High electric-field hall effect measurements onn-type InSb at 77 K

1982 ◽  
Vol 27 (2) ◽  
pp. 107-120 ◽  
Author(s):  
G. E. Alberga ◽  
R. G. Welzenis ◽  
W. C. Zeeuw
1965 ◽  
Vol 20 (2) ◽  
pp. 229-236 ◽  
Author(s):  
Ryōichi Yamamoto ◽  
Mitsusuke Ikeda ◽  
Hisanao Sato

The electrical conductivity produced by β -ray bombardment and by light irradiation in several diamonds was investigated in the temperature range 150 to 500° K. Considerable uniformity was observed in the behaviour of the specimens; all of them polarized strongly in the dark at room temperature, and polarization could be effectively eliminated by pulsing the electric field while maintaining the β -flux. Both the counting response and the photoconductivity increased as the temperature was lowered. This was interpreted as being largely due to an increase in the mobility of the charge carriers at lower temperatures, the quantitative relationship being consistent with Hall effect measurements. Accumulation of polarization was reduced by irradiation with red light or by elevation of temperature; at 420° K little sign of polarization remained. From various temperature effects, the thermal depths of the trapping levels in these diamonds were estimated at 0⋅6, 0⋅8 and 1 eV.


2020 ◽  
Vol 140 (8) ◽  
pp. 650-655
Author(s):  
Shoki Tsuji ◽  
Yoji Fujita ◽  
Hiroaki Urushibata ◽  
Akihiko Kono ◽  
Ryoichi Hanaoka ◽  
...  

2018 ◽  
Vol 31 (3) ◽  
pp. 20
Author(s):  
Sarmad M. M. Ali ◽  
Alia A.A. Shehab ◽  
Samir A. Maki

In this study, the ZnTe thin films were deposited on a glass substrate at a thickness of 400nm using vacuum evaporation technique (2×10-5mbar) at RT. Electrical conductivity and Hall effect measurements have been investigated as a function of variation of the doping ratios (3,5,7%) of the Cu element on the thin ZnTe films. The temperature range of (25-200°C) is to record the electrical conductivity values. The results of the films have two types of transport mechanisms of free carriers with two values of activation energy (Ea1, Ea2), expect 3% Cu. The activation energy (Ea1) increased from 29meV to 157meV before and after doping (Cu at 5%) respectively. The results of Hall effect measurements of ZnTe , ZnTe:Cu films show that all films were (p-type), the carrier concentration (1.1×1020 m-3) , Hall mobility (0.464m2/V.s) for pure ZnTe film, increases the carrier concentration (6.3×1021m-3) Hall mobility (2m2/V.s) for doping (Cu at 3%) film, but  decreases by increasing Cu concentration.


2018 ◽  
Vol 7 (3.36) ◽  
pp. 127 ◽  
Author(s):  
Nishanthi Sunthrasakaran ◽  
Nor Akmal Mohd Jamail ◽  
Qamarul Ezani Kamarudin ◽  
Sujeetha Gunabalan

The most important aspect influencing the circumstance and characteristics of electrical discharges is the distribution of electric field in the gap of electrodes. The study of discharge performance requires details on the variation of maximum electric field around the electrode. In electrical power system, the insulation of high voltage power system usually subjected with high electric field. The high electric field causes the degradation performance of insulation and electrical breakdown start to occur. Generally, the standard sphere gaps widely used for protective device in electrical power equipment. This project is study about the electric field distribution and current density for different electrode configuration with XLPE barrier. Hence, the different electrode configuration influences the electric field distribution. This project mainly involves the simulation in order to evaluate the maximum electric field for different electrode configuration. Finite Element Method (FEM) software has been used in this project to perform the simulation. This project also discusses the breakdown characteristics of the XLPE. The accurate evaluation of electric field distribution and maximum electric field is an essential for the determination of discharge behavior of high voltage apparatus and components. The degree of uniformity is very low for pointed rod-plane when compared to other two electrode configurations. The non- uniform electric distribution creates electrical stress within the surface of dielectric barrier. As a conclusion, when the gap distance between the electrodes increase the electric field decrease.  


1979 ◽  
Vol 30 (2) ◽  
pp. 219-223 ◽  
Author(s):  
S.G. Dinev ◽  
Ch.I. Radev ◽  
K.V. Stamenov ◽  
K.A. Stankov

Author(s):  
Yingxia Wei ◽  
Yaoxiang Liu ◽  
Tie-Jun Wang ◽  
Na Chen ◽  
Jingjing Ju ◽  
...  

We report on a systematic experimental study on the fluorescence spectra produced from a femtosecond laser filament in air under a high electric field. The electric field alone was strong enough to create corona discharge (CD). Fluorescence spectra from neutral and ionic air molecules were measured and compared with pure high-voltage CD and pure laser filamentation (FIL). Among them, high electric field assisted laser FIL produced nitrogen fluorescence more efficiently than either pure CD or pure FIL processes. The nonlinear enhancement of fluorescence from the interaction of the laser filament and corona discharging electric field resulted in a more efficient ionization along the laser filament zone, which was confirmed by the spectroscopic measurement of both ionization-induced fluorescence and plasma-scattered 800 nm laser pulses. This is believed to be the key precursor process for filament-guided discharge.


Sign in / Sign up

Export Citation Format

Share Document