scholarly journals Modes of synchronisation in the wake of a streamwise oscillatory cylinder

2017 ◽  
Vol 832 ◽  
pp. 146-169 ◽  
Author(s):  
Guoqiang Tang ◽  
Liang Cheng ◽  
Feifei Tong ◽  
Lin Lu ◽  
Ming Zhao

A numerical analysis of flow around a circular cylinder oscillating in-line with a steady flow is carried out over a range of driving frequencies $(f_{d})$ at relatively low amplitudes $(A)$ and a constant Reynolds number of 175 (based on the free-stream velocity). The vortex shedding is investigated, especially when the shedding frequency $(f_{s})$ synchronises with the driving frequency. A series of modes of synchronisation are presented, which are referred to as the $p/q$ modes, where $p$ and $q$ are natural numbers. When a $p/q$ mode occurs, $f_{s}$ is detuned to $(p/q)f_{d}$, representing the shedding of $p$ pairs of vortices over $q$ cycles of cylinder oscillation. The $p/q$ modes are further characterised by the periodicity of the transverse force over every $q$ cycles of oscillation and a spatial–temporal symmetry possessed by the global wake. The synchronisation modes $(p/q)$ with relatively small natural numbers are less sensitive to the change of external control parameters than those with large natural numbers, while the latter is featured with a narrow space of occurrence. Although the mode of synchronisation can be almost any rational ratio (as shown for $p$ and $q$ smaller than 10), the probability of occurrence of synchronisation modes with $q$ being an even number is much higher than $q$ being an odd number, which is believed to be influenced by the natural even distribution of vortices in the wake of a stationary cylinder.

1967 ◽  
Vol 29 (4) ◽  
pp. 691-703 ◽  
Author(s):  
J. R. Calvert

The wake of a disk at an angle to a stream contains marked periodic motions which arise from the regular shedding of vortices from the trailing edge. The vortices are in the form of a chain of irregular rings, each one linked to the succeeding one, and they move downstream at about 0·6 of free-stream velocity. The prominence of the vortex shedding increases as the angle of incidence (measured from the normal) increases up to at least 50°. The shedding frequency increases with the angle of incidence, but by a suitable choice of reference velocity and length scale, may be described by a wake Strouhal number which has the constant value 0·21 for all angles of incidence above zero, up to at least 40°.Axially-symmetric bodies at zero incidence shed vortices in a similar manner, except that the orientation of the plane of vortex shedding is not fixed and varies from time to time.


2007 ◽  
Vol 129 (7) ◽  
pp. 886-893 ◽  
Author(s):  
Xavier Escaler ◽  
Mohamed Farhat ◽  
Eduard Egusquiza ◽  
François Avellan

An experimental work has been carried out to investigate the dynamic behavior and the intensity of erosive partial cavitation on a 2-D hydrofoil. Both sheet (stable) and cloud (unstable) cavitation have been tested in a cavitation tunnel for various free stream velocities. Special attention has been given to validate the use of acceleration transducers for studying the physical process. In particular, the modulation in amplitude of the cavitation induced vibrations in a high frequency band has allowed us to determine the shedding frequency and the relative intensity of the collapse process for each testing condition. Regarding the cavity dynamics, a typical Strouhal value based on its length of about 0.28 has been found for cloud cavitation; meanwhile, for sheet cavitation, it presents a value of about 0.16. Furthermore, the level of the vibration modulation in the band from 45kHz to 50kHz for cloud cavitation shows a power law dependency on the free stream velocity as well as a good correlation with the pitting rate measured on stainless steel samples mounted on the hydrofoil.


Author(s):  
Eric D’herde ◽  
Laila Guessous

Flow over a cylinder is a fundamental fluid mechanics problem that involves a simple geometry, yet increasingly complex flow patterns as the Reynolds number is increased, most notably the development of a Karman vortex with a natural vortex shedding frequency fs when the Reynolds number exceeds a value of about 40. The goal of this ongoing study is to numerically investigate the effect of an incoming free-stream velocity pulsation with a mean Reynolds number of 100 on the drag force over and vorticity dynamics behind a circular cylinder. This paper reports on initial results involving unsteady, laminar and incompressible flows over a circular cylinder. Sinusoidal free-stream pulsations with amplitudes Av varying between 25% and 75% of the mean free-stream velocity and frequencies f varying between 0.25 and 5 times the natural shedding frequency were considered. Of particular interest to us is the interaction between the pulsating frequency and natural vortex shedding frequency and the resulting effects on drag. Interestingly, at frequencies close to the natural frequency, and to twice the natural frequency, a sudden drop in the mean value of the drag coefficient is observed. This drop in the drag coefficient is also accompanied by a change in the flow and vortex shedding patterns observed behind the cylinder.


