scholarly journals AIRFLY: Measurement of the Air Fluorescence Radiation Induced by Electrons

2006 ◽  
Vol 150 ◽  
pp. 186-189 ◽  
Author(s):  
F. Arciprete ◽  
M. Bohacova ◽  
J. Bluemer ◽  
E. Bollmann ◽  
R. Caruso ◽  
...  
Keyword(s):  
Radiation Induced ◽  
Air Fluorescence ◽  
Fluorescence Radiation

Use of Multiple Standards for Absorption Correction and Quantitation with Frieda

1973 ◽  
Vol 17 ◽  
pp. 269-278
Author(s):  
P. S. Ong ◽  
E. L. Cheng ◽  
G. Sroka
Keyword(s):  
Dry Mass ◽  
High Energy ◽  
Exciting Radiation ◽  
X Ray ◽  
Mass Absorption ◽  
Iron Copper ◽  
Absorption Correction ◽  
Radiation Induced ◽  
Fluorescence Radiation

AbstractThe computerized fluorescence radiation induced energy dispersive analyzer (FRIEDA) (1) described earlier uses an x-ray beam with a well defined energy for the excitation of fluorescence radiation, and an Si(Li) detector to measure the total x-ray spectra emitted. Such a system can also simultaneously provide supplemental data for the determination of the dry mass and the sample mass absorption which is necessary for accurate quantitation of the results. This instrumental capabillty has been utilized in the measurement of the trace elements iron, copper, and zinc in serum.Known amounts of two elements are thoroughly mixed with the sample. One element has a ‘high energy’ K line, the other a ‘low energy’ K line. The ratio of these intensities, in the absence of absorption, is a known constant and dependent only on the relative amounts of the respective elements, and on the energy of the exciting radiation. Whenever absorption is present, the ratio will change in a manner directly related to the mass absorption of the sample for these radiations.

Investigation of radiation-induced air fluorescence

2012 ◽  
Author(s):  
Jimmy Yao ◽  
Jack Brenizer ◽  
Rongqing Hui ◽  
Shizhuo Yin
Keyword(s):  
Radiation Induced ◽  
Air Fluorescence

Radiation-Induced Precipitation at Thin Foil Surfaces in Ni-Be Alloys

1982 ◽  
Vol 40 ◽  
pp. 598-599
Author(s):  
T. Mukai ◽  
T. E. Mitchell
Keyword(s):  
Electron Microscopy ◽  
High Voltage ◽  
Electron Irradiation ◽  
High Vacuum ◽  
Thin Foil ◽  
Homogeneous Precipitation ◽  
High Voltage Electron Microscopy ◽  
Voltage Electron ◽  
High Voltage Electron ◽  
Radiation Induced

Radiation-induced homogeneous precipitation in Ni-Be alloys was recently observed by high voltage electron microscopy. A coupling of interstitial flux with solute Be atoms is responsible for the precipitation. The present investigation further shows that precipitation is also induced at thin foil surfaces by electron irradiation under a high vacuum.

Annealing Of Radiation Damage in Tungsten

1970 ◽  
Vol 28 ◽  
pp. 412-413
Author(s):  
Robert C. Rau ◽  
John Moteff
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Radiation Damage ◽  
Thermal Annealing ◽  
Neutron Fluence ◽  
Dislocation Loops ◽  
Defect Clusters ◽  
Polycrystalline Tungsten ◽  
Transmission Electron ◽  
Radiation Induced

Transmission electron microscopy has been used to study the thermal annealing of radiation induced defect clusters in polycrystalline tungsten. Specimens were taken from cylindrical tensile bars which had been irradiated to a fast (E > 1 MeV) neutron fluence of 4.2 × 1019 n/cm2 at 70°C, annealed for one hour at various temperatures in argon, and tensile tested at 240°C in helium. Foils from both the unstressed button heads and the reduced areas near the fracture were examined.Figure 1 shows typical microstructures in button head foils. In the unannealed condition, Fig. 1(a), a dispersion of fine dot clusters was present. Annealing at 435°C, Fig. 1(b), produced an apparent slight decrease in cluster concentration, but annealing at 740°C, Fig. 1(C), resulted in a noticeable densification of the clusters. Finally, annealing at 900°C and 1040°C, Figs. 1(d) and (e), caused a definite decrease in cluster concentration and led to the formation of resolvable dislocation loops.

