Kinetics of elemental content changes of bone tissue of mice during evolution under hypokinetic stress

1994 ◽  
Vol 43-45 (1) ◽  
pp. 315-322
Author(s):  
T. E. Burkovskaya ◽  
M. V. Frontasyeva ◽  
S. F. Gundorina
Keyword(s):  
Bone Tissue ◽  
Elemental Content ◽  
Hypokinetic Stress ◽  
Kinetics Of

scholarly journals Selenium-Enriched Brushite: A Novel Biomaterial for Potential Use in Bone Tissue Engineering

2018 ◽  
Vol 19 (12) ◽  
pp. 4042 ◽  
Author(s):  
Aleksandra Laskus ◽  
Anna Zgadzaj ◽  
Joanna Kolmas
Keyword(s):  
Bone Tissue ◽  
Calcium Phosphates ◽  
Release Kinetics ◽  
Precipitation Method ◽  
X Ray Diffraction ◽  
X Ray ◽  
Ionic Substitution ◽  
Starting Point ◽  
Kinetics Of ◽  
Potential Use

In this study, a novel biomaterial, i.e., brushite containing 0.67 wt% of selenium (Se-Bru) was synthesized via a wet precipitation method. Pure, unsubstituted brushite (Bru) was synthesized via the same method and used as a reference material. Different techniques of instrumental analysis were applied to investigate and compare physicochemical properties of both materials. Fourier-Transform Infrared Spectroscopy confirmed the chemical identity of both materials. Scanning Electron Microscopy (SEM) was used to study the morphology and indicated that both samples (Bru and Se-Bru) consisted of plate-like microcrystals. Powder X-ray Diffraction (PXRD) showed that Bru, as well as Se-Bru were crystallographically homogenous. What is more, the data obtained from PXRD studies revealed that the substitution of selenite ions into the crystal structure of the material had clearly affected its lattice parameters. The incorporation of selenium was also confirmed by solid-state 1H→31P CP MAS kinetics experiments. Additionally, studies on the release kinetics of the elements forming Se-Bru and preliminary cytotoxicity tests were conducted. This preliminary research will favor a better understanding of ionic substitution in calcium phosphates and may be a starting point for the development of selenium-doped brushite cements for potential use in bone tissue impairments treatment.

scholarly journals Title Changes in the Mineral Composition of Rat Femoral Bones Induced by Implantation of LNCaP Prostate Cancer Cells and Dietary Supplementation

Nutrients ◽  
2020 ◽  
Vol 13 (1) ◽  
pp. 100
Author(s):  
Dorota Skrajnowska ◽  
Agata Jagielska ◽  
Anna Ruszczyńska ◽  
Barbara Wagner ◽  
Wojciech Bielecki ◽  
...  
Keyword(s):  
Prostate Cancer ◽  
Cancer Cells ◽  
Bone Tissue ◽  
Bone Structure ◽  
Elemental Content ◽  
Control Group ◽  
Standard Diet ◽  
Adaptation Period ◽  
Lncap Cells ◽  
Bone Composition

