Two-dimensional oscillatory motion of inertially focused particles in microfluidic flows

2020 ◽  
Vol 31 (8) ◽  
pp. 3447-3457
Author(s):  
Hirotake Udono
Keyword(s):  
Oscillatory Motion ◽  
Two Dimensional ◽  
Microfluidic Flows

Diffusion in oscillatory pipe flow

1983 ◽  
Vol 133 ◽  
pp. 233-244 ◽  
Author(s):  
E. J. Watson
Keyword(s):  
Mass Transfer ◽  
Cross Section ◽  
Pipe Flow ◽  
Oscillatory Motion ◽  
Circular Pipe ◽  
Two Dimensional ◽  
Ambient Fluid ◽  
Fast Oscillations

The rate of mass transfer of a diffusing substance along a pipe is augmented by an oscillatory motion of the ambient fluid in the pipe. The increase of the flux is evaluated for the cases of a circular pipe and of a two-dimensional channel. Results are given for a general cross-section in the limiting cases of slow and fast oscillations of the flow.

scholarly journals Onset of global instability in the flow past a circular cylinder cascade

2010 ◽  
Vol 668 ◽  
pp. 304-334 ◽  
Author(s):  
V. B. L. BOPPANA ◽  
J. S. B. GAJJAR
Keyword(s):  
Stability Analysis ◽  
Reynolds Numbers ◽  
Oscillatory Motion ◽  
Two Dimensional ◽  
Global Instability ◽  
Global Stability Analysis ◽  
Generalized Eigenvalue ◽  
Flow Past ◽  
Flow Past A Cylinder ◽  
Critical Reynolds Numbers

The effect of blockage on the onset of instability in the two-dimensional uniform flow past a cascade of cylinders is investigated. The same techniques as those described in Gajjar & Azzam (J. Fluid Mech., vol. 520, 2004, p. 51) are used to tackle the generalized eigenvalue problem arising from a global stability analysis of the linearized disturbance equations. Results have been obtained for the various mode classes, and our results show that for the odd–even modes, which correspond to anti-phase oscillatory motion about the midplane between the cylinders and are the modes most extensively studied in the literature, the effect of blockage has a marginal influence on the critical Reynolds numbers for instability. This is in sharp contrast to results cited in many studies with a fully developed inlet flow past a cylinder placed between confining walls. We are also able to find other unstable modes and in particular for low blockage ratios, the odd–odd modes which correspond to the in-phase oscillatory motion about the midplane between the cylinders are the first to become unstable as compared with the odd–even modes, and with much lower frequencies.

Spectrophotometric measurements of objective-prism spectra

1966 ◽  
Vol 24 ◽  
pp. 118-119
Author(s):  
Th. Schmidt-Kaler
Keyword(s):  
Progress Report ◽  
Two Dimensional ◽  
Objective Prism ◽  
Made In

I should like to give you a very condensed progress report on some spectrophotometric measurements of objective-prism spectra made in collaboration with H. Leicher at Bonn. The procedure used is almost completely automatic. The measurements are made with the help of a semi-automatic fully digitized registering microphotometer constructed by Hög-Hamburg. The reductions are carried out with the aid of a number of interconnected programmes written for the computer IBM 7090, beginning with the output of the photometer in the form of punched cards and ending with the printing-out of the final two-dimensional classifications.

Introductory paper

1966 ◽  
Vol 24 ◽  
pp. 3-5
Author(s):  
W. W. Morgan
Keyword(s):  
Line Intensity ◽  
Classification Scheme ◽  
Two Dimensional ◽  
Spectral Classification ◽  
Dimensional Array ◽  
Rr Lyrae ◽  
Metallic Line ◽  
Introductory Paper ◽  
Parameter Varying ◽  
Definition Of

1. The definition of “normal” stars in spectral classification changes with time; at the time of the publication of theYerkes Spectral Atlasthe term “normal” was applied to stars whose spectra could be fitted smoothly into a two-dimensional array. Thus, at that time, weak-lined spectra (RR Lyrae and HD 140283) would have been considered peculiar. At the present time we would tend to classify such spectra as “normal”—in a more complicated classification scheme which would have a parameter varying with metallic-line intensity within a specific spectral subdivision.

A one-dimensional self-gravitating stellar gas

1966 ◽  
Vol 25 ◽  
pp. 46-48 ◽  
Author(s):  
M. Lecar
Keyword(s):  
Gravitational Field ◽  
Phase Space ◽  
Motion Picture ◽  
Space Distribution ◽  
Two Dimensional ◽  
One Dimensional ◽  
Phase Space Distribution ◽  
Dimensional Phase Space ◽  
The Mean

“Dynamical mixing”, i.e. relaxation of a stellar phase space distribution through interaction with the mean gravitational field, is numerically investigated for a one-dimensional self-gravitating stellar gas. Qualitative results are presented in the form of a motion picture of the flow of phase points (representing homogeneous slabs of stars) in two-dimensional phase space.

