Integrated smart gas flow sensor with 2.6mW total power consumption and 80dB dynamic range

2016 ◽  
Vol 159 ◽  
pp. 159-163 ◽  
Author(s):  
Massimo Piotto ◽  
Francesco Del Cesta ◽  
Paolo Bruschi
Keyword(s):  
Power Consumption ◽  
Gas Flow ◽  
Dynamic Range ◽  
Flow Sensor ◽  
Total Power ◽  
Total Power Consumption

Design of Low Power and High Precision Successive Approximation Register Analog-to-Digital Converter (SAR-ADC) Based on Piecewise Capacitance and Calibration Technique

2020 ◽  
Vol 15 (4) ◽  
pp. 478-486
Author(s):  
Sheng-Biao An ◽  
Li-Xin Zhao ◽  
Shi-Cong Yang ◽  
Tao An ◽  
Rui-Xia Yang
Keyword(s):  
Power Consumption ◽  
Successive Approximation ◽  
Dynamic Range ◽  
Sar Adc ◽  
Total Power ◽  
Analog To Digital Converter ◽  
Digital Converter ◽  
Analog To Digital ◽  
Successive Approximation Register ◽  
Total Power Consumption

This paper presents a charge redistributed successive approximation register analog-to-digital converter (SAR ADC). Compared with the traditional Digital-Analog Convertor (DAC), the power consumption of the DAC scheme is reduced by 90%, the area is reduced by 60%. The test chip fabricated in 180 nm Complementary Metal Oxide Semiconductor (CMOS) occupied an active area of 0.12 mm 2 . At 10 MS/s, a signal-to-noise and distortion ratio (SNDR) of 57.70 dB and a spurious-free dynamic range (SFDR) of 55.63 dB are measured with 1.68 Vpp differential-mode input signal. The total power consumption is 690 μW corresponding to 67 fJ/conversion step figure of merit.

Design of a 10-Bit High Performance Current-Steering DAC with a Novel Nested Decoder Based on Domino Logic

2015 ◽  
Vol 24 (06) ◽  
pp. 1550086 ◽  
Author(s):  
Masoud Nazari ◽  
Leila Sharifi ◽  
Meysam Akbari ◽  
Omid Hashemipour
Keyword(s):  
Power Consumption ◽  
High Performance ◽  
Dynamic Range ◽  
Logic Gates ◽  
Cmos Technology ◽  
Total Power ◽  
Current Steering ◽  
Domino Logic ◽  
Chip Area ◽  
Total Power Consumption

In this paper, a 10-bit 8-2 segmented current-steering digital-to-analog converter (DAC) is presented which uses a novel nested binary to thermometer (BT) decoder based on domino logic gates. High accuracy and high performances are achieved with this structure. The proposed decoder has a pipelining scheme and it is designed symmetrically in three stages with repeatable logic gates. Thus, power consumption, chip area and the number of control signals are reduced. The proposed DAC is simulated in 0.18-μm CMOS technology and the spurious-free dynamic range (SFDR) is 65.3 dB over a 500 MHz output bandwidth at 1 GS/s. Total power consumption of the designed DAC is only 23.4 mW while the digital and analog supply voltages are 1.2 and 1.8 V, respectively. The active area of the proposed DAC is equal to 0.3 mm2.

A 12-bit 1-MS/s 26-μW SAR ADC for Sensor Applications

2018 ◽  
Vol 3 (1) ◽  
Author(s):  
Yung-Hui Chung ◽  
Chia-Wei Yen ◽  
Cheng-Hsun Tsai
Keyword(s):  
Power Consumption ◽  
Dynamic Range ◽  
Total Power ◽  
Measured Signal ◽  
Input Frequency ◽  
Dynamic Comparator ◽  
Digital To Analog Converter ◽  
Analog To Digital ◽  
Sensor Applications ◽  
Total Power Consumption

