Effect of ion-irradiation and annealing on superconductive property of PLD prepared YBCO tapes

2007 ◽  
Vol 463-465 ◽  
pp. 665-668 ◽  
Author(s):  
K. Nakashima ◽  
N. Chikumoto ◽  
A. Ibi ◽  
S. Miyata ◽  
Y. Yamada ◽  
...  
Keyword(s):  
Ion Irradiation ◽  
Ybco Tapes ◽  
Superconductive Property

Effets of surfaces on precipitate morphology in irradiated thin foils

1978 ◽  
Vol 36 (1) ◽  
pp. 654-655
Author(s):  
D.I. Potter ◽  
A. Taylor
Keyword(s):  
Ion Irradiation ◽  
Dark Field Image ◽  
Thin Foil ◽  
Dark Field ◽  
Al Alloy ◽  
Bright Field Image ◽  
Dislocation Loops ◽  
Precipitate Morphology ◽  
Thin Foils

Thermal aging of Ni-12.8 at. % A1 and Ni-12.7 at. % Si produces spatially homogeneous dispersions of cuboidal γ'-Ni3Al or Ni3Si precipitate particles arrayed in the Ni solid solution. We have used 3.5-MeV 58Ni+ ion irradiation to examine the effect of irradiation during precipitation on precipitate morphology and distribution. The nearness of free surfaces produced unusual morphologies in foils thinned prior to irradiation. These thin-foil effects will be important during in-situ investigations of precipitation in the HVEM. The thin foil results can be interpreted in terms of observations from bulk irradiations which are described first.Figure 1a is a dark field image of the γ' precipitate 5000 Å beneath the surface(∿1200 Å short of peak damage) of the Ni-Al alloy irradiated in bulk form. The inhomogeneous spatial distribution of γ' results from the presence of voids and dislocation loops which can be seen in the bright field image of the same area, Fig. 1b.

Xenon ion irradiation of superconducting YBa2Cu3O7 thin films

1990 ◽  
Vol 48 (4) ◽  
pp. 92-93
Author(s):  
H. Watanabe ◽  
B. Kabius ◽  
B. Roas ◽  
K. Urban
Keyword(s):  
Defect Formation ◽  
Ion Irradiation ◽  
High Resolution Electron Microscopy ◽  
Structural Disorder ◽  
Flux Lines ◽  
Pinning Effect ◽  
Magnetic Flux Lines ◽  
Resolution Electron ◽  
Radiation Induced ◽  
Induced Defects

Recently it was reported that the critical current density(Jc) of YBa2Cu2O7, in the presence of magnetic field, is enhanced by ion irradiation. The enhancement is thought to be due to the pinning of the magnetic flux lines by radiation-induced defects or by structural disorder. The aim of the present study was to understand the fundamental mechanisms of the defect formation in association with the pinning effect in YBa2Cu3O7 by means of high-resolution electron microscopy(HRTEM).The YBa2Cu3O7 specimens were prepared by laser ablation in an insitu process. During deposition, a substrate temperature and oxygen atmosphere were kept at about 1073 K and 0.4 mbar, respectively. In this way high quality epitaxially films can be obtained with the caxis parallel to the <100 > SrTiO3 substrate normal. The specimens were irradiated at a temperature of 77 K with 173 MeV Xe ions up to a dose of 3.0 × 1016 m−2.

Structural relationships in the synthesis of cubic boron nitride thin films by ion-assisted deposition

1994 ◽  
Vol 52 ◽  
pp. 638-639
Author(s):  
D. L. Medlin ◽  
T. A. Friedmann ◽  
P. B. Mirkarimi ◽  
M. J. Mills ◽  
K. F. McCarty
Keyword(s):  
Boron Nitride ◽  
Ion Irradiation ◽  
Cubic Boron Nitride ◽  
Film Stress ◽  
Bonded Phases ◽  
Structural Relationships ◽  
Precursor Material ◽  
Pressure Synthesis ◽  
Microstructure Of The Material

The allotropes of boron nitride include two sp2-bonded phases with hexagonal and rhombohedral structures (hBN and rBN) and two sp3-bonded phases with cubic (zincblende) and hexagonal (wurtzitic) structures (cBN and wBN) (Fig. 1). Although cBN is synthesized in bulk form by conversion of hBN at high temperatures and pressures, low-pressure synthesis of cBN as a thin film is more difficult and succeeds only when the growing film is simultaneously irradiated with a high flux of ions. Only sp2-bonded material, which generally has a disordered, turbostratic microstructure (tBN), will form in the absence of ion-irradiation. The mechanistic role of the irradiation is not well understood, but recent work suggests that ion-induced compressive film stress may induce the transformation to cBN.Typically, BN films are deposited at temperatures less than 1000°C, a regime for which the structure of the sp2-bonded precursor material dictates the phase and microstructure of the material that forms from conventional (bulk) high pressure treatment.

