scholarly journals A three-dimensional model of flagellar swimming in a Brinkman fluid

2019 ◽  
Vol 864 ◽  
pp. 1088-1124 ◽  
Author(s):  
NguyenHo Ho ◽  
Karin Leiderman ◽  
Sarah Olson
Keyword(s):  
Asymptotic Analysis ◽  
Swimming Speed ◽  
Three Dimensional ◽  
Sine Wave ◽  
Plane Motion ◽  
Brinkman Equation ◽  
Infinite Length ◽  
Three Dimensional Model ◽  
Resistance Parameter ◽  
Kirchhoff Rod

We investigate three-dimensional flagellar swimming in a fluid with a sparse network of stationary obstacles or fibres. The Brinkman equation is used to model the average fluid flow where a flow-dependent term, including a resistance parameter that is inversely proportional to the permeability, captures the effects of the fibres on the fluid. To solve for the local linear and angular velocities that are coupled to the flagellar motion, we extend the method of regularized Brinkmanlets to incorporate a Kirchhoff rod, discretized as point forces and torques along a centreline. Representing a flagellum as a Kirchhoff rod, we investigate emergent waveforms for different preferred strain and twist functions. Since the Kirchhoff rod formulation allows for out-of-plane motion, in addition to studying a preferred planar sine wave configuration, we also study a preferred helical configuration. Our numerical method is validated by comparing results to asymptotic swimming speeds derived for an infinite-length cylinder propagating planar or helical waves. Similar to the asymptotic analysis for both planar and helical bending, we observe that with small amplitude bending, swimming speed is always enhanced relative to the case with no fibres in the fluid (Stokes) as the resistance parameter is increased. For regimes not accounted for with asymptotic analysis, i.e. large amplitude planar and helical bending, our model results show a non-monotonic change in swimming speed with respect to the resistance parameter; a maximum swimming speed is observed when the resistance parameter is near one. The non-monotonic behaviour is due to the emergent waveforms; as the resistance parameter increases, the swimmer becomes incapable of achieving the amplitude of its preferred configuration. We also show how simulation results of slower swimming speeds for larger resistance parameters are actually consistent with the asymptotic swimming speeds if work in the system is fixed.

An obstacle problem for Koiter’s shells

2019 ◽  
Vol 24 (10) ◽  
pp. 3061-3079 ◽  
Author(s):  
Philippe G Ciarlet ◽  
Paolo Piersanti
Keyword(s):  
Asymptotic Analysis ◽  
A Priori ◽  
Elastic Shell ◽  
Three Dimensional ◽  
Two Dimensional ◽  
Three Dimensional Model ◽  
Limit Model ◽  
Membrane Shells ◽  
Point Of Departure ◽  
Confinement Condition

In this paper, we define, a priori, a natural two-dimensional Koiter’s model of a ‘general’ linearly elastic shell subject to a confinement condition. As expected, this model takes the form of variational inequalities posed over a non-empty closed convex subset of the function space used for the ‘unconstrained’ Koiter’s model. We then perform a rigorous asymptotic analysis as the thickness of the shell, considered a ‘small’ parameter, approaches zero, when the shell belongs to one of the three main classes of linearly elastic shells, namely elliptic membrane shells, generalized membrane shells and flexural shells. To illustrate the soundness of this model, we consider elliptic membrane shells to fix ideas. We then show that, in this case, the ‘limit’ model obtained in this fashion coincides with the two-dimensional ‘limit’ model obtained by means of another rigorous asymptotic analysis, but this time with the three-dimensional model of a ‘general’ linearly elastic shell subject to a confinement condition as a point of departure. In this fashion, our proposed Koiter’s model of a linearly elastic shell subject to a confinement condition is fully justified in this case, even though it is not itself a ‘limit’ model.