AbstractThis chapter presents an energy-efficient 12-bit 1-MS/s successive approximation register analog-to-digital converter (ADC) for sensor applications. A programmable dynamic comparator is proposed to suppress static current and maintain good linearity. A hybrid charge redistribution digital-to-analog converter is proposed to decrease the total capacitance, which would reduce the power consumption of the input and reference buffers. In the proposed ADC, its total input capacitance is only 700 fF, which greatly reduces the total power consumption of the analog frontend circuits. The 12-bit ADC is fabricated using 0.18-μm complementary metal-oxidesemiconductor technology, and it consumes only 26 μW from a 1 V supply at 1-MS/s. The measured signal-to-noise-and-distortion ratio (SNDR) and spurious-free dynamic range (SFDR) are 60.1 and 72.6 dB, respectively. The measured effective number of bits (ENOB) for a 100 kHz input frequency is 9.7 bits. At the Nyquist input frequency, the measured SNDR and SFDR are 59.7 and 71 dB, respectively. The ENOB is maintained at 9.6 bits and the figure-of-merit is 33.5 fJ/conversion-step.

A New Low Power Photoplethysmography Signal Acquisition System For Mental Stress Estimation

2021 ◽  
Author(s):  
Rajeev Kumar Pandey ◽  
Paul C.-P. Chao
Keyword(s):  
Standard Deviation ◽  
Power Consumption ◽  
Low Power ◽  
Dynamic Range ◽  
Acquisition System ◽  
Total Power ◽  
Signal Acquisition ◽  
Readout System ◽  
Pulse Rate Variability ◽  
Total Power Consumption

Abstract This study presents a new low power and robust reflectance type optical Photoplethysmography (PPG) acquisition system for the mental distress estimation. The front-end circuit is implemented in the integrated chip with chip area of 1200μm × 1200μm and fabricated via TSMC T18 process. The sensing range of the readout circuit is 20nA to 11μA, and the total power consumption of the readout system is 100μW. The total power consumption of the design chip including the OLED driver power is 1.64mW. The designed acquisition system is applied to the wrist artery of the two healthy patients when they are calculating the pictorial puzzles and when they are in relax state. The statistical deviation of the heart rate (HR) from the average HR is increased when subjects are in the stress. Also, the standard deviation of pulse rate variability (PRV), the dynamic range of pulse repetition time (PRT), and the standard deviation of PRV derivative show the increasing temporal value when subjects are in the stress.

scholarly journals Efficient Operation Method of Aquifer Thermal Energy Storage System Using Demand Response

Energies ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 3129
Author(s):  
Jewon Oh ◽  
Daisuke Sumiyoshi ◽  
Masatoshi Nishioka ◽  
Hyunbae Kim
Keyword(s):  
Energy Storage ◽  
Power Consumption ◽  
Thermal Energy ◽  
Demand Response ◽  
Thermal Energy Storage ◽  
Heat Storage ◽  
Storage System ◽  
Total Power ◽  
Operation Method ◽  
Total Power Consumption

The mass introduction of renewable energy is essential to reduce carbon dioxide emissions. We examined an operation method that combines the surplus energy of photovoltaic power generation using demand response (DR), which recognizes the balance between power supply and demand, with an aquifer heat storage system. In the case that predicts the occurrence of DR and performs DR storage and heat dissipation operation, the result was an operation that can suppress daytime power consumption without increasing total power consumption. Case 1-2, which performs nighttime heat storage operation for about 6 h, has become an operation that suppresses daytime power consumption by more than 60%. Furthermore, the increase in total power consumption was suppressed by combining DR heat storage operation. The long night heat storage operation did not use up the heat storage amount. Therefore, it is recommended to the heat storage operation at night as much as possible before DR occurs. In the target area of this study, the underground temperature was 19.1 °C, the room temperature during cooling was about 25 °C and groundwater could be used as the heat source. The aquifer thermal energy storage (ATES) system in this study uses three wells, and consists of a well that pumps groundwater, a heat storage well that stores heat and a well that used heat and then returns it. Care must be taken using such an operation method depending on the layer configuration.

scholarly journals A Novel Differential Log-Companding Amplifier for Biosignal Sensing

