F. PEREZ ◽  
M. CARRERA ◽  
J. FONTCUBERTA ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Neutron Diffraction ◽  
Physical Properties

The Infection of Cells by Bullet-Shaped Viruses

1969 ◽  
Vol 27 ◽  
pp. 372-373
Author(s):  
Frederick A. Murphy ◽  
Alyne K. Harrison ◽  
Sylvia G. Whitfield
Keyword(s):  
Electron Microscopy ◽  
Physical Properties ◽  
Host Cell ◽  
Thin Section ◽  
Cultured Cells ◽  
Cell Infection ◽  
Thin Section Electron Microscopy ◽  
Section Electron ◽  
Section Electron Microscopy

The bullet-shaped viruses are currently classified together on the basis of similarities in virion morphology and physical properties. Biologically and ecologically the member viruses are extremely diverse. In searching for further bases for making comparisons of these agents, the nature of host cell infection, both in vivo and in cultured cells, has been explored by thin-section electron microscopy.

Surface reconstructions of (001) cleaved GdBa2Cu3O7-δ

1992 ◽  
Vol 50 (1) ◽  
pp. 106-107
Author(s):  
H.W. Zandbergen ◽  
M.R. McCartney
Keyword(s):  
Electron Microscopy ◽  
Copper Oxide ◽  
Grain Boundaries ◽  
Atomic Structure ◽  
Oxygen Deficiency ◽  
Surface Layers ◽  
Layer Sequence ◽  
Surface Reconstructions ◽  
Good Agreement

Very few electron microscopy papers have been published on the atomic structure of the copper oxide based superconductor surfaces. Zandbergen et al. have reported that the surface of YBa2Cu3O7-δ was such that the terminating layer sequence is bulk-Y-CuO2-BaO-CuO-BaO, whereas the interruption at the grain boundaries is bulk-Y-CuO2-BaO-CuO. Bursill et al. reported that HREM images of the termination at the surface are in good agreement with calculated images with the same layer sequence as observed by Zandbergen et al. but with some oxygen deficiency in the two surface layers. In both studies only one or a few surfaces were studied.

A study of oxygen and vacancy ordering in YBa2Cu3O7−x

1989 ◽  
Vol 47 ◽  
pp. 164-165
Author(s):  
Y. P. Lin ◽  
A. H. O’Reilly ◽  
J. E. Greedan ◽  
M. Post
Keyword(s):  
Electron Microscopy ◽  
Neutron Diffraction ◽  
Oxygen Content ◽  
Carbon Film ◽  
Nitrogen Atmosphere ◽  
Vacancy Ordering ◽  
Powder Samples ◽  
Vacancy Chains ◽  
Chain Ordering

In the basal planes of the orthorhombic YBa2Cu3O7-X compound with x=0.07, which has a Tc of around 90K, chains of copper-oxygen are formed along the [010] direction. Previous investigations on the variation of Tc with oxygen content have shown the existence of a plateau at Tc = 60K for x=0.3 to 0.4, suggesting the presence of a separate phase. This phase has also been identified to be orthorhombic, but with a 2x superlattice along [100] of the parent structure, and the superlattice has been attributed to the formation of alternating copper-oxygen and copper-vacancy chains. In our work, we have studied the chain ordering phenomenon by electron microscopy and neutron diffraction on samples with different oxygen contents. We report here some of our electron microscopy findings for samples with x=0.4.Powder samples of YBa2Cu3O7-X were prepared by controlled re-oxidation of previously reduced material. For electron microscopy, the sample was dry ground using a mortar and pestle in a dry nitrogen atmosphere without the use of any solvent and transferred dry onto holey carbon film for examination in a Philips CM12 microscope.

scholarly journals Fabrication and Physical Properties of Single-Crystalline Βeta-FeSi2 Nanowires

2020 ◽  
Vol 15 (1) ◽  
Author(s):  
Chih-Yung Yang ◽  
Shu-Meng Yang ◽  
Yu-Yang Chen ◽  
Kuo-Chang Lu
Keyword(s):  
Electron Microscopy ◽  
Physical Properties ◽  
Chemical Vapor ◽  
Chemical Vapor Deposition Method ◽  
Ferromagnetic Behavior ◽  
X Ray Diffraction ◽  
Field Emitters ◽  
Transmission Electron ◽  
Single Source Precursor ◽  
Carrier Gases

Abstract In this study, self-catalyzed β-FeSi2 nanowires, having been wanted but seldom achieved in a furnace, were synthesized via chemical vapor deposition method where the fabrication of β-FeSi2 nanowires occurred on Si (100) substrates through the decomposition of the single-source precursor of anhydrous FeCl3 powders at 750–950 °C. We carefully varied temperatures, duration time, and the flow rates of carrier gases to control and investigate the growth of the nanowires. The morphology of the β-FeSi2 nanowires was observed with scanning electron microscopy (SEM), while the structure of them was analyzed with X-ray diffraction (XRD) and transmission electron microscopy (TEM). The growth mechanism has been proposed and the physical properties of the iron disilicide nanowires were measured as well. In terms of the magnetization of β-FeSi2, nanowires were found to be different from bulk and thin film; additionally, longer β-FeSi2 nanowires possessed better magnetic properties, showing the room-temperature ferromagnetic behavior. Field emission measurements demonstrate that β-FeSi2 nanowires can be applied in field emitters.

Sign in / Sign up

Export Citation Format

Share Document