Structural stability of heat-treated Co/C soft X-ray multilayers fabricated by dual-facing-target sputtering

1996 ◽  
Vol 63 (1) ◽  
pp. 57-65 ◽  
Author(s):  
H. L. Bai ◽  
E. Y. Jiang ◽  
C. D. Wang
Keyword(s):  
Structural Stability ◽  
X Ray ◽  
Heat Treated ◽  
Facing Target Sputtering

Structural stability of heat-treated CoN/CN soft X-ray multilayers fabricated by dual-facing-target sputtering

1998 ◽  
Vol 66 (4) ◽  
pp. 423-433 ◽  
Author(s):  
H.L. Bai ◽  
E.Y. Jiang ◽  
C.D. Wang ◽  
R.Y. Tian
Keyword(s):  
Structural Stability ◽  
X Ray ◽  
Heat Treated ◽  
Facing Target Sputtering

Characterization of heat-treated CN films fabricated by dual-facing-target sputtering for soft X-ray multilayer mirrors

1999 ◽  
Vol 69 (6) ◽  
pp. 641-647 ◽  
Author(s):  
H.L. Bai ◽  
E.Y. Jiang ◽  
P. Wu ◽  
Z.D. Lou ◽  
Y. Wang ◽  
...  
Keyword(s):  
Multilayer Mirrors ◽  
X Ray ◽  
Heat Treated ◽  
Facing Target Sputtering

Direct Observation of Crystalline Ordering In Naturally Graphitized Carbon Produced by Low Grade Metamorphism

1977 ◽  
Vol 35 ◽  
pp. 162-163
Author(s):  
Thomas R. McKee ◽  
Peter R. Buseck
Keyword(s):  
Crystallite Size ◽  
Sedimentary Rocks ◽  
Carbonaceous Material ◽  
Low Grade ◽  
X Ray ◽  
Graphitized Carbon ◽  
Transmission Electron ◽  
Heat Treated ◽  
Commercial Carbon ◽  
Metamorphic Zone

Sediments commonly contain organic material which appears as refractory carbonaceous material in metamorphosed sedimentary rocks. Grew and others have shown that relative carbon content, crystallite size, X-ray crystallinity and development of well-ordered graphite crystal structure of the carbonaceous material increases with increasing metamorphic grade. The graphitization process is irreversible and appears to be continous from the amorphous to the completely graphitized stage. The most dramatic chemical and crystallographic changes take place within the chlorite metamorphic zone.The detailed X-ray investigation of crystallite size and crystalline ordering is complex and can best be investigated by other means such as high resolution transmission electron microscopy (HRTEM). The natural graphitization series is similar to that for heat-treated commercial carbon blacks, which have been successfully studied by HRTEM (Ban and others).

The effect of small additions of Cu on precipitation in Al-Mg-Si alloys

1990 ◽  
Vol 48 (2) ◽  
pp. 442-443
Author(s):  
M. Tamizifar ◽  
G. Cliff ◽  
R.W. Devenish ◽  
G.W. Lorimer
Keyword(s):  
Electron Microscopy ◽  
Analytical Electron Microscopy ◽  
Scanning Transmission Electron Microscope ◽  
Argon Atmosphere ◽  
Age Hardening ◽  
X Ray ◽  
Transmission Electron ◽  
Heat Treated ◽  
Analytical Electron ◽  
Scanning Transmission

Small additions of copper, <1 wt%, have a pronounced effect on the ageing response of Al-Mg-Si alloys. The object of the present investigation was to study the effect of additions of copper up to 0.5 wt% on the ageing response of a series of Al-Mg-Si alloys and to use high resolution analytical electron microscopy to determine the composition of the age hardening precipitates.The composition of the alloys investigated is given in Table 1. The alloys were heat treated in an argon atmosphere for 30m, water quenched and immediately aged either at 180°C for 15 h or given a duplex treatment of 180°C for 15 h followed by 350°C for 2 h2. The double-ageing treatment was similar to that carried out by Dumolt et al. Analyses of the precipitation were carried out with a HB 501 Scanning Transmission Electron Microscope. X-ray peak integrals were converted into weight fractions using the ratio technique of Cliff and Lorimer.

Long-period modulated superstructures in Pd-12.5 at.%Ce and Pd-15 at.%Ce alloys

1990 ◽  
Vol 48 (4) ◽  
pp. 164-165
Author(s):  
Noriyuki Kuwano ◽  
Masaru Itakura ◽  
Kensuke Oki
Keyword(s):  
Electron Microscopy ◽  
Mean Value ◽  
Heavy Elements ◽  
Arc Furnace ◽  
X Ray ◽  
Long Period ◽  
Ultra High Purity ◽  
Heat Treated ◽  
Atomic Scattering ◽  
The Mean

Pd-Ce alloys exhibit various anomalies in physical properties due to mixed valences of Ce, and the anomalies are thought to be strongly related with the crystal structures. Since Pd and Ce are both heavy elements, relative magnitudes of (fcc-fpd) are so small compared with <f> that superlattice reflections, even if any, sometimes cannot be detected in conventional x-ray powder patterns, where fee and fpd are atomic scattering factors of Ce and Pd, and <f> the mean value in the crystal. However, superlattices in Pd-Ce alloys can be analyzed by electron microscopy, thanks to the high detectability of electron diffraction. In this work, we investigated modulated superstructures in alloys with 12.5 and 15.0 at.%Ce.Ingots of Pd-Ce alloys were prepared in an arc furnace under atmosphere of ultra high purity argon. The disc specimens cut out from the ingots were heat-treated in vacuum and electrothinned to electron transparency by a jet method.

