Transfer chemical potentials for cobalt(III) and chromium(III) complexes from water into aqueous methanol; their relevance to reactivity trends for cobalt(III)-chloride aquation

1984 ◽  
Vol 9 (5) ◽  
pp. 193-197 ◽  
Author(s):  
Michael J. Blandamer ◽  
John Burgess ◽  
Ezz-Eldin A. Abu-Gharib
Keyword(s):  
Aqueous Methanol ◽  
Chemical Potentials

Transfer chemical potentials for iron(II)-diimine complexes from water into aqueous methanol

1984 ◽  
Vol 9 (8) ◽  
pp. 306-308 ◽  
Author(s):  
Ezz -Eldin A. Abu-Gharib ◽  
Michael J. Blandamer ◽  
John Burgess ◽  
Nrinder Gosal ◽  
Pilar Guardado ◽  
...  
Keyword(s):  
Aqueous Methanol ◽  
Chemical Potentials ◽  
Diimine Complexes

An Improved Equation for the Liquid Junction Potential at the Interface of Different Solvents

1992 ◽  
Vol 45 (10) ◽  
pp. 1633 ◽  
Author(s):  
A Berne ◽  
C Kahanda ◽  
O Popovych
Keyword(s):  
Mixed Solvent ◽  
Electrolyte Solutions ◽  
Transport Numbers ◽  
Liquid Junction Potential ◽  
Aqueous Methanol ◽  
Liquid Junction ◽  
Chemical Potentials ◽  
Solvent Dependence ◽  
New Equation ◽  
Junction Potential

The component of the liquid-junction potential due to the diffusion of ions across an interface of electrolyte solutions in different solvents was formulated by taking into account the solvent dependence of the transport numbers, t, and of the chemical potentials of ions in the interphase region as determined from experimental data on their variation in the mixed-solvent compositions. The new equation was applied to NaCl/NaCl and HCl/HCl junctions between water and methanol-water solvents over the entire solvent range. Significant differences between the results obtained with the new equation and the old formulation, which treated the transport numbers as solvent-independent, were observed only for the HCl junctions involving 90-100 wt % aqueous methanol, where tH exhibits a sharp minimum as a function of the solvent composition.

Excess partial molar entropy of alkane-mono-ols in aqueous solutions at 25°C

2003 ◽  
Vol 81 (2) ◽  
pp. 150-155 ◽  
Author(s):  
Yoshikata Koga ◽  
Peter Westh ◽  
Keiko Nishikawa
Keyword(s):  
Aqueous Solutions ◽  
Key Words ◽  
Preceding Paper ◽  
Aqueous Methanol ◽  
Model Free ◽  
Chemical Potentials ◽  
Hydrophobic Nature ◽  
Mixing Schemes ◽  
Partial Molar Entropy ◽  
Partial Molar Enthalpies

In the preceding paper, we reported the values of model-free chemical potentials for aqueous methanol, ethanol, 1-propanol, 2-propanol, 1-butanol, and 1-hexanol at 25°C over the entire compositional region. Using alcohol excess partial molar enthalpies, HEAL, determined earlier in this laboratory (Can. J. Chem. 74, 713 (1996)), we have calculated excess partial molar entropies for the alcohols, SEAL, where AL stands for an alcohol. We then calculated, numerically, the entropic interaction, SEAL–AL = N([Formula: see text]SEAL/[Formula: see text]nAL)p,T,nW, where nAL is the amount of AL, nW is the amount of H2O, and N is the total amount of solution. SEAL–AL signifies the effect of addition of AL upon the entropic situation of existing AL in solution. Using these quantities, the mixing schemes in aqueous alcohols have been studied. The earlier conclusions, which used HEAL and HEAL–AL alone, are confirmed. Furthermore, the order of the relative hydrophobic nature of alcohols is established from the behaviour of SEAL–AL and of HEAL–AL as methanol < ethanol < 2-propanol < 1-propanol. Key Words: aqueous alcohols, excess partial molar entropies, entropic interaction mixing schemes, hydrophobicity ranking.

Conversion of fructose into methyl lactate over SnO2/Al2O3 catalystin flow regime

2020 ◽  
pp. 43-47
Author(s):  
S.V. Prudius ◽  
◽  
N.L. Hes ◽  
A.M. Mylin ◽  
V.V. Brei ◽  
...  
Keyword(s):  
Flow Reactor ◽  
Practical Interest ◽  
Dimethyl Acetal ◽  
Racemic Mixture ◽  
Process Conditions ◽  
Impregnation Method ◽  
Aqueous Methanol ◽  
Methyl Lactate ◽  
Al2o3 Catalyst ◽  
Target Reaction