Three-Dimensional Model for Virtual Surgical Simulation, during Complex Skull Base Surgery and Aneurysm Surgery

Skull Base ◽  
2008 ◽  
Vol 18 (S 01) ◽  
Author(s):  
Akio Morita ◽  
Toshikazu Kimura ◽  
Shigeo Sora ◽  
Kengo Nishimura ◽  
Hisayuki Sugiyama ◽  
...  
Keyword(s):  
Skull Base ◽  
Surgical Simulation ◽  
Skull Base Surgery ◽  
Three Dimensional ◽  
Aneurysm Surgery ◽  
Dimensional Model ◽  
Three Dimensional Model

Digitalization system of ancient architecture decoration art based on neural network and image features

2020 ◽  
pp. 1-12
Author(s):  
Wu Xin ◽  
Qiu Daping
Keyword(s):  
Neural Network ◽  
Construction Industry ◽  
Three Dimensional ◽  
Performance Testing ◽  
Image Features ◽  
Three Dimensional Model ◽  
Performance Effect ◽  
Data Process ◽  
And Performance ◽  
Construction Mode

The inheritance and innovation of ancient architecture decoration art is an important way for the development of the construction industry. The data process of traditional ancient architecture decoration art is relatively backward, which leads to the obvious distortion of the digitalization of ancient architecture decoration art. In order to improve the digital effect of ancient architecture decoration art, based on neural network, this paper combines the image features to construct a neural network-based ancient architecture decoration art data system model, and graphically expresses the static construction mode and dynamic construction process of the architecture group. Based on this, three-dimensional model reconstruction and scene simulation experiments of architecture groups are realized. In order to verify the performance effect of the system proposed in this paper, it is verified through simulation and performance testing, and data visualization is performed through statistical methods. The result of the study shows that the digitalization effect of the ancient architecture decoration art proposed in this paper is good.

Phonetic iconicity in the evaluative morphology of a sample of Indo-European, Niger-Congo and Austronesian languages

2010 ◽  
Vol 3 (2) ◽  
pp. 156-180 ◽  
Author(s):  
Renáta Gregová ◽  
Lívia Körtvélyessy ◽  
Július Zimmermann
Keyword(s):  
Three Dimensional ◽  
Sound Symbolism ◽  
Three Dimensional Model ◽  
Austronesian Languages ◽  
Place Of Articulation ◽  
European Languages ◽  
Phonetic Symbolism ◽  
The Individual ◽  
Core Vocabulary

Universals Archive (Universal #1926) indicates a universal tendency for sound symbolism in reference to the expression of diminutives and augmentatives. The research ( Štekauer et al. 2009 ) carried out on European languages has not proved the tendency at all. Therefore, our research was extended to cover three language families – Indo-European, Niger-Congo and Austronesian. A three-step analysis examining different aspects of phonetic symbolism was carried out on a core vocabulary of 35 lexical items. A research sample was selected out of 60 languages. The evaluative markers were analyzed according to both phonetic classification of vowels and consonants and Ultan's and Niewenhuis' conclusions on the dominance of palatal and post-alveolar consonants in diminutive markers. Finally, the data obtained in our sample languages was evaluated by means of a three-dimensional model illustrating the place of articulation of the individual segments.

3D reconstruction and calculation of surface area and volume of bell pepper

2007 ◽  
Vol 3 (1) ◽  
pp. 89-113
Author(s):  
Zoltán Gillay ◽  
László Fenyvesi
Keyword(s):  
3D Reconstruction ◽  
Surface Area ◽  
Three Dimensional ◽  
Reference Method ◽  
Bell Pepper ◽  
Three Dimensional Model ◽  
Acceptable Error ◽  
Volume Calculation ◽  
Bell Peppers ◽  
Area And Volume

There was a method developed that generates the three-dimensional model of not axisymmetric produce, based on an arbitrary number of photos. The model can serve as a basis for calculating the surface area and the volume of produce. The efficiency of the reconstruction was tested on bell peppers and artificial shapes. In case of bell peppers 3-dimensional reconstruction was created from 4 images rotated in 45° angle intervals. The surface area and the volume were estimated on the basis of the reconstructed area. Furthermore, a new and simple reference method was devised to give precise results for the surface area of bell pepper. The results show that this 3D reconstruction-based surface area and volume calculation method is suitable to determine the surface area and volume of definite bell peppers with an acceptable error.

Sign in / Sign up

Export Citation Format

Share Document