Multi-level quantization and blind equalization based direct transmission method of digital baseband signal

2017 ◽  
Vol 25 ◽  
pp. 348-354
Author(s):  
Maolin Ji ◽  
Jin Chen ◽  
Zeng Liu ◽  
Ying Tong ◽  
Fajie Duan ◽  
...  
2018 ◽  
Vol 1 (1) ◽  
Author(s):  
Chai Jianwen

This paper mainly studies the basic concept of baseband transmission of digital signal and the transmission processof digital signal baseband transmission and how to design digital baseband transmission system with MATLABsoftware simulation. This paper fi rst introduces the theoretical basis of this subject, including digital communication,the composition of digital baseband transmission system and digital baseband signal transmission process. Then thepaper introduced the characteristics of digital baseband transmission system, including digital PAM signal powerdensity and common line pattern, and by comparing choosing the fi nal bipolar zero return code. Then we introducedthe MATLAB simulation software. The conditions of the best reception of the digital baseband signal are describedand how the waveform of the baseband signal is observed by an oscilloscope. Finally, according to the basic stepsof simulation process, the simulation process of digital baseband transmission system is realized by MATLABsimulation tool, and the system is analyzed.


2020 ◽  
Vol 6 (11) ◽  
pp. 2000439
Author(s):  
Stefan Petzold ◽  
Eszter Piros ◽  
Robert Eilhardt ◽  
Alexander Zintler ◽  
Tobias Vogel ◽  
...  

Author(s):  
Pornpawit Boonsrimuang ◽  
Pisit Boonsrimuang ◽  
Tawil Paungma ◽  
Hideo Kobayashi

The future satellite communication systems are required to support the higher transmission data rate for providing multimedia services by employing the efficient modulation method such as multilevel QAM. However, the employment of conventional single carrier transmission method with multi-level QAM which has larger PAPR (Peak to Averaged Power Ratio) would cause the fatal degradation of signal quality due to the non-linear amplifiers located at the earth station and satellite. To overcome this problem, this paper proposes broadband satellite communication systems by using the multilevel QAM-OFDM technique with IDAR (Improved Decision Aided Reconstruction) method, which is designed for satellite channel. In the IDAR method, the characteristics of non-linear amplifiers are required to be known at the receiver for mitigating the intermodulation noise. This paper also proposes the estimation method for AM-AM and AM-PM conversion characteristics of non-linear amplifiers by using low PAPR preamble symbols. The various computer simulations are conducted in this paper to verify the effectiveness of proposed system in the non-linear satellite channel.


1990 ◽  
Vol 79 (5) ◽  
pp. 280-284 ◽  
Author(s):  
Manfred Broja ◽  
Kristina Michalowski ◽  
Olof Bryngdahl

Sign in / Sign up

Export Citation Format

Share Document