Photocatalytic Activity Suppression of Ag3PO4-Deposited Cu2O Octahedra and Rhombic Dodecahedra

2019 ◽  
Vol 123 (4) ◽  
pp. 2314-2320 ◽  
Author(s):  
Gollapally Naresh ◽  
An-Ting Lee ◽  
Vandana Meena ◽  
M. Satyanarayana ◽  
Michael H. Huang
Keyword(s):  
Photocatalytic Activity ◽  
Rhombic Dodecahedra

Photocatalytic Activity Suppression of CdS Nanoparticle-Decorated Cu2O Octahedra and Rhombic Dodecahedra

2018 ◽  
Vol 122 (24) ◽  
pp. 12944-12950 ◽  
Author(s):  
Jing-Yi Huang ◽  
Pei-Lun Hsieh ◽  
Gollapally Naresh ◽  
Hsin-Yi Tsai ◽  
Michael H. Huang
Keyword(s):  
Photocatalytic Activity ◽  
Cds Nanoparticle ◽  
Rhombic Dodecahedra

Photocatalytic degradation of methylene blue from aqueous solutions using nanopillars-TiO2 thin films: Batch reactor studies

2018 ◽  
Vol 18 (3) ◽  
pp. 81-91 ◽  
Author(s):  
C. Lalhriatpuia
Keyword(s):  
Thin Films ◽  
Methylene Blue ◽  
Photocatalytic Activity ◽  
Organic Carbon ◽  
Photocatalytic Degradation ◽  
Batch Reactor ◽  
Tio2 Thin Films ◽  
Initial Concentration ◽  
Bet Specific Surface Area ◽  
Interfering Ions

Nanopillars-TiO2 thin films was obtained on a borosilicate glass substrate with (S1) and without (S2) polyethylene glycol as template. The photocatalytic behaviour of S1 and S2 thin films was assessed inthe degradation of methylene blue (MB) dye from aqueous solution under batch reactor operations. The thin films were characterized by the SEM, XRD, FTIR and AFM analytical methods. BET specific surface area and pore sizes were also obtained. The XRD data confirmed that the TiO2 particles are in its anatase mineral phase. The SEM and AFM images indicated the catalyst is composed with nanosized pillars of TiO2, evenly distributed on the surface of the substrate. The BET specific surface area and pore sizes of S1 and S2 catalyst were found to be 5.217 and 1.420 m2/g and 7.77 and 4.16 nm respectively. The photocatalytic degradation of MB was well studied at wide range of physico-chemical parameters. The effect of solution pH (pH 4.0 to 10.0) and MB initial concentration (1.0 to 10.0 mg/L) was extensively studied and the effect of several interfering ions, i.e., cadmium nitrate, copper sulfate, zinc chloride, sodium chloride, sodium nitrate, sodium nitrite, glycine, oxalic acid and EDTA in the photocatalytic degradation of MB was demonstrated. The maximum percent removal of MB was observed at pH 8.0 beyond which it started decreasing and a low initial concentration of the pollutant highly favoured the photocatalytic degradation using thin films and the presence of several interfering ions diminished the photocatalytic activity of thin films to some extent. The overall photocatalytic activity was in the order: S2 > S1 > UV. The photocatalytic degradation of MB was followed the pseudo-first-order rate kinetics. The mineralization of MB was studied with total organic carbon measurement using the TOC (total organic carbon) analysis.

Photocatalytic activity of TiO2 synthesized by anodization and anodic spark deposition

MRS Advances ◽  
2020 ◽  
Vol 5 (61) ◽  
pp. 3141-3152
Author(s):  
Alma C. Chávez-Mejía ◽  
Génesis Villegas-Suárez ◽  
Paloma I. Zaragoza-Sánchez ◽  
Rafael Magaña-López ◽  
Julio C. Morales-Mejía ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Photocatalytic Activity ◽  
Surface Characteristics ◽  
Amorphous Solids ◽  
X Ray Diffraction ◽  
X Ray ◽  
Catalytic Activities ◽  
Anodic Spark Oxidation ◽  
Porous Surfaces ◽  
Scanning Electron

AbstractSeveral photocatalysts, based on titanium dioxide, were synthesized by spark anodization techniques and anodic spark oxidation. Photocatalytic activity was determined by methylene blue oxidation and the catalytic activities of the catalysts were evaluated after 70 hours of reaction. Scanning Electron Microscopy and X Ray Diffraction analysis were used to characterize the catalysts. The photocatalyst prepared with a solution of sulfuric acid and 100 V presented the best performance in terms of oxidation of the dye (62%). The electric potential during the synthesis (10 V, low potential; 100 V, high potential) affected the surface characteristics: under low potential, catalyst presented smooth and homogeneous surfaces with spots (high TiO2 concentration) of amorphous solids; under low potential, catalyst presented porous surfaces with crystalline solids homogeneously distributed.

