Pulmonary hyperpolarized129Xe morphometry for mapping xenon gas concentrations and alveolar oxygen partial pressure: Proof-of-concept demonstration in healthy and COPD subjects

2014 ◽  
Vol 74 (6) ◽  
pp. 1726-1732 ◽  
Author(s):  
A. Ouriadov ◽  
A. Farag ◽  
M. Kirby ◽  
D.G. McCormack ◽  
G. Parraga ◽  
...  
2007 ◽  
Vol 57 (2) ◽  
pp. 423-430 ◽  
Author(s):  
Katarzyna Cieślar ◽  
Vasile Stupar ◽  
Emmanuelle Canet-Soulas ◽  
Sophie Gaillard ◽  
Yannick Crémillieux

1991 ◽  
Vol 81 (6) ◽  
pp. 759-765 ◽  
Author(s):  
C. D. R. Borland ◽  
Y. Cox

1. To examine the effect of varying oxygen partial pressure (Pao2) on nitric oxide (DLNO) and carbon monoxide (DLCO) diffusing capacity (transfer factor), 10 subjects performed combined DLCO/DLNO measurements with the inspired mixture made up with three different oxygen concentrations (25%, 18% and 15%) to give Pao2 values of 12–20 kPa. 2. A novel method is described for calculating membrane diffusing capacity (DM) and pulmonary capillary volume (Qc) from DLNO and DLCO. 3. The mean DMCO was 52.89 mmol min−1 kPa−1 and Qc was 0.056 litre. Reducing Pao2 from 20 to 12 kPa resulted in an increase in DLCO = −0.124 (O2%) + 11.67 (P < 0.001) and a fall in DLNO = 0.538 (O2%) + 32.01 (P < 0.001) and a fall in DLNO/DLCO = 0.107 (O2%) + 2.52 (P < 0.001). DM (P = 0.59) and Qc (P = 0.64) also tended to fall with falling Pao2. 4. It appears more likely that the minor reduction in DLNO that we have observed with falling Pao2 is due to diffusion rather than reaction limitation.


1986 ◽  
Vol 14 (2) ◽  
pp. 153-154 ◽  
Author(s):  
JEAN-PAUL VIALE ◽  
CARLISLE J. PERCIVAL ◽  
GUY ANNAT ◽  
BERNARD ROUSSELET ◽  
JEAN MOTIN

1979 ◽  
Vol 7 (6) ◽  
pp. 267-272 ◽  
Author(s):  
ROBERT GILBERT ◽  
J. H. AUCHINCLOSS ◽  
MITCHELL KUPPINGER ◽  
M. VARKEY THOMAS

2010 ◽  
Vol 64 (5) ◽  
pp. 1484-1490 ◽  
Author(s):  
Ryan J. Kraayvanger ◽  
Christopher P. Bidinosti ◽  
William Dominguez-Viqueira ◽  
Juan Parra-Robles ◽  
Matthew Fox ◽  
...  

2019 ◽  
Vol 13 (6) ◽  
pp. 1105-1111
Author(s):  
Annette Baumstark ◽  
Stefan Pleus ◽  
Nina Jendrike ◽  
Christina Liebing ◽  
Rolf Hinzmann ◽  
...  

Background: Measurement results provided by blood glucose monitoring systems (BGMS) can be affected by various influencing factors. For some BGMS using glucose oxidase (GOx)-based test strips, one of these factors is the oxygen partial pressure (pO2) of the applied blood sample. Because assessing the potential influence of pO2 when measuring capillary blood samples is not straight-forward, we performed a proof of concept study. Method: Influence of pO2 was investigated for two GOx-based BGMS (BGMS A and B). Measurement results of the GOx-based BGMS were compared with measurement results from a pO2-independent BGMS (BGMS C). A total of 119 samples from 60 subjects were measured, twice with BGMS C, then 6 times each with BGMS A and BGMS B or vice versa, and again twice with BGMS C. Immediately afterward, pO2 was determined. Linear regression analysis based on relative differences between results from BGMS A or BGMS B and results from BGMS C was performed to estimate the degree of pO2 influence. Results: The relative bias between the lowest and highest pO2 values differed by 14.3% for BGMS A, indicating a pO2 influence that might be clinically relevant, and by 9.7% for BGMS B, indicating that pO2 influence may be too small to be reliably detected because of the BGMS’ imprecision. Conclusions: This proof of concept study showed that with the procedures used, a potentially clinically relevant influence of pO2 in capillary blood samples on GOx-based BGMS could be detected. Further larger-scale studies are needed to verify this influence.


Sign in / Sign up

Export Citation Format

Share Document