Author(s):  
Eric D’herde ◽  
Laila Guessous

Flow over a cylinder is a fundamental fluid mechanics problem that involves a simple geometry, yet increasingly complex flow patterns as the Reynolds number is increased, most notably the development of a Karman vortex with a natural vortex shedding frequency when the Reynolds number exceeds a value of about 40. The goal of this ongoing study is to numerically investigate the effect of an incoming free-stream velocity pulsation with a mean Reynolds number of 100 on the drag and lift forces over and vorticity dynamics behind a circular cylinder. This paper reports on initial results involving unsteady, laminar and incompressible flows over a circular cylinder. Sinusoidal free-stream pulsations with amplitudes Av varying between 25% and 75% of the mean free-stream velocity and frequencies varying between 0.25 and 5 times the natural shedding frequency fs were considered. Of particular interest to us is the interaction between the pulsating frequency and natural vortex shedding frequency and the resulting effects on drag. Interestingly, at frequencies close to the natural frequency, and to twice the natural frequency, a sudden drop in the mean value of the drag coefficient is observed. The first drop in the drag coefficient, i.e. near f = fs, is also accompanied by a change in the flow and vortex shedding patterns observed behind the cylinder. This change in vortex shedding pattern manifests itself as a departure from symmetrical shedding, and in a non-zero mean lift coefficient value. The second drop, i.e. near f = 2 fs, has similar characteristics, except that the mean lift coefficient remains at zero.


Author(s):  
Md. Mahbub Alam ◽  
An Ran ◽  
Yu Zhou

This paper presents cross-flow induced response of a both-end-spring-mounted circular cylinder (diameter D) placed in the wake of a rigid circular cylinder of smaller diameter d. The cylinder vibration is constrained to the transverse direction. The cylinder diameter ratio d/D and spacing ratio L/d are varied from 0.2 to 1.0 and 1.0 to 5.5, respectively, where L is the distance between the center of the upstream cylinder to the forward stagnation point of the downstream cylinder. A violent vibration of the cylinder is observed for d/D = 0.2 ∼ 0.8 at L/d = 1.0, for d/D = 0.24 ∼ 0.6 at 1.0 < L/d ≤ 2.5, for d/D = 0.2 ∼ 0.4 at 2.5 < L/d ≤ 3.5, and for d/D = 0.2 at 3.5 < L/d ≤ 5.5, but not for d/D = 1.0. A smaller d/D generates vibration for a longer range of L/d. The violent vibration occurs at a reduced velocity Ur (=U∞/fnD, where U∞ is the free-stream velocity and fn the natural frequency of the cylinder system) beyond the vortex excitation regime (Ur ≥ 8) depending on d/D and L/d. Once the vibration starts to occur, the vibration amplitude increases rapidly with increasing Ur. It is further noted that the flow behind the downstream cylinder is characterized by two predominant frequencies, corresponding to the cylinder vibration frequency and the natural vortex shedding frequency of the cylinder, respectively. While the former persists downstream, the latter vanishes rapidly.


1989 ◽  
Vol 111 (1) ◽  
pp. 71-77 ◽  
Author(s):  
P. M. Ligrani ◽  
A. Ortiz ◽  
S. L. Joseph ◽  
D. L. Evans

Heat transfer effects of longitudinal vortices embedded within film-cooled turbulent boundary layers on a flat plate were examined for free-stream velocities of 10 m/s and 15 m/s. A single row of film-cooling holes was employed with blowing ratios ranging from 0.47 to 0.98. Moderate-strength vortices were used with circulating-to-free stream velocity ratios of −0.95 to −1.10 cm. Spatially resolved heat transfer measurements from a constant heat flux surface show that film coolant is greatly disturbed and that local Stanton numbers are altered significantly by embedded longitudinal vortices. Near the downwash side of the vortex, heat transfer is augmented, vortex effects dominate flow behavior, and the protection from film cooling is minimized. Near the upwash side of the vortex, coolant is pushed to the side of the vortex, locally increasing the protection provided by film cooling. In addition, local heat transfer distributions change significantly as the spanwise location of the vortex is changed relative to film-cooling hole locations.


2014 ◽  
Vol 2014 ◽  
pp. 1-13 ◽  
Author(s):  
Min Zhang ◽  
YingZheng Liu ◽  
ZhaoMin Cao

A concept of energy harvesting from vortex-induced vibrations of a rigid circular cylinder with two piezoelectric beams attached is investigated. The variations of the power levels with the free stream velocity are determined. A mathematical approach including the coupled cylinder motion and harvested voltage is presented. The effects of the load resistance, piezoelectric materials, and circuit combined on the natural frequency and damping of the vibratory system are determined by performing a linear analysis. The dynamic response of the cylinder and harvested energy are investigated. The results show that the harvested level in SS and SP&PS modes is the same with different values of load resistance. For four different system parameters, the results show that the bigger size of cylinder with PZT beams can obtain the higher harvested power.


Author(s):  
Efstathios Konstantinidis

The fundamental understanding of the added mass phenomenon associated with the motion of a solid body relative to a fluid is revisited. This paper focuses on the two-dimensional flow around a circular cylinder oscillating transversely in a free stream. A virtual experiment reveals that the classical approach to this problem leads to a paradox. The inertial force is derived afresh based on analysis of the motion in a frame of reference attached to the cylinder centroid, which overcomes the paradox in the classical formulation. It is shown that the inertial force depends not only on the acceleration of the cylinder per se , but also on the relative motion between body and fluid embodied in a parameter called alpha, α , which represents the ratio of the maximum transverse velocity of the cylinder to the free-stream velocity; the induced inertial force is directionally varying and non-harmonic in time depended on the alpha parameter. It is further shown that the component of the inertial force in the transverse direction is negligible for α <0.1, increases quadratically for α <0.5, and tends asymptotically to the classical result as , i.e. in still fluid.


Sign in / Sign up

Export Citation Format

Share Document