2016 ◽  
Vol 2016 ◽  
pp. 1-7
Author(s):  
Zigang Dong ◽  
Xiaolin Zhou ◽  
Yuanting Zhang
Keyword(s):  
Power Consumption ◽  
Supply Voltage ◽  
Nonlinear Function ◽  
New Method ◽  
Total Power ◽  
Maximum Output ◽  
Output Current ◽  
Current Range ◽  
Symmetrical Configuration ◽  
Total Power Consumption

We proposed a new method for designing the CMOS differential log-companding amplifier which achieves significant improvements in linearity, common-mode rejection ratio (CMRR), and output range. With the new nonlinear function used in the log-companding technology, this proposed amplifier has a very small total harmonic distortion (THD) and simultaneously a wide output current range. Furthermore, a differential structure with conventionally symmetrical configuration has been adopted in this novel method in order to obtain a high CMRR. Because all transistors in this amplifier operate in the weak inversion, the supply voltage and the total power consumption are significantly reduced. The novel log-companding amplifier was designed using a 0.18 μm CMOS technology. Improvements in THD, output current range, noise, and CMRR are verified using simulation data. The proposed amplifier operates from a 0.8 V supply voltage, shows a 6.3 μA maximum output current range, and has a 6 μW power consumption. The THD is less than 0.03%, the CMRR of this circuit is 74 dB, and the input referred current noise density is166.1 fA/Hz. This new method is suitable for biomedical applications such as electrocardiogram (ECG) signal acquisition.

Exergy Analysis of a Novel Cryogenic Concept for the Liquefaction of Natural Gas Integrated Into an Air Separation Process

2016 ◽  
Author(s):  
S. Tesch ◽  
T. Morosuk ◽  
G. Tsatsaronis
Keyword(s):  
Natural Gas ◽  
Power Consumption ◽  
Exergy Analysis ◽  
Primary Energy ◽  
Separation Process ◽  
Air Separation ◽  
Total Power ◽  
Separation Unit ◽  
Total Power Consumption ◽  
Liquefaction Temperature

The increasing demand for primary energy leads to a growing market of natural gas and the associated market for liquefied natural gas (LNG) increases, too. The liquefaction of natural gas is an energy- and cost-intensive process. After exploration, natural gas, is pretreated and cooled to the liquefaction temperature of around −160°C. In this paper, a novel concept for the integration of the liquefaction of natural gas into an air separation process is introduced. The system is evaluated from the energetic and exergetic points of view. Additionally, an advanced exergy analysis is conducted. The analysis of the concepts shows the effect of important parameters regarding the maximum amount of liquefiable of natural gas and the total power consumption. Comparing the different cases, the amount of LNG production could be increased by two thirds, while the power consumption is doubled. The results of the exergy analysis show, that the introduction of the liquefaction of natural gas has a positive effect on the exergetic efficiency of a convetional air separation unit, which increases from 38% to 49%.

scholarly journals Optimization of Power Consumption for the Design of 802.11n MIMO_OFDM System

2018 ◽  
Vol 26 (4) ◽  
pp. 172-184
Author(s):  
Muthna Jasim Fadhil
Keyword(s):  
Power Consumption ◽  
Orthogonal Frequency Division Multiplexing ◽  
High Speed ◽  
Mimo Systems ◽  
Total Power ◽  
Wireless System ◽  
Generator System ◽  
Total Power Consumption ◽  
Consumption Energy ◽  
High Reduction

In modern systems communication, different methods have been improved to change the prior imitative techniques that process communication data with high speed. It is necessary to improve (OFDM) Orthogonal Frequency Division Multiplexing technique because the development in the guideline communication of wireless system which include security data and transmission data reliability. The applications communications of wireless is important to develop in order to optimize the process of communication leads to reduce the level consumption energy of the output level signal. The architecture of VLSI is used to optimize the performance transceiver in 802.11 n OFDM-MIMO systems, this idea concentrate on the design of 6x6 MIMO_OFDM system in software simulink of MATLAB then using generator system for transfer to code of VHDL and applying in FPGA Xilinx Spartan 3 XC3S200 . The modelsim used to get the simulation while Xilinx power estimator is used to calculate power. The results registered total power consumption about 94mW while compared with previous work  was 136mW which means a high reduction of about 30.8% .

Sign in / Sign up

Export Citation Format

Share Document