From Nd(III) and Pu(III) Oxalates to Oxides: Influence of Nitrilotris(methylenephosphonic acid) on Chemical Composition, Structure, and Morphology

2017 ◽  
Vol 17 (9) ◽  
pp. 4715-4725 ◽  
Author(s):  
Anne-Lise Vitart ◽  
Blaise Haidon ◽  
Benedicte Arab-Chapelet ◽  
Murielle Rivenet ◽  
Isabelle Bisel ◽  
...  
Keyword(s):  
Chemical Composition ◽  
Structure And Morphology ◽  
Composition Structure

New Sorption Materials on the Basis of Aluminosilicates for Wasterwater Treatment

2017 ◽  
Vol 13 ◽  
pp. 190-196
Author(s):  
Kristina K. Abdugaffarova ◽  
Maksim V. Dorogov ◽  
Anatolii A. Vikarchuk ◽  
Vlada V. Zabolotskikh ◽  
Vladislav S. Firsov
Keyword(s):  
Heavy Metals ◽  
Methylene Blue ◽  
Chemical Composition ◽  
Specific Surface ◽  
Post Treatment ◽  
Pilot Studies ◽  
Physical Methods ◽  
Structure And Morphology ◽  
Composition Structure

This article presents the results of experimental obtaining together with tests of modifications of the granulated sorption aluminosilicate-based material. The chemical composition, structure and morphology of a surface of the obtained modifications of sorbents from clay have been explored. Through a complex of modern physical methods it is established that porosity and a specific surface of clay-based sorbents increased as a result of modification. Pilot studies have shown higher efficiency of new aluminosilicate-based sorbents in comparison with absorbent carbon during sorption of such model pollutants as methylene blue, phenol and ions of heavy metals. Modifications of sorbent which can be effectively used for post treatment of wastewater are revealed.

Inclusion Compounds of Tetracyano Complexes and Their Electrical Properties

1994 ◽  
Vol 59 (11) ◽  
pp. 2436-2446 ◽  
Author(s):  
Mária Reháková ◽  
Anna Sopková ◽  
Vladimír Šály
Keyword(s):  
Electrical Conductivity ◽  
Chemical Composition ◽  
Electrical Properties ◽  
General Formula ◽  
Inclusion Compounds ◽  
High Frequency ◽  
Iodide Ions ◽  
Structure And Morphology ◽  
Composition Structure ◽  
Tetracyano Complexes

The presence of iodine and iodide ions in tetracyanonickelates inclusion compounds with the general formula Ni(B)mNi(CN)4 . n H2O (B = NH3 or ethylenediamine) changes the properties of these compounds. High frequency conductance measurements in the range of 10 - 105 Hz show that the products with ethylenediamine ligands have a higher electrical conductivity than those with NH3 ligands. The differences in the electrical properties between the compounds studied are mainly caused by chemical composition, structure and morphology.

Synthesis and properties of BxCyNz coatings

2001 ◽  
Vol 16 (3) ◽  
pp. 734-743 ◽  
Author(s):  
M. N. Oliveira ◽  
O. Conde
Keyword(s):  
Chemical Composition ◽  
Gas Phase ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Depth Sensing ◽  
Composition Triangle ◽  
Structure And Morphology ◽  
Fused Quartz ◽  
Composition Structure ◽  
Quartz Substrates

Some of the most interesting compounds from both technological and a scientific viewpoint can be found within the B–C–N composition triangle. Despite all the attention that some phases on the vertices and sides of the triangle have attracted, few works have focused inside the triangle itself. A laser-assisted chemical vapor deposition system was used to deposit B–C–N phases over fused quartz substrates. Two sets of gaseous precursors were used, namely B2H6 + NH3 + C2H4 and B2H6 + (CH3)2NH. The coatings were characterized regarding chemical composition, structure, and morphology. Hardness measurements were also carried out with a depth-sensing indentation instrument. It was found that depending on the gas phase, different regions of the BCN solid composition triangle are accessed. Coatings ranging from pure h-BN to pure B4C were obtained, as well as mixtures of these with BxCyNz compounds.

Effect of plasma treatment on chemical composition, structure and sorption properties of lignocellulosic hemp fibers (Cannabis sativa L.)

2020 ◽  
Vol 236 ◽  
pp. 116000 ◽  
Author(s):  
Biljana M. Pejić ◽  
Ana D. Kramar ◽  
Bratislav M. Obradović ◽  
Milorad M. Kuraica ◽  
Andrijana A. Žekić ◽  
...  
Keyword(s):  
Chemical Composition ◽  
Plasma Treatment ◽  
Cannabis Sativa ◽  
Sorption Properties ◽  
Hemp Fibers ◽  
Composition Structure ◽  
Structure And Sorption Properties

Influence of High-Calcium Ash Composition on the Composite Binders’ Properties

2021 ◽  
Vol 316 ◽  
pp. 1019-1024
Author(s):  
O. A. Ignatova ◽  
A. A. Dyatchina
Keyword(s):  
Mechanical Properties ◽  
Chemical Composition ◽  
Cement Stone ◽  
Normal Density ◽  
Fine Aggregate ◽  
Equivalent Amount ◽  
High Calcium ◽  
Composition Structure ◽  
Kinetics Of ◽  
Positive Effect

