Evaluation of the effect of deformation rate on the mechanical properties of steels 40Kh, 40KhN, and 30KhGSA

1988 ◽  
Vol 20 (4) ◽  
pp. 499-503 ◽  
Author(s):  
V. N. Katanchik ◽  
V. I. Lazarenko ◽  
V. V. Malyatin ◽  
A. A. Rakitskii
Keyword(s):  
Mechanical Properties ◽  
Deformation Rate

Effect of deformation rate on the mechanical properties of tantalum alloy TaV10

1984 ◽  
Vol 16 (7) ◽  
pp. 991-993
Author(s):  
N. N. Popov ◽  
A. G. Ivanov ◽  
O. M. Savel'eva
Keyword(s):  
Mechanical Properties ◽  
Deformation Rate ◽  
Tantalum Alloy

Effect of Rolling Process on Microstructure and Texture of Cold Rolled Ti-6Al-4V Seamless Tubes

2012 ◽  
Vol 557-559 ◽  
pp. 191-197 ◽  
Author(s):  
Yun Xue Jin ◽  
Kai Yue Li ◽  
Hong Mei Chen ◽  
Hong Fu Xiang
Keyword(s):  
Mechanical Properties ◽  
Deformation Rate ◽  
Texture Evolution ◽  
Rolling Process ◽  
Air Cooling ◽  
Final Size ◽  
Heat Treatment Parameter ◽  
Stress Relieving ◽  
Treatment Parameter ◽  
Cold Rolled

In this paper, initial Ti-6Al-4V seamless tube was prepared and cold rolled to a final size of 32*2, and the microstructure and mechanical properties development was investigated, and the (0002) and (10 -10) texture was measured on XRD, pole figure calculated by Microsoft of Labotex. Pass between annealing was taken for stress-relieving, heat-treatment parameter was 800°C-1hr, furnace cooling to 500°C and then air cooling to room temperature. The results show that rolling process result in effective grain refinement and mechanical properties improvement after several rolling passes. The increase number of rolling pass improves strength but reduce the elongation, annealing improve elongation, reduce strength. A trend of texture reorientation was found in this paper also, textures of materials rolled by deformation rate were compared, different deformation rate effect texture evolution has been proved.

Influence of deformation rate on microstructure, texture and mechanical properties of indirect-extruded Mg–Zn–Ca alloy

2015 ◽  
Vol 104 ◽  
pp. 66-72 ◽  
Author(s):  
L.B. Tong ◽  
M.Y. Zheng ◽  
L.R. Cheng ◽  
D.P. Zhang ◽  
S. Kamado ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Deformation Rate

scholarly journals Effect of deformation rate on the mechanical properties of arteries

2010 ◽  
Vol 03 (02) ◽  
pp. 124-137 ◽  
Author(s):  
Jorge O. Virues Delgadillo ◽  
Sebastien Delorme ◽  
Vincent Mora ◽  
Robert DiRaddo ◽  
Savvas G. Hatzikiriakos
Keyword(s):  
Mechanical Properties ◽  
Deformation Rate
Sign in / Sign up

Export Citation Format

Share Document