Influence of slip on the three-dimensional instability of flow past an elongated superhydrophobic bluff body

2017 ◽  
Vol 814 ◽  
pp. 69-94 ◽  
Author(s):  
Y. L. Xiong ◽  
D. Yang
Keyword(s):  
Bluff Body ◽  
Unstable Mode ◽  
Flow Direction ◽  
Three Dimensional ◽  
Partial Slip ◽  
Flow Past ◽  
Water Region ◽  
Vortex Shedding Frequency ◽  
Dimensional Instability ◽  
Mode A

The effects of superhydrophobic surfaces (SHSs), which consist of microgrates oriented transverse to the flow direction, on the onset of three-dimensional instability of flow past a bluff body were studied using Floquet analysis. The SHS was modelled on an air–water interface with a shear-free condition. The results showed that SHSs increased the vortex shedding frequency. Floquet analysis revealed that modes B$^{\prime }$ and S$^{\prime }$ were suppressed dramatically by the partial-slip condition compared with a regular no-slip body; however, mode A was less affected. Correspondingly, the critical spanwise wavelengths were not significantly affected by SHSs. A similar phenomenon was observed in flow past a circular cylinder coated by SHSs. The results also revealed that modes B$^{\prime }$ and S$^{\prime }$ were collapsed into mode A due to the increased width of the air–water region for flow past an elongated body. Furthermore, the critical Reynold numbers of different modes were diversely affected by gas fraction (GF) variations. The unstable modes with short wavelengths, such as modes B$^{\prime }$ and S$^{\prime }$, stabilized with increasing GF. Conversely, the opposite was seen for the unstable mode A with a longer wavelength. The exact critical Reynolds number depended on the geometric configuration, which should be between the critical values of the two extreme cases. The application of SHSs could modify the transition route from two- to three-dimensionality by alternating different unstable modes. As the wavelength of the unstable mode decreases, the inhibition of three-dimensional instability becomes more efficient by SHSs.

Flow past a rotationally oscillating cylinder

2013 ◽  
Vol 735 ◽  
pp. 307-346 ◽  
Author(s):  
S. Kumar ◽  
C. Lopez ◽  
O. Probst ◽  
G. Francisco ◽  
D. Askari ◽  
...  
Keyword(s):  
Reynolds Number ◽  
Vortex Shedding ◽  
Three Dimensional ◽  
Far Field ◽  
Two Dimensional ◽  
Flow Past ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency ◽  
Flow Visualizations ◽  
Hydrogen Bubble Technique

AbstractFlow past a circular cylinder executing sinusoidal rotary oscillations about its own axis is studied experimentally. The experiments are carried out at a Reynolds number of 185, oscillation amplitudes varying from $\mathrm{\pi} / 8$ to $\mathrm{\pi} $, and at non-dimensional forcing frequencies (ratio of the cylinder oscillation frequency to the vortex-shedding frequency from a stationary cylinder) varying from 0 to 5. The diagnostic is performed by extensive flow visualization using the hydrogen bubble technique, hot-wire anemometry and particle-image velocimetry. The wake structures are related to the velocity spectra at various forcing parameters and downstream distances. It is found that the phenomenon of lock-on occurs in a forcing frequency range which depends not only on the amplitude of oscillation but also the downstream location from the cylinder. The experimentally measured lock-on diagram in the forcing amplitude and frequency plane at various downstream locations ranging from 2 to 23 diameters is presented. The far-field wake decouples, after the lock-on at higher forcing frequencies and behaves more like a regular Bénard–von Kármán vortex street from a stationary cylinder with vortex-shedding frequency mostly lower than that from a stationary cylinder. The dependence of circulation values of the shed vortices on the forcing frequency reveals a decay character independent of forcing amplitude beyond forcing frequency of ${\sim }1. 0$ and a scaling behaviour with forcing amplitude at forcing frequencies ${\leq }1. 0$. The flow visualizations reveal that the far-field wake becomes two-dimensional (planar) near the forcing frequencies where the circulation of the shed vortices becomes maximum and strong three-dimensional flow is generated as mode shape changes in certain forcing parameter conditions. It is also found from flow visualizations that even at higher Reynolds number of 400, forcing the cylinder at forcing amplitudes of $\mathrm{\pi} / 4$ and $\mathrm{\pi} / 2$ can make the flow field two-dimensional at forcing frequencies greater than ${\sim }2. 5$.

Three-dimensional instabilities in oscillatory flow past elliptic cylinders

2016 ◽  
Vol 798 ◽  
pp. 371-397 ◽  
Author(s):  
José P. Gallardo ◽  
Helge I. Andersson ◽  
Bjørnar Pettersen
Keyword(s):  
Circular Cylinder ◽  
Flow Direction ◽  
Three Dimensional ◽  
Circular Cylinders ◽  
Flow Structures ◽  
Three Dimensional Flow ◽  
Elliptical Cross ◽  
Dimensional Flow ◽  
Aspect Ratios ◽  
Flow Past

We investigate the early development of instabilities in the oscillatory viscous flow past cylinders with elliptic cross-sections using three-dimensional direct numerical simulations. This is a classical hydrodynamic problem for circular cylinders, but other configurations have received only marginal attention. Computed results for some different aspect ratios ${\it\Lambda}$ from 1 : 1 to 1 : 3, all with the major axis of the ellipse aligned in the main flow direction, show good qualitative agreement with Hall’s stability theory (J. Fluid Mech., vol. 146, 1984, pp. 347–367), which predicts a cusp-shaped curve for the onset of the primary instability. The three-dimensional flow structures for aspect ratios larger than 2 : 3 resemble those of a circular cylinder, whereas the elliptical cross-section with the lowest aspect ratio of 1 : 3 exhibits oblate rather than tubular three-dimensional flow structures as well as a pair of counter-rotating spanwise vortices which emerges near the tips of the ellipse. Contrary to a circular cylinder, instabilities for an elliptic cylinder with sufficiently high eccentricity emerge from four rather than two different locations in accordance with the Hall theory.

