scholarly journals Fabrication and characteristics of nitrogen-doped nanocrystalline diamond/p-type silicon heterojunction

2010 ◽  
Vol 2 (1) ◽  
pp. 56-59 ◽  
Author(s):  
D. Lu ◽  
H. D. Li ◽  
S. H. Cheng ◽  
J. J. Yuan ◽  
X. Y. Lv
2020 ◽  
Vol 709 ◽  
pp. 138222
Author(s):  
Rawiwan Chaleawpong ◽  
Nathaporn Promros ◽  
Abdelrahman Zkria ◽  
Peerasil Charoenyuenyao ◽  
Eslam Abubakr ◽  
...  

2014 ◽  
Vol 918 ◽  
pp. 59-63
Author(s):  
Chii Ruey Lin ◽  
Da Hua Wei ◽  
Minh Khoa Bendao

In this work, a solar cell structure of nitrogen-doped nanocrystalline diamond (NCD:N)/p-type silicon was fabricated using microwave plasma jet chemical vapour deposition technique. The effects of nitrogen doping level on the structure, optical, and electrical of the as-grown NCD:N was discussed. The results showed that the micro structure, surface roughness, electrical properties, and optical properties were affected by the nitrogen doping. Additionally, the agglomeration of the film was increased with the higher concentration of CN species when the ratio of doped nitrogen increased. The roughness of the film was Rms:16.5 nm ~ 20.4 nm and the wettability was increased (contact angle 94.4o~ 64.6o). The optical transmittance was decreased (87% ~ 72%) with the higher nitrogen. The results of Hall measurements showed that the carrier concentration increased 2 order (1016 cm-3to 1018 cm-3) through nitrogen doping. The solar cell was made by NCD: N compound with p-type silicon. The photoelectric conversion efficiency was 2.8%. The open-circuit voltage was 0.52 V. The short-circuit current was 3 mA and the fill factor was 0.38.


1997 ◽  
Vol 470 ◽  
Author(s):  
Denis Sweatman ◽  
Sima Dimitrijev ◽  
Hui-Feng Li ◽  
Philip Tanner ◽  
H. Barry Harrison

ABSTRACTSilicon-carbide offers great potential as a wide bandgap semiconductor for electronic applications. A good quality oxide dielectric will allow MOS device fabrication and in particular N-channel mosfets for their higher electron mobility. To date oxides on N-type silicon-carbide (nitrogen doped) have exhibited excellent characteristics while on P-type (aluminium or boron doped) the characteristics are poor. This paper presents results for the oxidation and subsequent nitridation of N and P-type silicon-carbide. It illustrates the role that nitrogen at the interface has in improving the trap densities and that nitric oxide provides the nitrogen well. Nitrous oxide, previously used to nitride silicon dioxide on silicon, is shown to substantially deteriorate the interface density of states for both N and P-type substrates.


AIP Advances ◽  
2021 ◽  
Vol 11 (8) ◽  
pp. 085005
Author(s):  
Kevin Lauer ◽  
Geert Brokmann ◽  
Mario Bähr ◽  
Thomas Ortlepp
Keyword(s):  

Electronics ◽  
2021 ◽  
Vol 10 (9) ◽  
pp. 988
Author(s):  
Chrysa Aivalioti ◽  
Alexandros Papadakis ◽  
Emmanouil Manidakis ◽  
Maria Kayambaki ◽  
Maria Androulidaki ◽  
...  

Nickel oxide (NiO) is a p-type oxide and nitrogen is one of the dopants used for modifying its properties. Until now, nitrogen-doped NiO has shown inferior optical and electrical properties than those of pure NiO. In this work, we present nitrogen-doped NiO (NiO:N) thin films with enhanced properties compared to those of the undoped NiO thin film. The NiO:N films were grown at room temperature by sputtering using a plasma containing 50% Ar and 50% (O2 + N2) gases. The undoped NiO film was oxygen-rich, single-phase cubic NiO, having a transmittance of less than 20%. Upon doping with nitrogen, the films became more transparent (around 65%), had a wide direct band gap (up to 3.67 eV) and showed clear evidence of indirect band gap, 2.50–2.72 eV, depending on %(O2-N2) in plasma. The changes in the properties of the films such as structural disorder, energy band gap, Urbach states and resistivity were correlated with the incorporation of nitrogen in their structure. The optimum NiO:N film was used to form a diode with spin-coated, mesoporous on top of a compact, TiO2 film. The hybrid NiO:N/TiO2 heterojunction was transparent showing good output characteristics, as deduced using both I-V and Cheung’s methods, which were further improved upon thermal treatment. Transparent NiO:N films can be realized for all-oxide flexible optoelectronic devices.


Sign in / Sign up

Export Citation Format

Share Document