scholarly journals Stable and Metastable Phase Equilibria Involving the Cu6Sn5 Intermetallic

2021 ◽  
Author(s):  
A. Leineweber ◽  
M. Löffler ◽  
S. Martin
Keyword(s):  
Phase Equilibria ◽  
Electron Backscatter Diffraction ◽  
Metastable Phase ◽  
Stable Phase ◽  
X Ray Diffraction ◽  
X Ray ◽  
Heat Treated ◽  
Ordered Phases ◽  
Backscatter Diffraction ◽  
Kinetics Of

Abstract Cu6Sn5 intermetallic occurs in the form of differently ordered phases η, η′ and η′′. In solder joints, this intermetallic can undergo changes in composition and the state of order without or while interacting with excess Cu and excess Sn in the system, potentially giving rise to detrimental changes in the mechanical properties of the solder. In order to study such processes in fundamental detail and to get more detailed information about the metastable and stable phase equilibria, model alloys consisting of Cu3Sn + Cu6Sn5 as well as Cu6Sn5 + Sn-rich melt were heat treated. Powder x-ray diffraction and scanning electron microscopy supplemented by electron backscatter diffraction were used to investigate the structural and microstructural changes. It was shown that Sn-poor η can increase its Sn content by Cu3Sn precipitation at grain boundaries or by uptake of Sn from the Sn-rich melt. From the kinetics of the former process at 513 K and the grain size of the η phase, we obtained an interdiffusion coefficient in η of (3 ± 1) × 10−16 m2 s−1. Comparison of this value with literature data implies that this value reflects pure volume (inter)diffusion, while Cu6Sn5 growth at low temperature is typically strongly influenced by grain-boundary diffusion. These investigations also confirm that η′′ forming below a composition-dependent transus temperature gradually enriches in Sn content, confirming that Sn-poor η′′ is metastable against decomposition into Cu3Sn and more Sn-rich η or (at lower temperatures) η′. Graphic Abstract

scholarly journals Phase Relations in the ZrO2-MgO-FeOx System: Experimental Data and Assessment of Thermodynamic Parameters

2021 ◽  
Author(s):  
Ivan Saenko ◽  
O. Fabrichnaya
Keyword(s):  
Electron Microscopy ◽  
Experimental Data ◽  
Solid Solution ◽  
Thermodynamic Parameters ◽  
Spinel Phase ◽  
Experimental Investigations ◽  
X Ray ◽  
Heat Treated ◽  
Preliminary Phase ◽  
Scanning Electron

AbstractThermodynamic parameters were assessed for the MgO–FeOx system and combined with already available descriptions of ZrO2-FeOx and ZrO2-MgO systems to calculate preliminary phase diagrams for planning experimental investigations. Samples of selected compositions were heat treated at 1523, 1673 and 1873 K and characterized using x-ray and scanning electron microscopy combined with energy dispersive x-ray spectroscopy (SEM/EDX). Experiments indicated extension of cubic ZrO2 solid solution into the ternary system at 1873 K (75 mol.% ZrO2, 10 mol.% FeOx and 15 mol.% MgO) and limited solubility of 4 mol.% ZrO2 in spinel phase. Based on the obtained results thermodynamic parameters of C-ZrO2 and spinel phase were optimized.

Structural Stability of CdSe Nanocrystallite Dispersions

1995 ◽  
Vol 400 ◽  
Author(s):  
H. Mattoussi ◽  
C.B. Murray ◽  
M.G. Bawendi ◽  
R. Ober
Keyword(s):  
Thermodynamic Properties ◽  
Structural Stability ◽  
Particle Interactions ◽  
X Ray ◽  
X Ray Scattering ◽  
Crystallite Surface ◽  
Ray Scattering

AbstractX-ray scattering at small angles (SAXS) is used to study the structure and the thermodynamic properties of dispersions of CdSe nanocrystallite particles. In particular, this study allowed us to probe the inter particle interactions, and their dependence on several relevant parameters, such as the nature and size of the capping units attached to the crystallite surface and solvent.

PREPARATION OF ANTIMONY-PLATINUM SURFACE ALLOY ELECTRODE BY ATOM DIFFUSION IN THE SOLID PHASE

2006 ◽  
Vol 20 (25n27) ◽  
pp. 3999-4004
Author(s):  
HIROSHI MATSUI ◽  
KAZUFUMI WATANABE
Keyword(s):  
Diffraction Pattern ◽  
Low Temperatures ◽  
Solid Phase ◽  
Electrochemical Measurement ◽  
X Ray Diffraction ◽  
Platinum Surface ◽  
X Ray ◽  
Atom Diffusion ◽  
Heat Treated ◽  
Titanium Substrates

Antimony-platinum bilayers were prepared on titanium substrates by the two-step electrodeposition in the usual baths, and then surface alloys were formed by the atom diffusion in the solid phase. The simple antimony layer was little influenced by the substrate in both the measurements of X-ray diffraction and the i - E characteristic in a sulfuric acid solution. Regarding the bilayers, the catalytic activity in hydrogen evolution reaction was very sensitive to the presence of platinum, while the hydrogen adsorbability was quite insensitive. An interaction between antimony and platinum was confirmed by the appearance of a new dissolution wave in the electrochemical measurement and the occurrence of a new diffraction in the X-ray diffraction pattern after the heat-treatment of about 400°C. Although the new diffraction disagreed with any of the reported alloys, clear diffraction pattern of PtSb 2 alloy was observed, when the bilayers were heat-treated at about 600°C for one hour. Considering the penetration depth of X-ray, the alloying of antimony and platinum seems to occur also at low temperatures at least at the top surface.

Sign in / Sign up

Export Citation Format

Share Document