A two‐component modeling for free stream velocity in magnetohydrodynamic nanofluid flow with radiation and chemical reaction over a stretching cylinder

Heat Transfer ◽  
2020 ◽  
Author(s):  
Vinita ◽  
Vikas Poply ◽  
Renu Devi
Keyword(s):  
Chemical Reaction ◽  
Free Stream ◽  
Free Stream Velocity ◽  
Stream Velocity ◽  
Stretching Cylinder ◽  
Nanofluid Flow ◽  
Two Component

scholarly journals Boundary-Layer Type Solutions for Initial Platelet Activation and Deposition

2002 ◽  
Vol 4 (2) ◽  
pp. 95-108 ◽  
Author(s):  
T. David ◽  
P. G. de Groot ◽  
P. G. Walker
Keyword(s):  
Platelet Activation ◽  
Peclet Number ◽  
Free Stream ◽  
Free Stream Velocity ◽  
Stream Velocity ◽  
Bulk Fluid ◽  
Péclet Number ◽  
Activated Platelets ◽  
Activation Rate ◽  
Initial Adhesion

This paper presents, on the basis of high Peclet number, a mathematical model for the activation and initial adhesion of flowing platelets onto a surface. In contrast to past work, the model is applicable to general 2D and axi-symmetric flows where the wall shear stress is knowna priori. Results indicate that for high activation reaction rates there exist two layers, one containing only activated platelets and the other both activated and non-activated platelets. Fundamental relationships are proposed between the adhesion rate of platelets to the surface and the characteristic parameters of Peclet number and Reynolds number. Activation in the bulk fluid (blood) is characterised by the Damkohler number, which is a function of activation rate and the free-stream velocity. It is shown that, as the free-stream velocity varies, there exists a maximum of activated platelet flux to the wall for particular values of the velocity. These values, at which the maximum occur, are themselves functions of the platelet activation rate. As the free-stream velocity increases the activation of platelets ceases altogether and adhesion is reduced to a very small value strengthening the hypothesis of the correlation between atherogenesis/thrombogenesis and areas of low shear.

Free Convective Couette flow1of1a1Dusty1Fluid1through1a Porous Medium1with1Periodic1Permeability1in1the1Absence1of Electrically Magneto Hydro Dynamic Model

2021 ◽  
Vol 58 (2) ◽  
pp. 6072-6083
Author(s):  
K. Rajesh, A. Govindarajan, M. Vidhya
Keyword(s):  
Flow Field ◽  
Dynamic Model ◽  
Analytical Solutions ◽  
Free Stream ◽  
Porous Plate ◽  
Free Stream Velocity ◽  
Dust Particles ◽  
Stream Velocity

“The purpose of this investigation stands to discuss the effects of periodic permeability on1the; free1convective flow of a dusty viscous; incompressible1fluid through a1highly1porous1channel. The porous1medium is confined by an infinite perpendicular porous plate supercilious the free stream velocity to be uniform. Analytical solutions are gained for the dusty flow field, the1temperature field, the1skin1friction and the rate1of heat1transfer. when there is an increase in mass concentration1of dust1particles, it is found that the1velocity profile of fluid and dust particles reduces.”

scholarly journals Impact of Nonlinear Chemical Reaction and Melting Heat Transfer on an MHD Nanofluid Flow over a Thin Needle in Porous Media

2019 ◽  
Vol 9 (24) ◽  
pp. 5492 ◽  
Author(s):  
Muhammad Ramzan ◽  
Hina Gul ◽  
Seifedine Kadry ◽  
Chhayly Lim ◽  
Yunyoung Nam ◽  
...  
Keyword(s):  
Heat Transfer ◽  
Chemical Reaction ◽  
Flow Analysis ◽  
Slip Boundary Condition ◽  
Stream Velocity ◽  
Nanofluid Flow ◽  
Melting Heat ◽  
Slip Boundary ◽  
Melting Heat Transfer ◽  
The Impact

A novel mathematical model is envisioned discussing the magnetohydrodynamics (MHD) steady incompressible nanofluid flow with uniform free stream velocity over a thin needle in a permeable media. The flow analysis is performed in attendance of melting heat transfer with nonlinear chemical reaction. The novel model is examined at the surface with the slip boundary condition. The compatible transformations are affianced to attain the dimensionless equations system. Illustrations depicting the impact of distinct parameters versus all involved profiles are supported by requisite deliberations. It is perceived that the melting heat parameter has a declining effect on temperature profile while radial velocity enhances due to melting.

scholarly journals Prediction of Heat Transfer From Laminar Boundary Layers, With Emphasis on Large Free-Stream Velocity Gradients and Highly Cooled Walls

1966 ◽  
Vol 88 (3) ◽  
pp. 249-256 ◽  
Author(s):  
L. H. Back ◽  
A. B. Witte
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Shear Stress ◽  
Velocity Gradient ◽  
Free Stream ◽  
Variable Density ◽  
Similarity Solutions ◽  
Free Stream Velocity ◽  
Stream Velocity ◽  
Gradient Parameter

Laminar boundary-layer heat transfer and shear-stress predictions from existing similarity solutions are extended in an approximate way to perfect gas flows with a large free-stream velocity gradient parameter β and variable density-viscosity product ρμ across the boundary layer resulting from a highly cooled wall. The dimensionless enthalpy gradient at the wall gw′, to which the heat flux is related, is found not to vary appreciably with β. Thus the application of similarity solutions on a local basis to predict heat transfer from accelerated flows to an arbitrary surface may be a reasonable approximation involving a minimum amount of calculation time. Unlike gw′, the dimensionless velocity gradient at the wall fw″, to which the shear stress is related, is strongly dependent on β.

