Al-based binary reactive multilayer films: Large area freestanding film synthesis and self-propagating reaction analysis

2019 ◽  
Vol 474 ◽  
pp. 243-249 ◽  
Author(s):  
Seema Sen ◽  
Markus Lake ◽  
Peter Schaaf
Keyword(s):  
Multilayer Films ◽  
Large Area ◽  
Film Synthesis ◽  
Reactive Multilayer Films

Synthesis and characterization of Ti/Al reactive multilayer films with various molar ratios

2017 ◽  
Vol 631 ◽  
pp. 99-105 ◽  
Author(s):  
Seema Sen ◽  
Markus Lake ◽  
Johannes Wilden ◽  
Peter Schaaf
Keyword(s):  
Multilayer Films ◽  
Synthesis And Characterization ◽  
Molar Ratios ◽  
Reactive Multilayer Films

scholarly journals Combined Properties of Al/Ni Reactive Multilayer Films During High-Rate Heating Using a Pulse of Current

2020 ◽  
Vol 1637 ◽  
pp. 012001
Author(s):  
Yao Wang ◽  
Fei Guo ◽  
Qin Zhou ◽  
Hongchuan Jiang ◽  
Yong Li ◽  
...  
Keyword(s):  
Multilayer Films ◽  
High Rate ◽  
Reactive Multilayer Films

Preparation of Thick Ni/Al Reactive Multilayer Films and Prospective Use for Self-Powered Brazing of Ti-6Al-4V

2018 ◽  
Author(s):  
Denzel Bridges ◽  
Ying Ma ◽  
Cary Smith ◽  
Zhili Zhang ◽  
Anming Hu ◽  
...  
Keyword(s):  
High Speed ◽  
Dendritic Structure ◽  
Propagation Speed ◽  
Multilayer Films ◽  
Rapid Melting ◽  
Substrate Preheating ◽  
Self Powered ◽  
Peeling Off ◽  
Reactive Multilayer Films ◽  
Melting And Solidification

In this study we demonstrate a new method for depositing thick reactive multilayer films (RMFs) (thickness > 14 μm) by using Ti interlayer integration and substrate preheating during fabrication. These two adjustments are designed to alleviate internal planar stresses that cause delamination between deposited layers and peeling off the substrate. Decreasing the distance between Ti interlayers helps to eliminate delamination between deposited layers. Through high speed camera measurements, the reaction propagation speed of an RMF sample with preheating is 42% slower than the same RMF that was not preheated, indicating a slower heat release rate. The preliminary experiments on brazing Ti-6Al-4V coated with BAlSi-4 brazing material revealed dendritic structure branching out from the RMF surface into the brazing material. The dendrite structures most likely form because of rapid melting and solidification of the brazing material. However, this rapid melting and solidification cycle does not appear to occur uniformly across the BAlSi-4RMF interface which is linked to its low bonding strength. When the Ti-6Al-4V substrate is heated to 150 °C prior to ignition, the strength increases to 0.47 MPa when the total RMF thickness is 84 μm and 15 MPa of pressure is applied.

Energetic igniters realized by integrating Al/CuO reactive multilayer films with Cr films

2011 ◽  
Vol 110 (7) ◽  
pp. 074513 ◽  
Author(s):  
Peng Zhu ◽  
Ruiqi Shen ◽  
Yinghua Ye ◽  
Xiang Zhou ◽  
Yan Hu
Keyword(s):  
Multilayer Films ◽  
Reactive Multilayer Films

Dielectric structure pyrotechnic initiator realized by integrating Ti/CuO-based reactive multilayer films

2011 ◽  
Vol 109 (8) ◽  
pp. 084523 ◽  
Author(s):  
Peng Zhu ◽  
Ruiqi Shen ◽  
N. N. Fiadosenka ◽  
Yinghua Ye ◽  
Yan Hu
Keyword(s):  
Multilayer Films ◽  
Dielectric Structure ◽  
Reactive Multilayer Films

In situ pulsed laser deposition of large-area ceramic and multilayer films for applications in industry

1997 ◽  
Vol 68 (10) ◽  
pp. 3872-3876 ◽  
Author(s):  
R. C. Y. Auyeung ◽  
J. S. Horwitz ◽  
L. A. Knauss ◽  
D. B. Chrisey
Keyword(s):  
Pulsed Laser Deposition ◽  
Pulsed Laser ◽  
Multilayer Films ◽  
Laser Deposition ◽  
Large Area

Experimental and modeling investigation on the self-propagating combustion behavior of Al-MoO3 reactive multilayer films

2018 ◽  
Vol 123 (23) ◽  
pp. 235302 ◽  
Author(s):  
Yu Tai ◽  
Jianbing Xu ◽  
Fei Wang ◽  
Ji Dai ◽  
Wei Zhang ◽  
...  
Keyword(s):  
Multilayer Films ◽  
The Self ◽  
Combustion Behavior ◽  
Reactive Multilayer Films

Tuning the Ignition Performance of a Microchip Initiator by Integrating Various Al/MoO3 Reactive Multilayer Films on a Semiconductor Bridge

2017 ◽  
Vol 9 (6) ◽  
pp. 5580-5589 ◽  
Author(s):  
Jianbing Xu ◽  
Yu Tai ◽  
Chengbo Ru ◽  
Ji Dai ◽  
Yinghua Ye ◽  
...  
Keyword(s):  
Multilayer Films ◽  
Reactive Multilayer Films
Sign in / Sign up

Export Citation Format

Share Document