Absorption of Endoglucanase I and Cellobiohydrolase I ofTrichoderma reeseiduring Hydrolysis of Microcrystalline Cellulose

2000 ◽  
pp. 131-143 ◽  
Author(s):  
H. Ding ◽  
E. Vlasenko ◽  
C. Shoemaker ◽  
S. Shoemaker
Keyword(s):  
Microcrystalline Cellulose ◽  
Cellobiohydrolase I ◽  
Endoglucanase I ◽  
Hydrolysis Of

scholarly journals Purification, crystallization and preliminary crystallographic analysis of the catalytic domain of the extracellular cellulase CBHI fromTrichoderma harzianum

2010 ◽  
Vol 66 (9) ◽  
pp. 1041-1044 ◽  
Author(s):  
Francieli Colussi ◽  
Larissa C. Textor ◽  
Viviane Serpa ◽  
Roberto Nobuyuki Maeda ◽  
Nei Pereira ◽  
...  
Keyword(s):  
Microcrystalline Cellulose ◽  
Catalytic Domain ◽  
Crystallographic Analysis ◽  
Cellulolytic Activity ◽  
X Ray Diffraction ◽  
Cellobiohydrolase I ◽  
Data Set ◽  
Catalytic Core ◽  
Core Domain ◽  
Hydrolysis Of

The filamentous fungusTrichoderma harzianumhas a considerable cellulolytic activity that is mediated by a complex of enzymes which are essential for the hydrolysis of microcrystalline cellulose. These enzymes were produced by the induction ofT. harzianumwith microcrystalline cellulose (Avicel) under submerged fermentation in a bioreactor. The catalytic core domain (CCD) of cellobiohydrolase I (CBHI) was purified from the extracellular extracts and submitted to robotic crystallization. Diffraction-quality CBHI CCD crystals were grown and an X-ray diffraction data set was collected under cryogenic conditions using a synchrotron-radiation source.

The Formation of Plasma Acid at Atmospheric Pressure and its Application in Hydrolysis of Microcrystalline Cellulose

2013 ◽  
Vol 750-752 ◽  
pp. 1626-1629
Author(s):  
Bo Yuan ◽  
Ying Wang ◽  
Ying Chao Ji ◽  
Qiu Hong Wang
Keyword(s):  
Microcrystalline Cellulose ◽  
Atmospheric Pressure ◽  
High Performance ◽  
Barrier Discharge ◽  
Ph Value ◽  
Reducing Sugar ◽  
Dielectric Barrier ◽  
Integrated Optical ◽  
Hydrolysis Of ◽  
Single Factor Experiment

In this paper, plasma acid was obtained by treating distilled water with dielectric barrier discharge at atmospheric pressure in order to hydrolyze cellulose. The acidity of plasma acid was studied through a single factor experiment. A plasma acid with pH value of 1.42 was obtained and used to hydrolyze microcrystalline cellulose at 80°C for 60min. Under this condition, the integrated optical density (IOD) of the hydrolysis sample was 0.589. Based on standard glucose curve, the total reducing sugar (TRS) was calculated to be 53.75mg and the TRS yield was 53.75%. The filtrate was evaporated to get the solid hydrolysis sample to be analyzed by High-performance liquid chromatography (HPLC). The results showed that the sample mainly consisted of glucose, which proved that microcrystalline cellulose could be hydrolyzed by plasma acid. Therefore, it could be concluded that it was an environmentally friendly and economical method to hydrolyze the microcrystalline cellulose by plasma acid.

scholarly journals The role of cellulase concentration in determining the degree of synergism in the hydrolysis of microcrystalline cellulose

1988 ◽  
Vol 255 (3) ◽  
pp. 895-899 ◽  
Author(s):  
J Woodward ◽  
M Lima ◽  
N E Lee
Keyword(s):  
Microcrystalline Cellulose ◽  
Apparent Relationship ◽  
Beta Glucosidase ◽  
Hydrolysis Of

Microcrystalline cellulose (10 mg of Avicel/ml) was hydrolysed to glucose by different concentrations of the purified cellulase components endoglucanase (EG) II and cellobiohydrolases (CBH) I and II, alone and in combination with each other, in the presence of excess beta-glucosidase. At a concentration of 360 micrograms/ml (160 micrograms of EG II/ml, 100 micrograms of CBH I/ml and 100 micrograms of CBH II/ml) the degree of synergism among them was negligible. As the concentration of cellulase decreased, the degree of synergism increased, reaching an optimum at 20 micrograms/ml (5 micrograms of EG II/ml, 10 micrograms of CBH I/ml and 5 micrograms of CBH II/ml). There was no apparent relationship between the ratio of the components and the degree of synergism. The latter is probably due, though it could not be proved, to the level of saturation of the substrate with each component. Inhibition of Avicel hydrolysis was observed when the substrate was incubated with saturating and nonsaturating concentrations of a mixture of EG II and CBH I respectively. A similar result was also observed with a combination of EG I and EG II.