The instability of the steady flow past spheres and disks

1993 ◽  
Vol 254 ◽  
pp. 323-344 ◽  
Author(s):  
Ramesh Natarajan ◽  
Andreas Acrivos
Keyword(s):  
Critical Reynolds Number ◽  
Unstable Mode ◽  
Three Dimensional ◽  
Circular Disk ◽  
Linear Instability ◽  
Base Flow ◽  
The Body ◽  
Incoming Flow ◽  
Flow Past ◽  
Flow Past A Sphere

We consider the instability of the steady, axisymmetric base flow past a sphere, and a circular disk (oriented broadside-on to the incoming flow). Finite-element methods are used to compute the steady axisymmetric base flows, and to examine their linear instability to three-dimensional modal perturbations. The numerical results show that for the sphere and the circular disk, the first instability of the base flow is through a regular bifurcation, and the critical Reynolds number (based on the body radius) is 105 for the sphere, and 58.25 for the circular disk. In both cases, the unstable mode is non-axisymmetric with azimuthal wavenumber m = 1. These computational results are consistent with previous experimental observations (Magarvey & Bishop 1961 a, b; Nakamura 1976; Willmarth, Hawk & Harvey 1964).

scholarly journals Strouhal–Reynolds number relationship for flow past a circular cylinder

2017 ◽  
Vol 832 ◽  
pp. 170-188 ◽  
Author(s):  
Hongyi Jiang ◽  
Liang Cheng
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Three Dimensional ◽  
Wake Flow ◽  
Pure Mode ◽  
Laminar Regime ◽  
3D Flow ◽  
Flow Past ◽  
3D Flows ◽  
Mode A

The Strouhal–Reynolds number ($St{-}Re$) relationship for flow past a circular cylinder in the low $Re$ range of $Re\leqslant 1000$ is investigated through two- (2D) and three-dimensional (3D) direct numerical simulations (DNS). An improved method is proposed for the determination of the separating velocity and the wake width to allow for a better estimation of the wake Strouhal number $St^{\ast }$. For $Re$ in the extended laminar regime calculated by 2D DNS, the $St^{\ast }$ values are found to be more uniform than the original $St$ for the 2D flow. It is also found that the $St^{\ast }$ values for the 2D and 3D flows agree well in the laminar regime of $Re$ up to approximately 270. In addition, uniform $St^{\ast }$ values are also obtained for different mode A and mode B flow structures triggered artificially by using different cylinder span lengths in DNS. It is demonstrated that the drop in $St$ (with respect to its 2D counterpart) with the development of different 3D wake structures is due to the decrease in the separating velocity and the increase in the wake width for a 3D flow, rather than the existence of a particular wake structure such as pure mode A or vortex dislocation. However, as the wake flow becomes increasingly turbulent with further increase in $Re$, the $St^{\ast }$ value for the 3D flow increases gradually and deviates from its 2D counterpart, since for turbulent 3D flows the vortex shedding frequency scales on a length smaller than the wake width.

Three-dimensional transition in the wake of a transversely oscillating cylinder

2007 ◽  
Vol 577 ◽  
pp. 79-104 ◽  
Author(s):  
JUSTIN S. LEONTINI ◽  
M. C. THOMPSON ◽  
K. HOURIGAN
Keyword(s):  
Bluff Body ◽  
Oscillation Amplitude ◽  
Three Dimensional ◽  
Base Flow ◽  
Two Dimensional ◽  
Cylinder Wake ◽  
Oscillating Cylinder ◽  
Single Vortex ◽  
Spatio Temporal ◽  
Mode A

A Floquet stability analysis of the transition to three-dimensionality in the wake of a cylinder forced to oscillate transversely to the free stream has been undertaken. The effect of varying the oscillation amplitude is determined for a frequency of oscillation close to the natural shedding frequency. The three-dimensional modes that arise are identified, and the effect of the oscillation amplitude on their structure and growth rate quantified.It is shown that when the two-dimensional wake is in the 2S configuration (which is similar to the Kármán vortex street), the three-dimensional modes that arise are similar in nature and symmetry structure to the modes in the wake of a fixed cylinder. These modes are known as modes A, B and QP and occur in this order with increasing Re. However, increasing the amplitude of oscillation causes the critical Reynolds number for mode A to increase significantly, to the point where mode B becomes critical before mode A. The critical wavelength for mode A is also affected by the oscillation, becoming smaller with increasing amplitude. Elliptic instability theory is shown also to predict this trend, providing further support that mode A primarily arises as a result of an elliptic instability.At higher oscillation amplitudes, the spatio-temporal symmetry of the two-dimensional wake changes and it takes on the P + S configuration, with a pair of vortices on one side of the wake and a single vortex on the other side, for each oscillation cycle. With the onset of this configuration, modes A, B and QP cease to exist. It is shown that two new three-dimensional modes arise from this base flow, which we call modes SL and SS. Both of these modes are subharmonic, repeating over two base-flow periods. Also, either mode can be the first to become critical, depending on the amplitude of oscillation of the cylinder.The emergence of these two new modes, as well as the reversal of the order of inception of the three-dimensional modes A and B, leads to the observation that for an oscillating cylinder wake there are four different modes that can lead the transition to three-dimensionality, depending on the amplitude of oscillation. Therefore this type of flow provides a good example for studying the effect of mode-order inception on the path taken to turbulence in bluff-body wakes.For the range of amplitudes studied, the maximum Re value for which the flow remains two-dimensional is 280.

Sign in / Sign up

Export Citation Format

Share Document