Impact of Rutile Fraction on TiO2 Visible-Light Absorption and Visible-Light-Induced Photocatalytic Activity

2018 ◽  
Author(s):  
David Maria Tobaldi ◽  
Luc Lajaunie ◽  
ana caetano ◽  
nejc rozman ◽  
Maria Paula Seabra ◽  
...  
Keyword(s):  
Photocatalytic Activity ◽  
Visible Light ◽  
Light Absorption ◽  
Solid Phase ◽  
Diffraction Method ◽  
Band Alignment ◽  
Quantitative Phase Analysis ◽  
Transmission Microscopy ◽  
Visible Light Absorption ◽  
X Ray

<div>Titanium dioxide is by far the most utilised semiconductor material for photocatalytic applications. Still, it is transparent to visible-light. Recently, it has been proved that a type-II band alignment for the rutile−anatase mixture would improve its visible-light absorption.</div><div>In this research paper we thoroughly characterised the real crystalline and amorphous phases of synthesised titanias – thermally treated at different temperatures to get distinct ratios of anatase-rutile-amorphous fraction – as well as that of three commercially available photocatalytic nano-TiO2. </div><div>The structural characterisation was done via advanced X-ray diffraction method, namely the Rietveld-RIR method, to attain a full quantitative phase analysis of the specimens. The microstructure was also investigated via an advanced X-ray method, the whole powder pattern modelling. These methods were validated combining advanced aberration-corrected scanning transmission microscopy and high-resolution electron energy-loss spectroscopy. The photocatalytic activity was assessed in the liquid- and gas-solid phase (employing rhodamine B and 4-chlorophenol, and isopropanol, respectively, as the organic substances to degrade) using a light source irradiating exclusively in the visible-range.</div><div>Optical spectroscopy showed that even a small fraction of rutile (2 wt%) is able to shift to lower energies the apparent optical band gap of an anatase-rutile mixed phase. But is this enough to attain a real photocatalytic activity promoted by merely visible-light?</div><div>We tried to give a reply to that question.</div><div>Photocatalytic activity results in the liquid-solid phase showed that a high surface hydroxylation led to specimen with superior visible light-induced catalytic activity (i.e. dye and ligand-to-metal charge transfer complexes sensitisation effects). That is: not photocatalysis <i>sensu-strictu</i>.</div><div>On the other hand, the gas-solid phase results showed that a higher amount of the rutile fraction (around 10 wt%), together with less recombination of the charge carriers, were more effective for an actual photocatalytic oxidation of isopropanol.</div>

Crystal Engineering of Bi2WO6 to Polar Aurivillius-Phase Oxyhalides

2019 ◽  
Author(s):  
Kazuki Morita ◽  
Ji-Sang Park ◽  
Sunghyun Kim ◽  
Kenji Yasuoka ◽  
Aron Walsh
Keyword(s):  
Photocatalytic Activity ◽  
Crystal Engineering ◽  
First Principles ◽  
Parent Compound ◽  
Aurivillius Phase ◽  
Aurivillius Phases ◽  
Charge Neutrality ◽  
Bismuth Oxides ◽  
Structure Surface ◽  
Electric Dipoles

The Aurivillius phases of complex bismuth oxides have attracted considerable attention due to their lattice polarization (ferroelectricity) and photocatalytic activity. We report a first-principles exploration of Bi<sub>2</sub>WO<sub>6</sub> and the replacement of W<sup>6+</sup> by pentavalent (Nb<sup>5+</sup>, Ta<sup>5+</sup>) and tetravalent (Ti<sup>4+</sup>, Sn<sup>4+</sup>) ions, with charge neutrality maintained by the formation of a mixed-anion oxyhalide sublattice. We find that Bi<sub>2</sub>SnO<sub>4</sub>F<sub>2</sub> is thermodynamically unstable, in contrast to Bi<sub>2</sub>TaO<sub>5</sub>F, Bi<sub>2</sub>NbO<sub>5</sub>F and Bi<sub>2</sub>TiO<sub>4</sub>F<sub>2</sub>. The electric dipoles introduced by chemical substitutions in the parent compound are found to suppress the spontaneous polarization from 61.55 μC/cm<sup>2</sup> to below 15.50 μC/cm<sup>2</sup>. Analysis of the trends in electronic structure, surface structure, and ionization potentials are reported. This family of materials can be further extended with control of layer thicknesses and choice of compensating halide species.<br>

STRUCTURAL, OPTICAL PROPERTIES AND PHOTOCATALYTIC ACTIVITY OF NANOCRYSTALLINE TiO2 THIN FILMS DEPOSITED BY SOL-GEL SPIN COATING

2019 ◽  
Vol 7 (1) ◽  
pp. 28
Author(s):  
KOMARAIAH DURGAM ◽  
RADHA EPPA ◽  
REDDY M. V. RAMANA ◽  
KUMAR J. SIVA ◽  
R. SAYANNA ◽  
...  
Keyword(s):  
Thin Films ◽  
Optical Properties ◽  
Photocatalytic Activity ◽  
Spin Coating ◽  
Sol Gel ◽  
Tio2 Thin Films ◽  
Nanocrystalline Tio2

PHOTOCATALYTIC ACTIVITY OF Ag/TiO2-P25 MODIFIED CEMENT: OPTIMIZATION USING TAGUCHI APPROACH

2018 ◽  
Vol 17 (5) ◽  
pp. 1131-1138 ◽  
Author(s):  
Mohammad A. Behnajady ◽  
Sara Bimeghdar ◽  
Hamed Eskandarloo
Keyword(s):  
Photocatalytic Activity ◽  
Taguchi Approach
Sign in / Sign up

Export Citation Format

Share Document