In recent years, numerous researchers have focused on the development of catalytic methods for processing of biomass-derived sugars into alkyl lactates, which are widely used as non-toxic solvents and are the starting material for obtaining monomeric lactide. In this work, the transformation of fructose into methyl lactate on Sn-containing catalyst in the flow reactor that may be of practical interest was studied. The supported Sn-containing catalyst was ob-tained by a simple impregnation method of granular γ-Al2O3. The catalytic ex-periments were performed in a flow reactor at temperatures of 160-190 °C and pressure of 3.0 MPa. The 1.6-9.5 wt.% fructose solutions in 80% aqueous methanol were used as a reaction mixture. It was found that addition to a reac-tion mixture of 0.03 wt.% potassium carbonate leads to the increase in selec-tivity towards methyl lactate on 15% at 100% conversion of fructose. Prod-ucts of the target reaction С6Н12О6 + 2СН3ОН = 2С4Н8О3 + 2Н2О were ana-lyzed using 13C NMR method. The following process conditions for obtaining of 65 mol% methyl lactate yield at 100% fructose conversion were found: use of 4.8 wt.% fructose solution in 80% methanol, 180 °С, 3.0 МПа and a load on catalyst 1.5 mmol C6H12O6/mlcat/h at contact time of 11 minutes. The cata-lyst productivity is 2.0 mmol C4H8O3/mlcat/h and the by-productі are 1,3-dihydroxyacetone dimethyl acetal (20%) and 5-hydroxymethylfurfural (10%). It should be noted that a racemic mixture of L- and D-methyl lactates has been obtained by conversion of D-fructose on the SnO2/Al2O3 catalyst. The SnO2/Al2O3 catalyst was found to be stable for 6 h while maintaining full fruc-tose conversion at 55–70% methyl lactate selectivity. After regeneration the catalyst completely restores the initial activity.

Analysis of Brassinosteroids in Soybean Seeds and Leaves by Liquid Chromatography-Tandem Mass Spectrometry

2017 ◽  
Vol 10 (1) ◽  
pp. 100-109
Author(s):  
Hongxia Li ◽  
Natasha Trzaskalski ◽  
R.J. Neil Emery
Keyword(s):  
Mass Spectrometry ◽  
Liquid Chromatography ◽  
Tandem Mass Spectrometry ◽  
High Performance ◽  
Soybean Seeds ◽  
Tandem Mass ◽  
Electrospray Tandem Mass Spectrometry ◽  
Aqueous Methanol ◽  
Chromatography Tandem Mass Spectrometry ◽  
Liquid Chromatography Tandem Mass

Objective:A simple and fast high performance liquid chromatography-electrospray tandem mass spectrometry (LC-ESI-MS/MS) method has been developed for the analysis of brassinosteroids (BRs) in plants without derivatization.Materials:The BRs (including castasterone, 24-epicastasterone, brassinolide and 24-epibrassinolide) have been extracted with ice cold 80% aqueous methanol solution.Method:Five different purification strategies have been tested for the purification and enrichment of BRs.Conclusion:This analytical method was sensitive, reliable, rapid and applicable to trace analysis in complex plant samples.

Solubility and Thermodynamic Transfer Functions of Cesium Dianilinetetraisothiocyanatochromate(III)

1998 ◽  
Vol 63 (3) ◽  
pp. 293-298
Author(s):  
Vladislav Holba
Keyword(s):  
Experimental Data ◽  
Isopropyl Alcohol ◽  
Transfer Functions ◽  
Butyl Alcohol ◽  
Aqueous Methanol ◽  
Gibbs Energies ◽  
Gibbs Energy Of Transfer ◽  
Energy Of Transfer ◽  
The Given ◽  
Reference Electrolyte

The solubilities of cesium dianilinetetraisothiocyanatochromate(III) in water as well as in aqueous methanol, isopropyl alcohol, tert-butyl alcohol and acetonitrile were measured as a function of temperature and solvent composition. The Gibbs energies, enthalpies and entropies of transfer of the salt from water to the given solvents have been evaluated from experimental data. The contribution of [Cr(C6H5NH2)2(NCS)4]- ion to the Gibbs energy of transfer of the investigated salt has been calculated using the tetraphenylarsonium tetraphenylborate (TATB) reference electrolyte assumption.

Kinetics and Mechanism of Decomposition of 1,3-Bis(4-methylphenyl)triazene Catalyzed with Substituted Benzoic Acids in 25% Aqueous Methanol-General or Specific Catalysis?

1994 ◽  
Vol 59 (9) ◽  
pp. 2029-2041
Author(s):  
Oldřich Pytela ◽  
Taťjana Nevěčná
Keyword(s):  
Benzoic Acids ◽  
Hammett Equation ◽  
Aqueous Methanol ◽  
Mechanism Of Decomposition ◽  
Kinetics Of Decomposition ◽  
Independent Variable ◽  
Amino Derivatives ◽  
Substituted Benzoic Acids ◽  
The Individual ◽  
Kinetics Of

The kinetics of decomposition of 1,3-bis(4-methylphenyl)triazene catalyzed with 13 substituted benzoic acids of various concentrations have been measured in 25 vol.% aqueous methanol at 25.0 °C. The rate constants observed (297 data) have be used as values of independent variable in a series of models of the catalyzed decomposition. For the catalytic particles were considered the undissociated acid, its conjugated base, and the proton in both the specific and general catalyses. Some models presumed formation of reactive or nonreactive complexes of the individual reactants. The substituent effect is described by the Hammett equation. The statistically best model in which the observed rate constant is a superposition of a term describing the dependence on proton concentration and a term describing the dependence on the product of concentrations of proton and conjugated base is valid with the presumption of complete proton transfer from the catalyst acid to substrate, which has been proved. The behaviour of 4-dimethylamino, 4-amino, and 3-amino derivatives is anomalous (lower catalytic activity as compared with benzoic acid). This supports the presumed participation of conjugated base in the title process.

Sign in / Sign up

Export Citation Format

Share Document