Processing of polyurethane/polyester interpenetrating polymer networks by reaction injection molding. Part II: Mixing at high reynolds numbers and impingement pressures

1986 ◽  
Vol 26 (12) ◽  
pp. 799-842 ◽  
Author(s):  
Luu T. Nguyen ◽  
Nam P. Suh
Keyword(s):  
Injection Molding ◽  
Polymer Networks ◽  
Reynolds Numbers ◽  
Interpenetrating Polymer Networks ◽  
Reaction Injection Molding ◽  
High Reynolds Numbers ◽  
High Reynolds

TRANSONIC CROSS FLOW (M∞ = 0.8) OVER A CIRCULAR CYLINDER AT HIGH REYNOLDS NUMBERS

2012 ◽  
Vol 43 (5) ◽  
pp. 589-613
Author(s):  
Vyacheslav Antonovich Bashkin ◽  
Ivan Vladimirovich Egorov ◽  
Ivan Valeryevich Ezhov ◽  
Sergey Vladimirovich Utyuzhnikov
Keyword(s):  
Circular Cylinder ◽  
Cross Flow ◽  
Reynolds Numbers ◽  
High Reynolds Numbers ◽  
High Reynolds

Oscillatory control of separation at high Reynolds numbers

AIAA Journal ◽  
1999 ◽  
Vol 37 ◽  
pp. 1062-1071 ◽  
Author(s):  
A. Seifert ◽  
L. G. Pack
Keyword(s):  
Reynolds Numbers ◽  
High Reynolds Numbers ◽  
High Reynolds

Turbulent vortex breakdown at high Reynolds numbers

AIAA Journal ◽  
2000 ◽  
Vol 38 ◽  
pp. 825-834
Author(s):  
F. Novak ◽  
T. Sarpkaya
Keyword(s):  
Vortex Breakdown ◽  
Reynolds Numbers ◽  
Turbulent Vortex ◽  
High Reynolds Numbers ◽  
High Reynolds

Drag Measurements on Long Thin Cylinders at Small Angles and High Reynolds Numbers

2004 ◽  
Author(s):  
William L. Keith ◽  
Kimberly M. Cipolla ◽  
David R. Hart ◽  
Deborah A. Furey
Keyword(s):  
Reynolds Numbers ◽  
High Reynolds Numbers ◽  
High Reynolds

An Experimental and Numerical Study of Heat Transfer and Pressure Loss in a Rectangular Channel With V-Shaped Ribs

2006 ◽  
Author(s):  
Michael Maurer ◽  
Jens von Wolfersdorf ◽  
Michael Gritsch
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Enhancement ◽  
Thermal Performance ◽  
Pressure Loss ◽  
Numerical Study ◽  
Rectangular Channel ◽  
Reynolds Numbers ◽  
Transfer Enhancement ◽  
High Reynolds Numbers ◽  
High Reynolds

An experimental and numerical study was conducted to determine the thermal performance of V-shaped ribs in a rectangular channel with an aspect ratio of 2:1. Local heat transfer coefficients were measured using the steady state thermochromic liquid crystal technique. Periodic pressure losses were obtained with pressure taps along the smooth channel sidewall. Reynolds numbers from 95,000 to 500,000 were investigated with V-shaped ribs located on one side or on both sides of the test channel. The rib height-to-hydraulic diameter ratios (e/Dh) were 0.0625 and 0.02, and the rib pitch-to-height ratio (P/e) was 10. In addition, all test cases were investigated numerically. The commercial software FLUENT™ was used with a two-layer k-ε turbulence model. Numerically and experimentally obtained data were compared. It was determined that the heat transfer enhancement based on the heat transfer of a smooth wall levels off for Reynolds numbers over 200,000. The introduction of a second ribbed sidewall slightly increased the heat transfer enhancement whereas the pressure penalty was approximately doubled. Diminishing the rib height at high Reynolds numbers had the disadvantage of a slightly decreased heat transfer enhancement, but benefits in a significantly reduced pressure loss. At high Reynolds numbers small-scale ribs in a one-sided ribbed channel were shown to have the best thermal performance.

Sign in / Sign up

Export Citation Format

Share Document