Prostate cancer (PCa) is the second most frequent cancer in men and the fifth most common cause of death worldwide, with an estimated 378,553 deaths in 2020. Prostate cancer shows a strong tendency to form metastatic foci in the bones. A number of interactions between cancer cells attacking bones and cells of the bone matrix lead to destruction of the bone and growth of the tumour. The last few decades have seen increased interest in the precise role of minerals in human health and disease. Tumour cells accumulate various minerals that promote their intensive growth. Bone, as a storehouse of elements, can be a valuable source of them for the growing tumour. There are also reports suggesting that the presence of some tumours, e.g., of the breast, can adversely affect bone structure even in the absence of metastasis to this organ. This paper presents the effect of chronic dietary intake of calcium, iron and zinc, administered in doses corresponding maximally to twice their level in a standard diet, on homeostasis of selected elements (Ca, K, Zn, Fe, Cu, Sr, Ni, Co, Mn and Mo) in the femoral bones of healthy rats and rats with implanted cancer cells of the LNCaP line. The experiment was conducted over 90 days. After the adaptation period, the animals were randomly divided into four dietary groups: standard diet and supplementation with Zn, Fe and Ca. Every dietary group was divided into experimental group (with implanted cancer cells) and control group (without implanted cancer cells). The cancer cells (LnCaP) were implanted intraperitoneally in the amount 1 × 106 to the rats at day 90 of their lifetime. Bone tissue was dried and treated with microwave-assisted mineral digestation. Total elemental content was quantified by ICP-MS. Student’s t-test and Anova or Kruskal–Wallis tests were applied in order to compare treatment and dietary groups. In the case of most of the diets, especially the standard diet, the femoral bones of rats with implanted LNCaP cells showed a clear downward trend in the content of the elements tested, which may be indicative of slow osteolysis taking place in the bone tissue. In the group of rats receiving the standard diet, there were significant reductions in the content of Mo (by 83%), Ca (25%), Co (22%), Mn (13%), K (13%) and Sr (9%) in the bone tissue of rats with implanted LNCaP cells in comparison with the control group receiving the same diet but without LNCaP implantation. Supplementation of the rat diet with calcium, zinc and iron decreased the frequency of these changes relative to the standard diet, which may indicate that the diet had an inhibitory effect on bone resorption in conditions of LNCaP implantation. The principal component analysis (PCA) score plot confirms the pronounced effect of implanted LNCaP cells and the standard diet on bone composition. At the same time, supplementation with calcium, zinc and iron seems to improve bone composition. The microelements that most often underwent quantitative changes in the experimental conditions were cobalt, manganese and molybdenum.

Direct observations of radiation-enhanced transformations in glass

1983 ◽  
Vol 41 ◽  
pp. 354-355
Author(s):  
J. F. DeNatale ◽  
D. G. Howitt
Keyword(s):  
Glass Matrix ◽  
Diffusion Mechanism ◽  
Bubble Formation ◽  
Silicate Glasses ◽  
Phase Decomposition ◽  
Direct Observations ◽  
Thin Foils ◽  
Oxygen Bubble ◽  
Electron Energy Loss ◽  
Kinetics Of

The electron irradiation of silicate glasses containing metal cations produces various types of phase separation and decomposition which includes oxygen bubble formation at intermediate temperatures figure I. The kinetics of bubble formation are too rapid to be accounted for by oxygen diffusion but the behavior is consistent with a cation diffusion mechanism if the amount of oxygen in the bubble is not significantly different from that in the same volume of silicate glass. The formation of oxygen bubbles is often accompanied by precipitation of crystalline phases and/or amorphous phase decomposition in the regions between the bubbles and the detection of differences in oxygen concentration between the bubble and matrix by electron energy loss spectroscopy cannot be discerned (figure 2) even when the bubble occupies the majority of the foil depth.The oxygen bubbles are stable, even in the thin foils, months after irradiation and if van der Waals behavior of the interior gas is assumed an oxygen pressure of about 4000 atmospheres must be sustained for a 100 bubble if the surface tension with the glass matrix is to balance against it at intermediate temperatures.

Irradiation behavior of pyrolytic silicon carbide

1983 ◽  
Vol 41 ◽  
pp. 72-73
Author(s):  
R. J. Lauf
Keyword(s):  
Silicon Carbide ◽  
Fission Products ◽  
Thermodynamics And Kinetics ◽  
Neutron Fluences ◽  
Fuel Particles ◽  
Sic Coatings ◽  
Irradiation Behavior ◽  
Kinetics Of ◽  
Htgr Fuel

Fuel particles for the High-Temperature Gas-Cooled Reactor (HTGR) contain a layer of pyrolytic silicon carbide to act as a miniature pressure vessel and primary fission product barrier. Optimization of the SiC with respect to fuel performance involves four areas of study: (a) characterization of as-deposited SiC coatings; (b) thermodynamics and kinetics of chemical reactions between SiC and fission products; (c) irradiation behavior of SiC in the absence of fission products; and (d) combined effects of irradiation and fission products. This paper reports the behavior of SiC deposited on inert microspheres and irradiated to fast neutron fluences typical of HTGR fuel at end-of-life.

