Determination of the magnitude of the separation criterion for a three-dimensional laminar boundary layer

1976 ◽  
Vol 10 (2) ◽  
pp. 237-242 ◽  
Author(s):  
N. M. Belyanin
Keyword(s):  
Boundary Layer ◽  
Laminar Boundary Layer ◽  
Three Dimensional ◽  
Separation Criterion

scholarly journals Receptivity of a laminar boundary layer to the interaction of a three-dimensional roughness element with time-harmonic free-stream disturbances

1992 ◽  
Vol 242 ◽  
pp. 701-720 ◽  
Author(s):  
M. Tadjfar ◽  
R. J. Bodonyi
Keyword(s):  
Boundary Layer ◽  
Laminar Boundary Layer ◽  
Stokes Flow ◽  
Free Stream ◽  
Flow Direction ◽  
Roughness Element ◽  
Three Dimensional ◽  
Unsteady Motion ◽  
Time Harmonic ◽  
Tollmien Schlichting

Receptivity of a laminar boundary layer to the interaction of time-harmonic free-stream disturbances with a three-dimensional roughness element is studied. The three-dimensional nonlinear triple–deck equations are solved numerically to provide the basic steady-state motion. At high Reynolds numbers, the governing equations for the unsteady motion are the unsteady linearized three-dimensional triple-deck equations. These equations can only be solved numerically. In the absence of any roughness element, the free-stream disturbances, to the first order, produce the classical Stokes flow, in the thin Stokes layer near the wall (on the order of our lower deck). However, with the introduction of a small three-dimensional roughness element, the interaction between the hump and the Stokes flow introduces a spectrum of all spatial disturbances inside the boundary layer. For supercritical values of the scaled Strouhal number, S0 > 2, these Tollmien–Schlichting waves are amplified in a wedge-shaped region, 15° to 18° to the basic-flow direction, extending downstream of the hump. The amplification rate approaches a value slightly higher than that of two-dimensional Tollmien–Schlichting waves, as calculated by the linearized analysis, far downstream of the roughness element.

scholarly journals Experimental observation of frequency lock-in of roughness-induced instabilities in a laminar boundary layer

2019 ◽  
Vol 870 ◽  
pp. 680-697
Author(s):  
Dominik K. Puckert ◽  
Ulrich Rist
Keyword(s):  
Boundary Layer ◽  
Aspect Ratio ◽  
Laminar Boundary Layer ◽  
Roughness Element ◽  
Water Channel ◽  
Three Dimensional ◽  
Boundary Layer Theory ◽  
Linear Stability Theory ◽  
Mode Decomposition ◽  
Lock In

The interaction of disturbance modes behind an isolated cylindrical roughness element in a laminar boundary layer is investigated by means of hot-film anemometry and particle image velocimetry in a low-turbulence laminar water channel. Both sinuous and varicose disturbance modes are found in the wake of a roughness with unit aspect ratio (diameter/height $=$ 1). Interestingly, the frequency of the varicose mode synchronizes with the first harmonic of the sinuous mode when the critical Reynolds number from three-dimensional global linear stability theory is exceeded. The coupled motion of sinuous and varicose modes is explained by frequency lock-in. This mechanism is of great importance in many aspects of nature, but has not yet received sufficient attention in the field of boundary-layer theory. A Fourier mode decomposition provides detailed analyses of sinuous and varicose modes. The observation is confirmed by a second experiment with the same aspect ratio at a different position in the laminar boundary layer. When the aspect ratio is increased, the flow is fully governed by the varicose mode. Thus, no frequency lock-in can be observed in this case. The significance of this work is to explain how sinuous and varicose modes can co-exist behind a roughness and to propose a mechanism which is well established in physics but not encountered often in boundary-layer theory.

Decreasing the Side Wall Contamination in Wind Tunnels

1983 ◽  
Vol 105 (4) ◽  
pp. 435-438 ◽  
Author(s):  
T. Motohashi ◽  
R. F. Blackwelder
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Boundary Layers ◽  
Laminar Boundary Layer ◽  
Three Dimensional ◽  
Side Wall ◽  
Wind Tunnels ◽  
Turbulent Fluid ◽  
Side Walls ◽  
Suction Slot

To study boundary layers in the transitional Reynolds number regime, the useful spanwise and streamwise extent of wind tunnels is often limited by turbulent fluid emanating from the side walls. Some or all of the turbulent fluid can be removed by sucking fluid out at the corners, as suggested by Amini [1]. It is shown that by optimizing the suction slot width, the side wall contamination can be dramatically decreased without a concomitant three-dimensional distortion of the laminar boundary layer.

Three-Dimensional Hypersonic Laminar Boundary-Layer Computations for Transition Experiment Design

1997 ◽  
Vol 34 (4) ◽  
pp. 409-415 ◽  
Author(s):  
Roger L. Kimmel ◽  
Mark A. Klein ◽  
Stephen N. Schwoerke
Keyword(s):  
Boundary Layer ◽  
Laminar Boundary Layer ◽  
Three Dimensional ◽  
Experiment Design
Sign in / Sign up

Export Citation Format

Share Document