Electron and ion irradiation-induced dissolution of mechanical twins in the intermetalic U3Si: An in situ HVEM study

1989 ◽  
Vol 47 ◽  
pp. 652-653
Author(s):  
Charles W. Allen ◽  
Robert C. Birtcher
Keyword(s):  
Elevated Temperatures ◽  
Ion Irradiation ◽  
Ion Beam ◽  
National Laboratory ◽  
Argonne National Laboratory ◽  
Heavy Ion ◽  
High Energy ◽  
Mechanical Twinning ◽  
In Situ Experiments

The uranium silicides, including U3Si, are under study as candidate low enrichment nuclear fuels. Ion beam simulations of the in-reactor behavior of such materials are performed because a similar damage structure can be produced in hours by energetic heavy ions which requires years in actual reactor tests. This contribution treats one aspect of the microstructural behavior of U3Si under high energy electron irradiation and low dose energetic heavy ion irradiation and is based on in situ experiments, performed at the HVEM-Tandem User Facility at Argonne National Laboratory. This Facility interfaces a 2 MV Tandem ion accelerator and a 0.6 MV ion implanter to a 1.2 MeV AEI high voltage electron microscope, which allows a wide variety of in situ ion beam experiments to be performed with simultaneous irradiation and electron microscopy or diffraction.At elevated temperatures, U3Si exhibits the ordered AuCu3 structure. On cooling below 1058 K, the intermetallic transforms, evidently martensitically, to a body-centered tetragonal structure (alternatively, the structure may be described as face-centered tetragonal, which would be fcc except for a 1 pet tetragonal distortion). Mechanical twinning accompanies the transformation; however, diferences between electron diffraction patterns from twinned and non-twinned martensite plates could not be distinguished.

Transmission Electron Microscopy characterization of epitaxial III-V semiconductor thin films grown on Si(100) by ion-assisted deposition

1990 ◽  
Vol 48 (4) ◽  
pp. 686-687
Author(s):  
L. Hultman ◽  
C.-H. Choi ◽  
R. Kaspi ◽  
R. Ai ◽  
S.A. Barnett
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Ion Irradiation ◽  
High Energy ◽  
Nucleation Mechanism ◽  
Layer By Layer ◽  
Extended Defect ◽  
Island Formation ◽  
Si Substrates ◽  
Transmission Electron

III-V semiconductor films nucleate by the Stranski-Krastanov (SK) mechanism on Si substrates. Many of the extended defects present in the films are believed to result from the island formation and coalescence stage of SK growth. We have recently shown that low (-30 eV) energy, high flux (4 ions per deposited atom), Ar ion irradiation during nucleation of III-V semiconductors on Si substrates prolongs the 1ayer-by-layer stage of SK nucleation, leading to a decrease in extended defect densities. Furthermore, the epitaxial temperature was reduced by >100°C due to ion irradiation. The effect of ion bombardment on the nucleation mechanism was explained as being due to ion-induced dissociation of three-dimensional islands and ion-enhanced surface diffusion.For the case of InAs grown at 380°C on Si(100) (11% lattice mismatch), where island formation is expected after ≤ 1 monolayer (ML) during molecular beam epitaxy (MBE), in-situ reflection high-energy electron diffraction (RHEED) showed that 28 eV Ar ion irradiation prolonged the layer-by-layer stage of SK nucleation up to 10 ML. Otherion energies maintained layer-by-layer growth to lesser thicknesses. The ion-induced change in nucleation mechanism resulted in smoother surfaces and improved the crystalline perfection of thicker films as shown by transmission electron microscopy and X-ray rocking curve studies.

Sound velocity of glassy Pd 80 Si 20 after heavy-ion irradiation at low temperatures

2002 ◽  
Vol 82 (11) ◽  
pp. 2333-2339
Author(s):  
G. Schumacher ◽  
R. C. Birtcher ◽  
D. P. Renusch ◽  
M. Grimsditch ◽  
L. E. Rehn
Keyword(s):  
Sound Velocity ◽  
Low Temperatures ◽  
Ion Irradiation ◽  
Heavy Ion ◽  
Heavy Ion Irradiation

Surface Modification of PMMA by Ion Irradiation

2012 ◽  
Vol 132 (3) ◽  
pp. 227-232
Author(s):  
Junya Yokoyama ◽  
Toru Iwao ◽  
Motoshige Yumoto
Keyword(s):  
Surface Modification ◽  
Ion Irradiation

Magnetization dynamics of irradiation-fabricated perpendicularly magnetized dots inside a softer magnetic matrix

2003 ◽  
Vol 777 ◽  
Author(s):  
T. Devolder ◽  
M. Belmeguenai ◽  
C. Chappert ◽  
H. Bernas ◽  
Y. Suzuki
Keyword(s):  
Domain Wall ◽  
Magnetic Anisotropy ◽  
Magnetization Reversal ◽  
Ion Irradiation ◽  
Magnetic Nanostructures ◽  
Magnetic Storage ◽  
Exchange Field ◽  
Static Magnetization ◽  
Specific Domain ◽  
Helium Ion

AbstractGlobal Helium ion irradiation can tune the magnetic properties of thin films, notably their magneto-crystalline anisotropy. Helium ion irradiation through nanofabricated masks can been used to produce sub-micron planar magnetic nanostructures of various types. Among these, perpendicularly magnetized dots in a matrix of weaker magnetic anisotropy are of special interest because their quasi-static magnetization reversal is nucleation-free and proceeds by a very specific domain wall injection from the magnetically “soft” matrix, which acts as a domain wall reservoir for the “hard” dot. This guarantees a remarkably weak coercivity dispersion. This new type of irradiation-fabricated magnetic device can also be designed to achieve high magnetic switching speeds, typically below 100 ps at a moderate applied field cost. The speed is obtained through the use of a very high effective magnetic field, and high resulting precession frequencies. During magnetization reversal, the effective field incorporates a significant exchange field, storing energy in the form of a domain wall surrounding a high magnetic anisotropy nanostructure's region of interest. The exchange field accelerates the reversal and lowers the cost in reversal field. Promising applications to magnetic storage are anticipated.

Effect of low-temperature ion irradiation on the nanostructure of 12% chromium ChS-139 steel

2019 ◽  
pp. 15-27
Author(s):  
S. V. Rogozhkin ◽  
◽  
N. A. Iskandarov ◽  
A. A. Nikitin ◽  
A. A. Bogachev ◽  
...  
Keyword(s):  
Low Temperature ◽  
Ion Irradiation
Sign in / Sign up

Export Citation Format

Share Document