Analysis of the 9th November 1990 flare

2000 ◽  
Vol 179 ◽  
pp. 229-232
Author(s):  
Anita Joshi ◽  
Wahab Uddin
Keyword(s):  
Image Processing ◽  
Two Dimensional ◽  
Temporal Behaviour ◽  
Contour Maps ◽  
Dimensional Measurements ◽  
Processing Software ◽  
Image Processing Software

AbstractIn this paper we present complete two-dimensional measurements of the observed brightness of the 9th November 1990Hαflare, using a PDS microdensitometer scanner and image processing software MIDAS. The resulting isophotal contour maps, were used to describe morphological-cum-temporal behaviour of the flare and also the kernels of the flare. Correlation of theHαflare with SXR and MW radiations were also studied.

High Resolution Microscopy of Multi-Layered Biological Crystals

1982 ◽  
Vol 40 ◽  
pp. 80-83
Author(s):  
H.A. Cohen ◽  
T.W. Jeng ◽  
W. Chiu
Keyword(s):  
High Resolution ◽  
Low Dose ◽  
Three Dimensional ◽  
Data Interpretation ◽  
Two Dimensional ◽  
Biological Objects ◽  
Density Maps ◽  
Density Map ◽  
Complex Crystal ◽  
High Resolution Microscopy

This tutorial will discuss the methodology of low dose electron diffraction and imaging of crystalline biological objects, the problems of data interpretation for two-dimensional projected density maps of glucose embedded protein crystals, the factors to be considered in combining tilt data from three-dimensional crystals, and finally, the prospects of achieving a high resolution three-dimensional density map of a biological crystal. This methodology will be illustrated using two proteins under investigation in our laboratory, the T4 DNA helix destabilizing protein gp32*I and the crotoxin complex crystal.

Instrumentation For Quantitative Microscopy

1977 ◽  
Vol 35 ◽  
pp. 206-209
Author(s):  
B. Ralph ◽  
A.R. Jones
Keyword(s):  
Volume Fraction ◽  
Three Dimensional ◽  
Two Dimensional ◽  
Automatic Data ◽  
Phase Volume Fraction ◽  
Statistical Confidence ◽  
Resultant Data ◽  
Automatic Data Collection ◽  
Third Dimension ◽  
Evolution Of Microstructure

In all fields of microscopy there is an increasing interest in the quantification of microstructure. This interest may stem from a desire to establish quality control parameters or may have a more fundamental requirement involving the derivation of parameters which partially or completely define the three dimensional nature of the microstructure. This latter categorey of study may arise from an interest in the evolution of microstructure or from a desire to generate detailed property/microstructure relationships. In the more fundamental studies some convolution of two-dimensional data into the third dimension (stereological analysis) will be necessary.In some cases the two-dimensional data may be acquired relatively easily without recourse to automatic data collection and further, it may prove possible to perform the data reduction and analysis relatively easily. In such cases the only recourse to machines may well be in establishing the statistical confidence of the resultant data. Such relatively straightforward studies tend to result from acquiring data on the whole assemblage of features making up the microstructure. In this field data mode, when parameters such as phase volume fraction, mean size etc. are sought, the main case for resorting to automation is in order to perform repetitive analyses since each analysis is relatively easily performed.

Comparison of Recovery and Recrystallization in Stainless Steel Following Plane-Wave Shock Loading and Explosive Forming

1970 ◽  
Vol 28 ◽  
pp. 428-429 ◽  
Author(s):  
J. A. Korbonski ◽  
L. E. Murr
Keyword(s):  
Stainless Steel ◽  
Shock Loading ◽  
Pressure Pulse ◽  
Shock Pressure ◽  
304 Stainless Steel ◽  
Strain Rates ◽  
Two Dimensional ◽  
Aisi 304 Stainless Steel ◽  
Aisi 304 ◽  
Explosive Forming

Comparison of recovery rates in materials deformed by a unidimensional and two dimensional strains at strain rates in excess of 104 sec.−1 was performed on AISI 304 Stainless Steel. A number of unidirectionally strained foil samples were deformed by shock waves at graduated pressure levels as described by Murr and Grace. The two dimensionally strained foil samples were obtained from radially expanded cylinders by a constant shock pressure pulse and graduated strain as described by Foitz, et al.

Sign in / Sign up

Export Citation Format

Share Document