scholarly journals Effect of Wideband Gap Tunnel Diode and Thickness of the Window Layer on the Performance of a Dual Junction Solar Cell

2016 ◽  
Vol 25 ◽  
pp. 684-691 ◽  
Author(s):  
Girija Shankar Sahoo ◽  
Guru Prasad Mishra
2022 ◽  
Vol 12 (2) ◽  
pp. 601
Author(s):  
Chae-Won Kim ◽  
Gwang-Yeol Park ◽  
Jae-Cheol Shin ◽  
Hyo-Jin Kim

In order to improve efficiency of flexible III-V semiconductor multi-junction solar cells, it is important to enhance the current density for efficiency improvement and to attain an even efficiency of solar cells on a curved surface. In this study, the nanotextured InAlP window layer of a GaAs single-junction solar cell was employed to suppress reflectance in broad range. The nanotextured surface affects the reflectance suppression with the broad spectrum of wavelength, which causes it to increase the current density and efficiency of the GaAs single-junction solar cell and alleviate the efficiency drop at the high incident angle of the light source. Those results show the potential of the effectively suppressed reflectance of multi-junction solar cells and even performance of solar cells attached on a curved surface.


2012 ◽  
Vol 51 ◽  
pp. 080208
Author(s):  
Hung Wei Yu ◽  
Chen Chen Chung ◽  
Chin Te Wang ◽  
Hong Quan Nguyen ◽  
Binh Tinh Tran ◽  
...  

2012 ◽  
Vol 51 (8R) ◽  
pp. 080208
Author(s):  
Hung Wei Yu ◽  
Chen Chen Chung ◽  
Chin Te Wang ◽  
Hong Quan Nguyen ◽  
Binh Tinh Tran ◽  
...  

2017 ◽  
Vol 4 (14) ◽  
pp. 12600-12605
Author(s):  
Girija Shankar Sahoo ◽  
Mayank Mausam ◽  
Guru Prasad Mishra

2015 ◽  
Vol 8 (1) ◽  
pp. 106-111 ◽  
Author(s):  
Zilong Wang ◽  
Hua Zhang ◽  
Wei Zhao ◽  
Zhigang Zhou ◽  
Mengxun Chen

Research on automatic tracking solar concentrator photovoltaic systems has gained increasing attention in developing the solar PV technology. A paraboloidal concentrator with secondary optic is developed for a three-junction GaInP/GalnAs/Ge solar cell. The concentration ratio of this system is 200 and the photovoltaic cell is cooled by the heat pipe. A detailed analysis on the temperature coefficient influence factors of triple-junction solar cell under different high concentrations (75X, 100X, 125X, 150X, 175X and 200X) has been conducted based on the dish-style concentration photovoltaic system. The results show that under high concentrated light intensity, the temperature coefficient of Voc of triple-junction solar cell is increasing as the concentration ratio increases, from -10.84 mV/°C @ 75X growth to -4.73mV/°C @ 200X. At low concentration, the temperature coefficient of Voc increases rapidly, and then increases slowly as the concentration ratio increases. The temperature dependence of η increased from -0.346%/°C @ 75X growth to - 0.103%/°C @ 200X and the temperature dependence of Pmm and FF increased from -0.125 W/°C, -0.35%/°C @ 75X growth to -0.048W/°C, -0.076%/°C @ 200X respectively. It indicated that the temperature coefficient of three-junction GaInP/GalnAs/Ge solar cell is better than that of crystalline silicon cell array under concentrating light intensity.


2021 ◽  
Vol 2 (2) ◽  
pp. 100340
Author(s):  
Choongman Moon ◽  
Brian Seger ◽  
Peter Christian Kjærgaard Vesborg ◽  
Ole Hansen ◽  
Ib Chorkendorff

Crystals ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 726
Author(s):  
Ray-Hua Horng ◽  
Yu-Cheng Kao ◽  
Apoorva Sood ◽  
Po-Liang Liu ◽  
Wei-Cheng Wang ◽  
...  

In this study, a mechanical stacking technique has been used to bond together the GaInP/GaAs and poly-silicon (Si) solar wafers. A GaInP/GaAs/poly-Si triple-junction solar cell has mechanically stacked using a low-temperature bonding process which involves micro metal In balls on a metal line using a high-optical-transmission spin-coated glue material. Current–voltage measurements of the GaInP/GaAs/poly-Si triple-junction solar cells have carried out at room temperature both in the dark and under 1 sun with 100 mW/cm2 power density using a solar simulator. The GaInP/GaAs/poly-Si triple-junction solar cell has reached an efficiency of 24.5% with an open-circuit voltage of 2.68 V, a short-circuit current density of 12.39 mA/cm2, and a fill-factor of 73.8%. This study demonstrates a great potential for the low-temperature micro-metal-ball mechanical stacking technique to achieve high conversion efficiency for solar cells with three or more junctions.


Sign in / Sign up

Export Citation Format

Share Document