Electron Probe Microanalysis of Frozen Hydrated Kidneys, Isolated Cells, and Cultured Cells

1982 ◽  
Vol 40 ◽  
pp. 402-403 ◽  
Author(s):  
Claude Lechene
Keyword(s):  
Liquid Nitrogen ◽  
Electron Probe Microanalysis ◽  
Electron Probe ◽  
Cultured Cells ◽  
Liquid Nitrogen Temperature ◽  
Elemental Content ◽  
Isolated Cells ◽  
Renal Tubular Cells ◽  
Diamond Saw ◽  
Saw Blade

Electron probe microanalysis of frozen hydrated kidneysThe goal of the method is to measure on the same preparation the chemical elemental content of the renal luminal tubular fluid and of the surrounding renal tubular cells. The following method has been developed. Rat kidneys are quenched in solid nitrogen. They are trimmed under liquid nitrogen and mounted in a copper holder using a conductive medium. Under liquid nitrogen, a flat surface is exposed by sawing with a diamond saw blade at constant speed and constant pressure using a custom-built cryosaw. Transfer into the electron probe column (Cameca, MBX) is made using a simple transfer device maintaining the sample under liquid nitrogen in an interlock chamber mounted on the electron probe column. After the liquid nitrogen is evaporated by creating a vacuum, the sample is pushed into the special stage of the instrument. The sample is maintained at close to liquid nitrogen temperature by circulation of liquid nitrogen in the special stage.

The Ordered Phase Formation in Ti-Al-Ga Alloys

1970 ◽  
Vol 28 ◽  
pp. 440-441
Author(s):  
Shiro Fujishiro ◽  
Harold L. Gegel
Keyword(s):  
Thermal Stability ◽  
High Temperature ◽  
Titanium Alloys ◽  
Growth Kinetics ◽  
Stoichiometric Composition ◽  
Good Potential ◽  
Alpha Titanium ◽  
Cold Rolled ◽  
Kinetics Of ◽  
Thermal Stability Of

Ordered-alpha titanium alloys having a DO19 type structure have good potential for high temperature (600°C) applications, due to the thermal stability of the ordered phase and the inherent resistance to recrystallization of these alloys. Five different Ti-Al-Ga alloys consisting of equal atomic percents of aluminum and gallium solute additions up to the stoichiometric composition, Ti3(Al, Ga), were used to study the growth kinetics of the ordered phase and the nature of its interface.The alloys were homogenized in the beta region in a vacuum of about 5×10-7 torr, furnace cooled; reheated in air to 50°C below the alpha transus for hot working. The alloys were subsequently acid cleaned, annealed in vacuo, and cold rolled to about. 050 inch prior to additional homogenization

Ion Beam Induced Interfacial Reactions in Molybdenum Thin Films on Silicon

1981 ◽  
Vol 39 ◽  
pp. 162-163
Author(s):  
L. J. Chen ◽  
L. S. Hung ◽  
J. W. Mayer
Keyword(s):  
Ion Beam ◽  
Chemical Vapor ◽  
Interfacial Reactions ◽  
Practical Applications ◽  
Microelectronic Devices ◽  
Recent Emergence ◽  
Chemical Vapor Deposited ◽  
Atomic Mixing ◽  
Silicon Interface ◽  
Kinetics Of

When an energetic ion penetrates through an interface between a thin film (of species A) and a substrate (of species B), ion induced atomic mixing may result in an intermixed region (which contains A and B) near the interface. Most ion beam mixing experiments have been directed toward metal-silicon systems, silicide phases are generally obtained, and they are the same as those formed by thermal treatment.Recent emergence of silicide compound as contact material in silicon microelectronic devices is mainly due to the superiority of the silicide-silicon interface in terms of uniformity and thermal stability. It is of great interest to understand the kinetics of the interfacial reactions to provide insights into the nature of ion beam-solid interactions as well as to explore its practical applications in device technology.About 500 Å thick molybdenum was chemical vapor deposited in hydrogen ambient on (001) n-type silicon wafer with substrate temperature maintained at 650-700°C. Samples were supplied by D. M. Brown of General Electric Research & Development Laboratory, Schenectady, NY.

Sign in / Sign up

Export Citation Format

Share Document