Evaluation of thermomechanical pretreatment for enzymatic hydrolysis of pure microcrystalline cellulose and cellulose from Brewers’ spent grain

2011 ◽  
Vol 54 (3) ◽  
pp. 305-310 ◽  
Author(s):  
Guillaume Pierre ◽  
Frédéric Sannier ◽  
Romain Goude ◽  
Armelle Nouviaire ◽  
Zoulikha Maache-Rezzoug ◽  
...  
Keyword(s):  
Enzymatic Hydrolysis ◽  
Microcrystalline Cellulose ◽  
Spent Grain ◽  
Hydrolysis Of

scholarly journals Bleaching of Microcrystalline Cellulose Produced by Gas-Phase Hydrolysis

2021 ◽  
pp. 173-183
Author(s):  
Alexander I. Sizov ◽  
◽  
Sergey D. Pimenov ◽  
Anastasia D. Stroiteleva ◽  
Katherine D. Stroiteleva ◽  
...  
Keyword(s):  
Hydrogen Peroxide ◽  
Pharmaceutical Industry ◽  
Gas Phase ◽  
Sodium Hypochlorite ◽  
Microcrystalline Cellulose ◽  
High Rate ◽  
Subsequent Formation ◽  
Hydrolysis Of Cellulose ◽  
Yellow Tint ◽  
Hydrolysis Of

One of the main consumers of microcrystalline cellulose (MCC) is the pharmaceutical industry, where MCC is used as a binder and filler in direct compression of tablets. MCC is produced by acidic hydrolysis of cellulose, which usually results in a decrease in whiteness. This is due to the destruction of sugars formed during hydrolysis and the subsequent formation of colored products. The composition and properties of these products depend on the method of hydrolysis, acid concentration, temperature, and process duration. One of the most promising methods for producing MCC is gas-phase hydrolysis of cellulose with hydrogen chloride gas-air mixtures. The method has a high rate of hydrolysis, low reagent and energy consumption. The requirements of the pharmaceutical industry determine the need to produce MCC with high whiteness. The research purpose is to select bleaching modes for MCC using sodium hypochlorite and hydrogen peroxide as bleaching agents. MCC produced by gas-phase hydrolysis of bleached wood pulp was used during the study. The whiteness and intensity of the yellow tint of MCC in the bleaching process were determined by digital colorimetry on a flatbed scanner. The paper shows that sodium hypochlorite and hydrogen peroxide allow achieving the whiteness not less than 90 % and the intensity of the yellow tint not more than 3 standard units. High-quality bleaching can be carried out even for MCC samples with an initial whiteness of about 40 %. The most effective bleaching agent is sodium hypochlorite when the pH of the bleaching solution is 2–3. Hydrogen peroxide also provides high whiteness of MCC at pH of 10–11. However, the consumption of active oxygen (AO) for bleaching is more than three times higher in comparison with the consumption of active chlorine (ACh). It was found that the dyes of MCC produced by gas-phase hydrolysis consist of two chromophore groups that decolorize at different rates. The easily oxidized group of components makes up about 90 % of the total amount of dyes, and the resistant to oxidation components make up about 10 % and determine the intensity of the yellow tint of MCC. The modes of bleaching MCC with sodium hypochlorite and hydrogen peroxide to product samples with whiteness comparable to that of imported samples were determined. For citation: Sizov A.I., Pimenov S.D., Stroiteleva A.D., Stroiteleva K.D. Bleaching of Microcrystalline Cellulose Produced by Gas-Phase Hydrolysis. Lesnoy Zhurnal [Russian Forestry Journal], 2021, no. 6, pp. 173–183. DOI: 10.37482/0536-1036-2021-6-173-183

Sign in / Sign up

Export Citation Format

Share Document