Radiation-induced surface decomposition

1983 ◽  
Vol 41 ◽  
pp. 368-369
Author(s):  
M. L. Knotek
Keyword(s):  
Ionizing Radiation ◽  
Atomic Structure ◽  
Chemical Bonding ◽  
Neutral Species ◽  
Radiation Induced ◽  
Physical And Chemical ◽  
Surface Decomposition ◽  
The Relationship ◽  
Electron And Photon ◽  
Surface Bond

Modern surface analysis is based largely upon the use of ionizing radiation to probe the electronic and atomic structure of the surfaces physical and chemical makeup. In many of these studies the ionizing radiation used as the primary probe is found to induce changes in the structure and makeup of the surface, especially when electrons are employed. A number of techniques employ the phenomenon of radiation induced desorption as a means of probing the nature of the surface bond. These include Electron- and Photon-Stimulated Desorption (ESD and PSD) which measure desorbed ionic and neutral species as they leave the surface after the surface has been excited by some incident ionizing particle. There has recently been a great deal of activity in determining the relationship between the nature of chemical bonding and its susceptibility to radiation damage.

In situ TEM studies of irradiation effects for materials improvement

1991 ◽  
Vol 49 ◽  
pp. 452-453
Author(s):  
Charles W. Allen
Keyword(s):  
Nuclear Reactor ◽  
Austenitic Stainless Steels ◽  
High Energy ◽  
Point Of View ◽  
In Situ Tem ◽  
Irradiation Effects ◽  
Tem Analysis ◽  
Radiation Induced ◽  
Analytical Tools

Irradiation effects studies employing TEMs as analytical tools have been conducted for almost as many years as materials people have done TEM, motivated largely by materials needs for nuclear reactor development. Such studies have focussed on the behavior both of nuclear fuels and of materials for other reactor components which are subjected to radiation-induced degradation. Especially in the 1950s and 60s, post-irradiation TEM analysis may have been coupled to in situ (in reactor or in pile) experiments (e.g., irradiation-induced creep experiments of austenitic stainless steels). Although necessary from a technological point of view, such experiments are difficult to instrument (measure strain dynamically, e.g.) and control (temperature, e.g.) and require months or even years to perform in a nuclear reactor or in a spallation neutron source. Consequently, methods were sought for simulation of neutroninduced radiation damage of materials, the simulations employing other forms of radiation; in the case of metals and alloys, high energy electrons and high energy ions.

Xenon ion irradiation of superconducting YBa2Cu3O7 thin films

1990 ◽  
Vol 48 (4) ◽  
pp. 92-93
Author(s):  
H. Watanabe ◽  
B. Kabius ◽  
B. Roas ◽  
K. Urban
Keyword(s):  
Defect Formation ◽  
Ion Irradiation ◽  
High Resolution Electron Microscopy ◽  
Structural Disorder ◽  
Flux Lines ◽  
Pinning Effect ◽  
Magnetic Flux Lines ◽  
Resolution Electron ◽  
Radiation Induced ◽  
Induced Defects

Recently it was reported that the critical current density(Jc) of YBa2Cu2O7, in the presence of magnetic field, is enhanced by ion irradiation. The enhancement is thought to be due to the pinning of the magnetic flux lines by radiation-induced defects or by structural disorder. The aim of the present study was to understand the fundamental mechanisms of the defect formation in association with the pinning effect in YBa2Cu3O7 by means of high-resolution electron microscopy(HRTEM).The YBa2Cu3O7 specimens were prepared by laser ablation in an insitu process. During deposition, a substrate temperature and oxygen atmosphere were kept at about 1073 K and 0.4 mbar, respectively. In this way high quality epitaxially films can be obtained with the caxis parallel to the <100 > SrTiO3 substrate normal. The specimens were irradiated at a temperature of 77 K with 173 MeV Xe ions up to a dose of 3.0 × 1016 m−2.

