Studies on flow characteristics of coal–oil–water slurry system

2006 ◽  
Vol 79 (4) ◽  
pp. 217-224 ◽  
Author(s):  
Subrata Kumar Majumder ◽  
Kamal Chandna ◽  
Dhiren Sankar De ◽  
Gautam Kundu
Keyword(s):  
Flow Characteristics ◽  
Water Slurry ◽  
Slurry System ◽  
Oil Water

Viscous Oil-Water Flow in a Microchannel: Flow Patterns and Flow Development

2010 ◽  
Author(s):  
Hooman Foroughi ◽  
Masahiro Kawaji
Keyword(s):  
Water Flow ◽  
Silicone Oil ◽  
Flow Characteristics ◽  
Flow Patterns ◽  
Fused Silica ◽  
Water Mixture ◽  
Injection Point ◽  
Viscous Oil ◽  
Wide Range ◽  
Oil Water

The flow characteristics of a highly viscous oil and water mixture in a circular microchannel have been investigated. Water and silicone oil with a viscosity of 863 mPa.s were injected into a fused silica microchannel with a diameter of 250 μm. Before each experiment, the microchannel was initially saturated with either oil or water. In the initially oil-saturated case, different liquid-liquid flow patterns were observed and classified over a wide range of oil and water flow rates. As a special case, the flow of water at zero oil flow rate in a microchannel initially filled with silicone oil was also studied. When the microchannel was initially saturated with water, the oil formed a jet in water at the injection point but developed an instability at the oil-water interface downstream and eventually broke up into droplets.

Study of Flow Characteristics of Oil and Water in the Process of Stirring

2013 ◽  
Vol 353-356 ◽  
pp. 3190-3193
Author(s):  
Zong Rui Hao ◽  
Juan Xu ◽  
Hai Yan Bie ◽  
Zhong Hai Zhou
Keyword(s):  
Flow Field ◽  
Flow Pattern ◽  
Cross Section ◽  
Radial Flow ◽  
Flow Characteristics ◽  
Stirred Tank ◽  
Turbulent Model ◽  
Vof Model ◽  
Circular Flows ◽  
Oil Water

To study the flow pattern in the process of oil-water stirring in three paddle stirring tank, RNG k-ε turbulent model and VOF model are adopted to simulate the flow field at different time in the stirred tank with the baffle. The results showed that, in the stirring process, inverted cone manifold was formed in the center of the stirring shaft. The stratified area was formed in the baffle and gradually transported to the bottom of the tank. The two circular flows were formed among three groups of blades. And the axially acting of the fluid was strong, which made homogeneous stirring in the stirred tank. At the same time the radial flow of the cross-section inside the tank increased because of the baffle.

Study on oil–water two-phase flow characteristics of the hydrocyclone under periodic excitation

2020 ◽  
Vol 159 ◽  
pp. 215-224 ◽  
Author(s):  
Sen Li ◽  
Ruoning Li ◽  
Franck C.G.A. Nicolleau ◽  
Zunce Wang ◽  
Yuejuan Yan ◽  
...  
Keyword(s):  
Two Phase Flow ◽  
Flow Characteristics ◽  
Phase Flow ◽  
Periodic Excitation ◽  
Two Phase ◽  
Oil Water

Flow characteristics and morphology of hydrate slurry formed from (natural gas+diesel oil/condensate oil+water) system containing anti-agglomerant

2012 ◽  
Vol 84 ◽  
pp. 333-344 ◽  
Author(s):  
Bao-Zi Peng ◽  
Jun Chen ◽  
Chang-Yu Sun ◽  
Abhijit Dandekar ◽  
Shao-Hui Guo ◽  
...  
Keyword(s):  
Natural Gas ◽  
Water System ◽  
Flow Characteristics ◽  
Diesel Oil ◽  
Oil Water

A Study on the Flow Characteristics of Oil-Water Separator for Marine Ship CFD

2016 ◽  
Vol 19 (4) ◽  
pp. 48-53 ◽  
Author(s):  
Byeong Jun Kim ◽  
Sung Yoon Kim ◽  
Chun Su Roh ◽  
Young Ho Lee
Keyword(s):  
Flow Characteristics ◽  
Water Separator ◽  
Oil Water

Effect of Na4O7P2 on Cu powder preparation from Cu2O–water slurry system

2008 ◽  
Vol 319 (1) ◽  
pp. 109-114 ◽  
Author(s):  
J.G. Ahn ◽  
T.H. Hoang ◽  
D.J. Kim ◽  
M.S. Kim ◽  
C.O. Kim ◽  
...  
Keyword(s):  
Powder Preparation ◽  
Water Slurry ◽  
Slurry System
Sign in / Sign up

Export Citation Format

Share Document