Heat transfer in an iron bath of a two-stage smelting reduction process

1993 ◽  
Vol 64 (8-9) ◽  
pp. 372-376 ◽  
Author(s):  
Heinrich Wilhelm Gudenau ◽  
Tianjun Yang ◽  
Thomas Germershausen ◽  
Heinz Rosenbaum ◽  
Keng Wu
2010 ◽  
Vol 46 (2) ◽  
pp. 131-140
Author(s):  
G.B. Qiu ◽  
Y. Xu

The corrosion behavior of three sorts of refractories based on alumina-graphite were studied by immersion tests. The melts included smelting reduction molten slag and corresponding carbon saturated molten iron. The influence of test temperature, FeO content in slag and specimen rotative velocity on the corrosion rate of refractories was examined. By means of SEM and EDS, the microstructure change of the refractories after immersion test in kinds of melts was studied. The morphology of the deteriorated layer showed the corrosion extent of refractories. With the addition of zirconia and titania into the refractories, the corrosion rate changed to some extent. The corrosion rate of three sorts of refractories increased dramatically with the increasing FeO content in smelting reduction slag. Compared with alumina-graphite refractory and alumina-graphite-zirconia refractory, alumina-graphite-titania refractory had stronger corrosion resistance in the smelting reduction conditions. By the results of SEM and EDS, the corrosion mechanism of refractories was developed.


1992 ◽  
Vol 32 (1) ◽  
pp. 95-101 ◽  
Author(s):  
Hiroyuki Katayama ◽  
Takamasa Ohno ◽  
Masao Yamauchi ◽  
Michitaka Matsuo ◽  
Takafumi Kawamura ◽  
...  

2014 ◽  
Vol 933 ◽  
pp. 32-37
Author(s):  
Shuai Niu ◽  
Yong Ren ◽  
Hua Zhang ◽  
Hui Long Fu ◽  
Xin Hong

According to the comprehensive utilization of 300 series and 400 series stainless steel dust (SSD), and the dephosphorization of the reclaimed Cr-Ni contained hot metal, an experimental method of smelting reduction in iron-bath and oxidational dephosphorization was studied. The result shows: The yield rate of Cr in 300SSDand 400SSDis 98.13% and 98.39% respectively, the yield rate of Ni is almost 100%; During the dephosphorization, through the BaO and CaO-BaO based dephosphorizer has a higher Dephosphorization rate, it can bring pollution problems and the cost is too high, however, under some circumstance when the requirement of phosphorus content is not critical, the CaO based dephosphorizer can also achieved the dephosphorization goal.


2017 ◽  
Vol 88 (12) ◽  
pp. 1700212 ◽  
Author(s):  
Heng Zhou ◽  
Shengli Wu ◽  
Mingyin Kou ◽  
Biao Tang ◽  
Hanchi Cheng ◽  
...  

2017 ◽  
Vol 42 (38) ◽  
pp. 24487-24494 ◽  
Author(s):  
Yiqin Liu ◽  
Hao Zhang ◽  
Zengen Li ◽  
Aimin Zhang ◽  
Xiaohui Zhang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document