The paper presents the studies’ results of chemical composition, structure, and physico-mechanical properties of high-calcium ashes from the Kansk-Achinsk coals (2017-2019 selection). It was found that ash has a complex poly-mineral composition and contains hydraulically active minerals and oxides of СаОfr, β-C2S, CA, C3A, C4AF, C2F, CaSO4. According to the content of CaOfr, MgO does not meet standards’ requirements. The uniformity of the volume change is maintained by the composition with 50% of cement. The structure and hardening kinetics of ash and ash-cement stone compositions, obtained from the test of normal density, were analyzed. It was established that the hardening of compositions with ash from the Kansk-Achinsk coals was largely influenced by ash minerals. An equivalent amount of cement in composite binders cannot be replaced. In order to obtain a positive effect, compositions with ash instead cement of no more than 30% and a part of fine aggregate, without exceeding the ratio of ash: cement = 1: 1, should be used.

scholarly journals BIOFILM MATRIX – CHEMICAL COMPOSITION, STRUCTURE, FUNCTIONS

2016 ◽  
Vol 0 (4(36)) ◽  
pp. 6-27
Author(s):  
М. Б. Галкін ◽  
В. О. Іваниця ◽  
Б. М. Галкін ◽  
Т. О. Філіпова
Keyword(s):  
Chemical Composition ◽  
Structure Functions ◽  
Composition Structure ◽  
Biofilm Matrix

scholarly journals Production and investigation of powders for additive synthesis from a new beta-solidifying TiAl-based alloy

2021 ◽  
Vol 2144 (1) ◽  
pp. 012004
Author(s):  
P V Panin ◽  
I A Bogachev ◽  
E A Lukina
Keyword(s):  
Phase Composition ◽  
Chemical Composition ◽  
Equilibrium Phase ◽  
Fold Increase ◽  
Induction Melting ◽  
Technological Properties ◽  
Powder Flowability ◽  
Powder Particles ◽  
Additive Synthesis ◽  
Composition Structure

Abstract Chemical composition, structure, and technological properties have been investigated for metal powder compositions (MPCs) of a new six-component TiAl-based alloy with Gd microadditions: Ti-31.0Al-2.5V-2.5Nb-2.5Cr-0.4Gd, wt.% (Ti-44.5Al-2V-1Nb-2Cr-0.1Gd, at.%). Three MPCs fractions (10–63, 40–100, 80–120 μm) were produced by electrode induction melting and inert gas atomization technique and targeted for the additive synthesis of parts. It is shown that the chemical composition of the MPCs for the main elements corresponds to that of the electrode. In contrast, a 1.5-fold increase of the oxygen content in the MPCs was observed, which is being the result of natural oxidation of powder particles upon air environment due to developed specific surface. It has been determined that the phase composition of the MPCs (γ+α(α2)+β) differs from the equilibrium phase composition of the electrode (γ+α2)+β0/B2) and corresponds to a rapidly quenched metastable state, which indicates high solidification rates in the atomization process, exceeding critical cooling rates of the alloy. The technological properties, specifically the powder flowability, were found to be improved for 40–100 and 80–120 μm fractions, making them applicable for additive synthesis of parts from the studied alloy by selective electron-beam melting method

Micromorphology and Characterization of V2O3 Nanoparticles Produced by the Liquid Phase Reduction-Heat Treatment

2019 ◽  
Vol 944 ◽  
pp. 650-656
Author(s):  
Ming Rui Zhang ◽  
Yuan Qin ◽  
Dao Zhang ◽  
Guang Yuan Wang ◽  
Sen Yang
Keyword(s):  
Heat Treatment ◽  
Phase Composition ◽  
Liquid Phase ◽  
Thermal Treatment ◽  
Oxalic Acid ◽  
Structure And Morphology ◽  
Phase Reduction ◽  
Novel Method ◽  
Composition Structure

The liquid phase reduction-heat treatment has been used to prepare V2O3nanoparticles in this paper. It is a novel method that the precursor was developed by Oxalic acid dehydrate (H2C2O4·2H2O) reduction of V2O5powder in anhydrous ethanol. V2O3nanoparticles were successfully obtained by thermal treatment of the precursor. The phase, composition, structure, and morphology of the as-obtained samples were verified by XRD, XPS, SEM and TEM measurements. Meanwhile, the possible formation mechanism of V2O3in the heat-treatment is briefly discussed by analyzing the DSC.

scholarly journals Correction: Materials space of solid-state electrolytes: unraveling chemical composition–structure–ionic conductivity relationships in garnet-type metal oxides using cheminformatics virtual screening approaches

2020 ◽  
Vol 22 (26) ◽  
pp. 15058-15058
Author(s):  
Natalia Kireeva ◽  
Vladislav S. Pervov
Keyword(s):  
Chemical Composition ◽  
Solid State ◽  
Ionic Conductivity ◽  
Virtual Screening ◽  
Metal Oxides ◽  
Chem Phys ◽  
Solid State Electrolytes ◽  
Composition Structure ◽  
Screening Approaches ◽  
Phys Chem Chem Phys

Correction for ‘Materials space of solid-state electrolytes: unraveling chemical composition–structure–ionic conductivity relationships in garnet-type metal oxides using cheminformatics virtual screening approaches’ by Natalia Kireeva et al., Phys. Chem. Chem. Phys., 2017, 19, 20904–20918, DOI: 10.1039/c7cp00518k.

Relating chemical composition, structure, and rheology in alkali‐activated aluminosilicate gels

2020 ◽  
Vol 104 (1) ◽  
pp. 572-583
Author(s):  
Jennifer N. Mills ◽  
Norman J. Wagner ◽  
Paramita Mondal
Keyword(s):  
Chemical Composition ◽  
Composition Structure ◽  
Alkali Activated
Sign in / Sign up

Export Citation Format

Share Document