Applications of ultramicrotomy for materials characterization

1993 ◽  
Vol 51 ◽  
pp. 232-233
Author(s):  
R.T. Blackham ◽  
J.J. Haugh ◽  
C.W. Hughes ◽  
M.G. Burke
Keyword(s):  
Materials Science ◽  
Microstructural Analysis ◽  
Analytical Electron Microscopy ◽  
Austenitic Stainless Steels ◽  
Specimen Preparation ◽  
Preparation Technique ◽  
Thermally Induced ◽  
Radiation Induced ◽  
Characterization Of Materials

Essential to the characterization of materials using analytical electron microscopy (AEM) techniques is the specimen itself. Without suitable samples, detailed microstructural analysis is not possible. Ultramicrotomy, or diamond knife sectioning, is a well-known mechanical specimen preparation technique which has been gaining attention in the materials science area. Malis and co-workers and Glanvill have demonstrated the usefulness and applicability of this technique to the study of a wide variety of materials including Al alloys, composites, and semiconductors. Ultramicrotomed specimens have uniform thickness with relatively large electron-transparent areas which are suitable for AEM anaysis.Interface Analysis in Type 316 Austenitic Stainless Steel: STEM-EDS microanalysis of grain boundaries in austenitic stainless steels provides important information concerning the development of Cr-depleted zones which accompany M23C6 precipitation, and documentation of radiation induced segregation (RIS). Conventional methods of TEM sample preparation are suitable for the evaluation of thermally induced segregation, but neutron irradiated samples present a variety of problems in both the preparation and in the AEM analysis, in addition to the handling hazard.

Ultrastructural Immunocytochemistry of Five Rat Pituitary Adenomas

1980 ◽  
Vol 38 ◽  
pp. 724-725
Author(s):  
D. J. McComb ◽  
N. Ryan ◽  
E. Horvath ◽  
K. Kovacs ◽  
E. Nagy ◽  
...  
Keyword(s):  
Pituitary Adenomas ◽  
Pituitary Tumors ◽  
Electron Microscopic ◽  
Electron Microscopic Immunocytochemistry ◽  
Transmission Electron ◽  
Rat Pituitary ◽  
Radiation Induced ◽  
Group 5 ◽  
Group 2 ◽  
Microscopic Techniques

Conventional light and electron microscopic techniques failed to clarify the cellular composition and derivation of spontaneous and induced, intrasellar and transplanted pituitary adenomas in rats (1). In the present work, electron microscopic immunocytochemistry was applied to evaluate five adenohypo-physial tumors using a technique described by Moriarty and Garner (2). Spontaneously occurring pituitary adenomas (group 1) were harvested from aging female Long-Evans rats. R-Amsterdam rats were treated with 2 x 1.0 mg estrone acetate (HogivaI) s.c. weekly for 6 months. Pituitary adenomas in excess of 30 mg were removed from these animals to make up the tumors of group 2. Groups 3 and 4 consisted of estrogen-induced autonomous transplan¬ted pituitary tumors MtT.WlO and MtT.F4. Group 5 was a radiation-induced transplanted autonomous pituitary tumor MtT.W5. The tumors of groups 3,4 and 5 were allowed to proliferate in host rats 6-8 weeks prior to removal for processing. Tissue was processed for transmission electron microscopy (glutaraldehyde fixation, OsO4 postfixation and epoxy resin embedding), and electron microscopic immunocytochemistry (3% paraformaldehyde fixation and Araldite embedding).

Radiation-Induced Precipitation in Ti-6A1-4V

1980 ◽  
Vol 38 ◽  
pp. 154-155
Author(s):  
J. E. O'Neal ◽  
S. M. L. Sastry ◽  
J. W. Davis
Keyword(s):  
Dark Field ◽  
Dislocation Loops ◽  
Beta Titanium Alloy ◽  
Defect Clusters ◽  
Weak Beam ◽  
Beta Titanium ◽  
Small Defect ◽  
Radiation Induced ◽  
Vector Orientation ◽  
Defect Microstructures

The radiation-induced defect structure and nonequilibrium phase precipitation were studied in T1-6A1-4V (an alpha-beta titanium alloy), irradiated at 450 ± 30°C in row VII of the EBR-II to a fluence of 3.0 × 1021 neutrons/cm2 (En > 0.1 MeV). The Irradiation-induced defect microstructures were examined using bright-field, conventional dark-field, and weak-beam dark-field techniques. The nature of dislocations and dislocation loops was determined by standard-contrast experiments under two-beam conditions, and the small defect clusters were identified using the line-of-contrast criterion and black-white vector orientation criterion.

Sign in / Sign up

Export Citation Format

Share Document