Effects of Partial Slip on Chemically Reactive Solute Distribution in MHD Boundary Layer Stagnation Point Flow Past a Stretching Permeable Sheet

2015 ◽  
Vol 13 (1) ◽  
pp. 29-36 ◽  
Author(s):  
Swati Mukhopadhyay
Keyword(s):  
Boundary Layer ◽  
Differential Equations ◽  
Stagnation Point ◽  
Free Stream ◽  
Free Stream Velocity ◽  
Stagnation Point Flow ◽  
Partial Slip ◽  
Stream Velocity ◽  
Slip Parameter ◽  
Mhd Boundary Layer

Abstract This paper presents the magnetohydrodynamic (MHD) boundary layer stagnation point flow with diffusion of chemically reactive species undergoing first-order chemical reaction over a permeable stretching sheet in presence of partial slip. With the help of similarity transformations, the partial differential equations corresponding to momentum and the concentration equations are transformed into non-linear ordinary differential equations. Numerical solutions of these equations are obtained by shooting method. It is found that the horizontal velocity increases with the increasing value of the ratio of the free stream velocity and the stretching velocity. Velocity decreases with the increasing magnetic parameter when the free-stream velocity is less than the stretching velocity but the opposite behavior is noted when the free-stream velocity is greater than the stretching velocity. Due to suction, fluid velocity decreases at a particular point of the surface. With increasing velocity slip parameter, velocity increases when the free-stream velocity is greater than the stretching velocity. But the concentration decreases in this case. Concentration decreases with increasing mass slip parameter.

Effects of Unsteady Free-Stream Velocity and Free-Stream Turbulence at a Stagnation Point

1983 ◽  
Vol 105 (1) ◽  
pp. 66-71 ◽  
Author(s):  
R. S. R. Gorla
Keyword(s):  
Stagnation Point ◽  
Numerical Solutions ◽  
Free Stream ◽  
Eddy Diffusivity ◽  
Descent Method ◽  
Free Stream Velocity ◽  
Steepest Descent Method ◽  
Wall Friction ◽  
Stream Velocity ◽  
Free Stream Turbulence

An analysis is presented to investigate the combined effects of transient free-stream velocity and free-stream turbulence at a stagnation point on a cylinder situated in a crossflow. A model has been successfully formulated for the eddy diffusivity induced by the free-stream turbulence. The governing momentum equation has been integrated by the steepest descent method. Numerical solutions are provided for the unsteady wall shear stress function for specific free-stream transients. The results are correlated by a new turbulence parameter. It has been found that the wall friction increases with increasing free-stream turbulence intensity. In the case of flows involving unsteady free-stream velocity, the friction factor increases with increasing values of the reduced frequency of oscillations.

Active Control Methods for Drag Reduction in Flow Over Bluff Bodies (Keynote)

2002 ◽  
Author(s):  
Haecheon Choi
Keyword(s):  
Circular Cylinder ◽  
Drag Reduction ◽  
Active Control ◽  
High Frequency ◽  
Free Stream ◽  
Free Stream Velocity ◽  
Stream Velocity ◽  
Control Methods ◽  
Periodic Forcing ◽  
Time Periodic

In this paper, we present two successful results from active controls of flows over a circular cylinder and a sphere for drag reduction. The Reynolds number range considered for the flow over a circular cylinder is 40∼3900 based on the free-stream velocity and cylinder diameter, whereas for the flow over a sphere it is 105 based on the free-stream velocity and sphere diameter. The successful active control methods are a distributed (spatially periodic) forcing and a high-frequency (time periodic) forcing. With these control methods, the mean drag and lift fluctuations decrease and vortical structures are significantly modified. For example, the time-periodic forcing with a high frequency (larger than 20 times the vortex shedding frequency) produces 50% drag reduction for the flow over a sphere at Re = 105. The distributed forcing applied to the flow over a circular cylinder results in a significant drag reduction at all the Reynolds numbers investigated.

Analytical Investigation of the Characteristics of the Co-Flowing Velocity Sensor

1973 ◽  
Vol 2 (4) ◽  
pp. 209-215 ◽  
Author(s):  
M. P. duPlessis ◽  
R. L. Wang ◽  
W. F. Hayes
Keyword(s):  
Free Stream ◽  
National Research Council ◽  
Analytical Investigation ◽  
Variable Density ◽  
Free Stream Velocity ◽  
Stream Velocity ◽  
Air Velocity ◽  
Velocity Sensor ◽  
Jet Nozzle ◽  
Measured Pressure

An analytical finite-difference method is used to predict the linearity and sensitivity of a co-flowing air velocity sensor. The sensor, conceived, developed and tested at the National Research Council consists of a 0.023-in. inside diameter nozzle and receiver assembly which, when placed in a free-stream of unknown velocity, can be used to measure that free-stream velocity. For a certain range of jet and stream velocities the measured pressure from the receiver is linearly related to the free-stream velocity. With known jet supply pressures the analysis predicts jet exit velocities and the dynamic recovery pressure in the receiver for different values of free-stream velocities. The predictions compare well with variable density wind tunnel experimental results covering free-stream air velocities, temperatures and pressures of 50-720 ft/sec, −40°C to +20°C and 400-750 mm. Hg abs., respectively, and sensor jet nozzle exit velocities of 50-500 ft/sec.

Sign in / Sign up

Export Citation Format

Share Document